headlights AUDI A4 1999 B5 / 1.G Engine Oil Level Checking Workshop Manual
[x] Cancel search | Manufacturer: AUDI, Model Year: 1999, Model line: A4, Model: AUDI A4 1999 B5 / 1.GPages: 111, PDF Size: 1.26 MB
Page 67 of 111

67
Headlights, adjusting
Requirements
Tires inflated to correct pressure.
Lenses clean and in proper condition.
Reflectors in proper condition.
Springs settled (load vehicle with approx. 75
kg (165 Ibs) on driver's seat and roll several
meters (yards).
Vehicle standing on level ground.
Adjust headlight housing from top with
screwdriver or allen wrench.
Illustration shows adjusting screws for right headlight. Adjusting screws for
left headlight are symmetrically opposite.
A = Vertical adjustment
B = Lateral adjustment
Pa
ge 67 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 68 of 111

68
Headlights, aiming using Hella Universal
Beamsetter IV
Service
Align vehicle headlamps using the VAS 5107
(Hella Universal Beamsetter IV) and the following
procedure:
Additional instructions and diagrams
Instruction Manual for the Hella Beamsetter
Series IV
Have a second technician sit in the driver's seat while aligning the
headlights. - Position vehicle on a flat floor surface that meets the following (ISO
10640) specifications:
0.5mm or less slant from front wheel to back wheel of the
Beamsetter -A-.
1mm or less slant per meter for the length of the vehicle -B-.
- Clean headlight lenses.
- Adjust vehicle tire pressure to specifications.
- Bounce front and rear of vehicle up and down several times to settle
vehicle suspension.
Pa
ge 68 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 69 of 111

69
Setting low beam alignment of driver's side
headlight
- Move Beamsetter into position in front of the
vehicle so it is aligned with the vehicle and
Beamsetter box is 30 to 70cm (12 to 28 in.) from
the driver's side headlight.
- Switch headlights ON in low beam position.
- Align Beamsetter box so it is centered on the
headlight (align vertically then horizontally).
Note:
Use the arrows on the Beamsetter box as a
guide.
You may want to use a straight edge or tape
measure, because alignment must be within
3cm (1.2 in.) of the center of the headlight.
- Without moving the Beamsetter, slide Broad-
band sight toward center of vehicle (Broad-band
sight can also be moved up and down for a
better position).
Use Broad-band sight to make final alignment of
Beamsetter box to vehicle by:
Pa
ge 69 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 72 of 111

71
Note:
VOL is the correct beam pattern for both right
and left headlights.
Note:
If the height alignment changed, readjust.
Checking driver's side headlight high beam alignment - Adjust lateral (horizontal) alignment of driver's side headlight so that
the peak (highest point) of the headlight beam pattern aligns with the
right edge of the target box of the grid on the pattern screen (it should
match the VOL pattern shown on the Beamsetter box).
- Switch headlights ON in high beam position.
- Realign Beamsetter box with the high beam headlight if necessary.
- Set Beamsetter "Scaled wheel" to 0%.
- Cover low beam lamp (use hand or small piece of cardboard) and
check that the "hot spot" of high beam pattern is centered on the
square target box of the pattern screen.
Pa
ge 72 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 74 of 111

73
Passenger's side headlight, alignment
- Move Beamsetter to the passenger side of the
vehicle and follow the same procedures to align
the Beamsetter box to the headlamp.
- Align headlight low beam, check high beam and
align fog lamp.
Note:
Make sure to reset the Beamsetter "Scaled
wheel" to the proper setting each time you
change from low beam to high beam or to fog
lamp.
- Ensure that headlights and vehicle body are
clean and free of fingerprints.
Pa
ge 74 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6