battery AUDI A4 2000 B5 / 1.G Battery User Guide

27-10

Electrolyte level too high

Special tools, test equipment and auxiliary
items

Commercially available hydrometer
Note:
If the electrolyte level is too high, the sulfuric acid/water mixture will leak
to the outside of the battery and damage functional components in the
engine compartment.
- If electrolyte level is too high (overfilling), i.e., it is above internal
electrolyte level mark (lip of plastic flange) or external maximum line,
draw off excess electrolyte using commercially available hydrometer.
- Draw off electrolyte using hydrometer until electrolyte level has
reached lip of plastic flange or maximum line.
Pa
ge 11 of 29 Batter
y
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.1

27-12

No-load voltage, checking


CAUTION!

Battery cell caps must be screwed in tightly
when charging, measuring voltage or
performing load tests.
Always comply with the following
instructions otherwise a correct
measurement cannot be assured.

Special tools, test equipment and auxiliary
items
VAG1715 multimeter or
VAG1362 minitester or
Multimeter (Fluke 83 or equivalent)

Notes:
When testing the no-load voltage of a battery
installed in a vehicle, make sure the battery
Ground (GND) strap is disconnected.
The battery must not have been under a load
Pa
ge 13 of 29 Batter
y
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.1

for at least two hours before the test.
The battery must not have been charged at
least two hours before the test.
Pa
ge 14 of 29 Batter
y
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.1

27-13
Use the following procedure for testing the
voltage of a battery which is not under load:

- Switch ignition off.

- Disconnect battery Ground strap.

- Measure voltage between battery terminals.


12.5 volts or higher: battery OK

Below 12.5 volts: recharge battery
immediately Page 27
-21

Pa
ge 15 of 29 Batter
y
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.1

27-14

Specific gravity, checking


Special tools, test equipment and auxiliary
items

CAUTION!
Notes:
The specific gravity can be tested immediately after charging the battery.
Commercially available hydrometerShop towelWhen working with battery acid, make sure to follow all "Warnings
and safety precautions for lead-acid batteries." Wear suitable
protective clothing and eye protection. When disposing of batteries, always comply with applicable
Federal, State and local laws regarding the disposal of batteries
and sulfuric acid. In order to better determine the overall condition of a battery, always
perform a specific gravity test in conjunction with the load test. The temperature of the electrolyte must be at least 10 C (50 F).
Pa
ge 16 of 29 Batter
y
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.1

27-15
Use the following procedure to test the specific
gravity in all of the battery cells:

- Switch ignition off.

- Remove all cell caps.

The higher the specific gravity of the drawn electrolyte, the higher the
indicator will float.
The specific gravity of the electrolyte can be read in kg/dm3 on the
hydrometer scale. - Immerse tip of hydrometer into battery cell and draw out enough
electrolyte to allow indicator to float freely.
- Compare measured value indicated on hydrometer to values indicated
in table below:
Pa
ge 17 of 29 Batter
y
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.1

27-16

State of charge in normal
climate zones Specific gravity in
kg/dm
3
Discharged 1.12
Half charged 1.20
Good charge 1.28
In normal climate zones, the specific gravity must
be at least 1.24 kg/dm
3.

- If specific gravity is too low: charge battery.

- After charging battery, repeat specific gravity
test.

Note:
The measured values for the specific gravity of
the individual battery cells must not vary by more
than 0.03 kg/dm
3.
Pa
ge 18 of 29 Batter
y
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.1

27-17

Examples of unacceptable variations in
specific gravity:

Battery
cell: 1 2 3 4 5 6

Specific gravity per cell in kg/dm
3
Example
1: 1.24 1.25 1.25 1.10 1.24 1.25

Example
2: 1.26 1.26 1.25 1.14 1.18 1.24
Example 1:
The specific gravity in cell 4 is too low.
Example 2:
The specific gravity in cells 4 and 5 is too low
(the difference in specific gravity between the
cells is greater than 0.03 kg/dm
3).

- If values are not met, replace battery.

- If values are met, reinstall cell caps.
The original cell caps that came with the battery
must be reinstalled to help prevent leakage.
Pa
ge 19 of 29 Batter
y
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.1

27-18

Load testing


In order to better determine the overall
condition of a battery, always perform a load
test in conjunction with the specific gravity
test.

Special tools, test equipment and auxiliary
items

Note:
When using the VAS1979 or VAS5033 battery tester, it is not necessary
to remove the battery or disconnect the battery cables.
VAS1979 or VAS5033 battery tester
- Follow warnings and safety precautions for lead-acid batteries. Wear
protective clothing such as face shield and leather gloves.
Pa
ge 21 of 29 Batter
y
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.1

27-19

Load test procedure

- Switch ignition off.

- Read battery tester operating instructions.

Battery tester operating instructions
Table - Observe carefully:
Connect the clamps to the battery terminals as required by the tester
instruction manual. The clamps must make good contact with the
battery terminals.
- Load current varies depending on battery capacity, set load current on
tester appropriately. - Obtain load current from table below.

The minimum voltage (the voltage which must be exceeded) varies
and can be obtained from the table below.
The load current and minimum voltage vary depending on the
capacity of the battery. Battery
capacity Cold cranking
amps Load
current Minimum voltage
(limit)
70 Ah 340 A 200 A 9.5 V
Pa
ge 22 of 29 Batter
y
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.1