low beam AUDI A4 1999 B5 / 1.G Suspension Rear Axle Front Wheel Drive Workshop Manual

42-1


Rear axle, servicing (front-
wheel-drive vehicles) WARNING!
CAUTION!
If using power tools (pneumatic or electric), do
not tighten the bolted connections more than
hand-tight. Otherwise, the specified tightening
torques could be exceeded.
Do not attempt to weld and/or straighten the
axle beam.
Do not re-use fasteners that are worn or
deformed in normal use.
Some fasteners are designed to be used only
once, and are unreliable and may fail if used
a second time. This includes, but is not
limited to, nuts, bolts, washers, circlips and
cotter pins. Always follow recommendations
in this manual-replace these fasteners with
new parts where indicated, and any other
time it is deemed necessary by inspection.
Pa
ge 1 of 26 Rear axle, servicin
g (front-wheel-drive vehicles
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.42.1

control linkage to axle beam.

Tightening torque: 3 Nm +1/-0 Nm (27 in. lb +9/-
0 in. lb)

- Install cover below rear axle.

- Check wheel alignment and adjust if necessary
page 44
-6 .
Pa
ge 16 of 26 Rear axle, servicin
g (front-wheel-drive vehicles
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.42.1

42-14

Guide bushings, removing and installing


Lowering rear axle
- On vehicles with headlight range control remove linkage from axle
beam.
- Remove bolts from guide bushing mount and lower axle.
- Position VW552 guide piece to prevent brake lines from becoming
stressed.

Removing guide bushing
Pa
ge 17 of 26 Rear axle, servicin
g (front-wheel-drive vehicles
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.42.1