wiring AUDI A4 2000 B5 / 1.G Suspension Wheel Bearing Housing Remove And Install Workshop Manual

40-55


- Remove bolts -1- for brake splash guard.
- Pull ABS wheel speed sensor out of wheel bearing housing.
- Loosen nuts -2- and -3-.

- Pull out rubber grommet -1- and disconnect harness connector -2-.
- Detach ABS wheel speed sensor wiring from retainers (arrows).
- Guide wiring through opening in wheel bearing housing and remove.
Be careful not to damage the rubber grommet.
Pa
ge 3 of 17 Wheel bearin
g housin
g, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.40.5

40-61


3 -
Wheel hub
Shouldered
With 75 mm diameter wheel bearing
housing: Pressing hub out Fig. 1Pressing hub in Fig. 9
With 82 or 85 mm diameter wheel bearing
housing:
Pressing hub out Fig. 2Pressing hub in Fig. 10
4 -
Bolt
10 Nm (7 ft lb)
5 -
Brake splash guard
6 -
ABS wheel speed sensor Pull out to removeInstall drive axle before installing speed
sensor Press into clamping sleeve up to stopRouting wiring page 40
-55
7 -
Clamping sleeve
Always replace
Pa
ge 10 of 17 Wheel bearin
g housin
g, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.40.5