traction control AUDI A4 1999 B5 / 1.G Brakes ABS EDL Bosch 5.0 Workshop Manual

01-45


ABS/EDL Bosch 5.0

Warning lights, functional overview


If On Board Diagnostic (OBD) has detected a
malfunction in the system, it indicates the
malfunction by lighting up warning lamps when
ignition is switched on. The warning lamps are
located in the instrument cluster.

Instrument cluster without DIS
The illustration shows the ABS/EDL warning light -K47- (right arrow),
the warning light for brake system -K118- (center arrow, red symbol
for "brake system malfunction") and the traction control indicator light -
K86- (left arrow).
Pa
ge 1 of 10 ABS/EDL Bosch 5.0
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.5

01-47

ABS
-
K47- Brake
system ASR

-
K86-
1) Possible reasons why the indicator lamps light up

If an irregularity occurs during the self test after ignition is switched on, and the warning
lamps -K47- and -K86- do not light up for 2 seconds, check the warning lamps; "Electrical
test" page 01
-68
, carry out test steps 19 and 21. The possible causes are as follows:

Electrical Wiring Diagrams, Troubleshooting & Component Locations
Repair Manual, Electrical Equipment, Repair Group 90; Instrument cluster

The battery voltage is insufficient. None of the lamps in the instrument cluster light up. Check
the battery.





X 1)
The ABS warning light does not light up during the self-test. There is a short to Ground (GND)
in the wiring that controls the ABS warning light between terminal 32 of the ABS control
module -J104- and the instrument cluster. This malfunction does not affect activation of the
ABS warning light. For vehicles equipped with ASR, the traction control indicator lamp lights up
during the self-test; "Electrical test" page 01
-68
, carry out test step 19.

X


The vehicle is equipped with ASR. The ABS warning light lights up during the self-test. The
traction control indicator light does not light up during the self-test "Electrical test" page 01
-
68
, carry out test step 21.
Pa
ge 3 of 10 ABS/EDL Bosch 5.0
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.5

1) The traction control indicator light is only available in vehicles equipped with ASR.
Pa
ge 4 of 10 ABS/EDL Bosch 5.0
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.5

01-48

ABS
-K47-
Brake
system ASR

-K86-
1) Possible reasons why the indicator lamps light up



X



X1)
If activation of the lamps and the voltage supply are OK, the warning lamps light up for 2
seconds during the self-test after ignition is switched on.
The vehicle is either equipped with or without ASR, warning lamps do not switch off after self-
test. However, the red "brake system malfunction" symbol did not go on. Carry out the
"Electrical test", page 01
-68
, test step 20 and observe the next example of lighting
warning lamps.
1) The traction control indicator light is only available in vehicles equipped with ASR.
Pa
ge 5 of 10 ABS/EDL Bosch 5.0
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.5

1) The traction control indicator light is only available in vehicles equipped with ASR.
Pa
ge 7 of 10 ABS/EDL Bosch 5.0
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.5

01-50

ABS
-K47-
Brake
system ASR

-K86-
1) Possible reasons why the indicator lamps light up






X1) The vehicle is equipped with ASR:

There is a malfunction that affects only the ASR system. The ABS and EDL systems are not
deactivated. Check DTC memory page 01
-97
.
ASR is switched off via the traction control button. If the traction control indicator light does
not light up in this case, check the switch and the indicator light, carry out the "Electrical test",
steps 21 and 22 page 01
-68
.
ASR is in adjustment mode. The traction control indicator light blinks 3 times per second.
Short circuit to B+ in the traction control button: The traction control indicator light switches off
five minutes after ignition is switched on.
The lamp remains constantly lit after ignition is switched on, but none of the above mentioned
conditions are true. There is a short to Ground (GND) in the wiring that controls the traction
control indicator light between terminal 31 of the ABS control module -J104- and the
instrument cluster.



There is an irregularity present or a complaint has been made. The indicator lamps go on
during the self-test and then go out. The possible causes are as follows:

The DTC 00526 "Brake light switch -F-" is stored in DTC memory , check DTC memory
page 01
-97
.
The DTC 00668 "Vehicle voltage terminal 30" is stored in DTC memory , check DTC memory
Pa
ge 8 of 10 ABS/EDL Bosch 5.0
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.5

page 01
-97
.
The onset of EDL was temporarily shut-off to avoid an overheating in the brake system.
1) The traction control indicator light is only available in vehicles equipped with ASR.
Pa
ge 9 of 10 ABS/EDL Bosch 5.0
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.5

01-51

ABS
-
K47- Brake
system ASR

-K86-
1) Possible reasons why the indicator lamps light up





X





X
The vehicle can be equipped either with or without ASR. No DTCs are stored in DTC
memory. The ABS lamp remains constantly lit after ignition is switched on and the the red
"brake system malfunction" symbol also lights up 3 seconds after ignition is switched on.
The traction control indicator lamp does not light up even for vehicles equipped with ASR.


Voltage supply for control module less than 6.5 volts; carry out "Electrical test" step 23 page 01
-68
.
There is an open circuit or short circuit to B+ in the wire that controls the ABS warning lamp
between terminal 32 of the ABS control module -J104- and the instrument cluster; carry out
"Electrical test" step 19 page 01
-68
.



X
No DTCs are stored in DTC memory. The red "brake system malfunction" symbol remains
lit after ignition is switched on.


The brake fluid level is too low
Malfunction in instrument cluster: Carry out "Electrical test" step 20, page Page 01
-68
.
1) The traction control indicator light is only available in vehicles equipped with ASR.
Pa
ge 10 of 10 ABS/EDL Bosch 5.011/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.5