height AUDI A4 1999 B5 / 1.G Suspension Wheel Alignment Workshop Manual
[x] Cancel search | Manufacturer: AUDI, Model Year: 1999, Model line: A4, Model: AUDI A4 1999 B5 / 1.GPages: 37, PDF Size: 0.41 MB
Page 4 of 37
44-8
Example of vehicle data label
In this example the vehicle is installed with the standard suspension,
version 1BA (arrow).
The vehicle data label is located in the spare wheel recess and in the
vehicle Maintenance booklet.
Factory codes for the suspension:
1BA: Standard suspension1BE: Sport suspension 1BB: Heavy duty suspension (approx. 20 mm (3/4 in.) higher)1BC: Special purpose suspension1BD: Sport suspension, Audi S41BH: USA1BT: Heavy duty suspension (approx. 7 mm or 1/4 in. higher)1BP: Heavy duty suspension (same ride height as 1BA but with limited
bump)
Pa
ge 4 of 37 Wheel ali
gnment
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.44.2
Page 28 of 37
44-29
Standard suspension 1BA, special
suspension (1BC) and heavy duty
suspension 1BP
On vehicles with standard running gear, the toe-in measurement C1 is
measured in the defined starting position (vehicle at curb weight) B1
page 44
-30
.
Heavy duty suspension 1BB (vehicle ride height 20 mm higher)
On vehicles with heavy duty suspension 1BB:
B2 Vehicle suspension extended 60 mm (2.36 in.) compared to position
B1
C2 Toe-in measured in position B2
C1 Toe-in measured in position B1 (defined starting position) page 44
-32
C2 Toe-in measured in position B2
Pa
ge 28 of 37 Wheel ali
gnment
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.44.2
Page 31 of 37
44-32
Bring vehicles with heavy duty suspension
1BB (vehicle ride height 20 mm higher) into
defined starting position B1 page 44
-28
Note:
Depending on the type of wheel alignment
equipment used, it may be necessary to raise the
front of the vehicle in order to position the
VAG1925 spacer. After lowering the vehicle
again the suspension must be bounced.
- Insert VAG1925 spacer together with VAG1925/4 adapters and screw
both threaded spindles out...
Make sure vehicle is not raised using the above procedure - ...until they just rest against front subframe bolts (arrow).
Vehicle with heavy duty suspension 1BB is now in defined starting
position B1
Pa
ge 31 of 37 Wheel ali
gnment
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.44.2