ECU AUDI A4 2000 B5 / 1.G 01A Transmission Final Drive Flange Driveshaft Seals Workshop Manual

39-9


Note: - Remove driveshaft -1- from transmission and rest it on heat shield -2-.
- Secure driveshaft to fuel line bracket -3- using wire (arrows).
- Place VAG1306 drip tray underneath and drain transmission oil.
- Place VAG1306 drip tray underneath end cover.

Oil will run out when removing cap -B-
- Remove circlip -A-.
- Screw M8 bolt into thread of cap -B-.
- Pull out cap -B- using bolt.
Pa
ge 4 of 7 Drive flan
ge and driveshaft seals, re
placin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.2

39-11

Installing

- Fill space between sealing lip and dust lip with
gear oil.

- Lightly oil outer circumference of seal.

- Drive in drive flange seal 2 mm (0.079 in.) below outer housing surface,
without canting.
- Install drive flange.

The circlip must be seated in the base of the groove. - While inserting drive flange, install circlip at same time.
- Replace O-ring for cap.
- Install cap and secure in position.
- Install driveshaft Page 39
-71
.
Pa
ge 6 of 7 Drive flan
ge and driveshaft seals, re
placin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.2