lock AUDI A4 2000 B5 / 1.G 01A Transmission Rear Final Drive Remove Install Workshop Manual

39-107


WARNING!
For sefety reasons, two persons are required for lowering the final
drive, and raising it again for installation.
Note:
Crossmember -1- does not need to be removed.
Installing
Installation is the reverse of removal, note the following:
Notes: - Remove mounting bolts -B- and -C- from rear crossmember at final
drive.
- Lower final drive using transmission hoist.
Always replace self-locking nuts.Always replace self-locking driveshaft bolts.The threaded holes on the drive flange on the final drive should be
cleaned of all locking compound residue after driveshaft has been
removed. Otherwise there is a risk of seizing the bolt when tightening
and subsequently breaking off at the next disassembly. The threads can be cleaned using a thread tap.Replace seals between driveshaft and drive flange (remove protective
film and bond seal to drive flange. Adhesive bond surface must be
free of grease.
Pa
ge 4 of 7 Rear final drive, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.12

39-108


Notes: - Use transmission hoist, to raise final drive far enough until both drive
axles can be installed.
- Tighten drive axle bolts slightly.
- Raise final drive and bolt to crossmember and transmission support.
- Install drive shaft Page 39
-74
.
Always replace self-locking bolts for driveshaft.

To prevent imbalance, the flanges of the driveshaft (arrow -A-) and of
the final drive (arrow -B-) must be installed so that the factory color
markings (or the color markings made during removal) are aligned. After removing driveshaft from final drive, additional balance disc
(thicker washer) which may have been installed between base plate
and bolt head may not be re-installed.
- Check oil level in final drive Page 39
-84
.
Pa
ge 5 of 7 Rear final drive, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.12