transmission AUDI A4 2000 B5 / 1.G 01A Transmission Differential Remove And Install Workshop Manual

39-16


Differential, removing and
installing

Special tools and equipment

VW771 slide hammer-complete set
3257 plug insert 27 mm
21/3 Kukko extractor

Notes:
Removing and installing the differential is
possible with the transmission installed.
The differential can be removed and installed
without disassembly of the shift mechanism,
drive axle, pinion shaft, and cover. Disassembly
of the above mentioned parts is necessary, if
the differential needs to be adjusted.
Transmission code CXF: drive flanges are
installed without polygon bearings.
Polygon bearing can be replaced only with the
drive flange.

Pa
ge 1 of 6 Differential, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.4

39-17


1 -
Transmission housing1)
2 -
Seal
Always replace Page 39
-1
3 -
Circlip
Always replaceRemoving and installing Fig. 1
4 -
Spacer ring
Only installed on drive axles with polygon
seals and spline diameter of 30 mm (1.181
in) Removing Fig. 2Installing Fig. 3
5 -
Drive flange
Removing and installing Page 39
-1
Assembly Fig. 4
6 -
Differential with ring gear1)
Disassembling and assembling Page 39
-21

7 -
Cover for final drive1)
8 -
Torx bolt
25 Nm (18 ft lb)
Pa
ge 3 of 6 Differential, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.4