key AUDI A4 2008 B8 / 4.G Quick Reference Guide

Downloaded from www.Manualslib.com manuals search engine
1
2
3
Locking sensor
Audi A4
Quick reference guide
Dear Audi Driver,
This quick reference guide gives you a brief introduction
to the main features and controls of your vehicle.
However, it cannot replace the Owner’s Manual and the
other manuals supplied with the vehicle; these contain
important information and safety warnings.
We wish you safe and enjoyable motoring
with your Audi.
AUDI AG
Anti-theft alarm system
The alarm system is automatically setwhen you lock
the car, and switched off when you unlock the car
with the remote control. If you unlock the vehicle by
inserting the key in the driver’s door, the ignition must
be switched on within 15 seconds, otherwise the alarm
will be triggered.
Opening boot lid
If you
p press the button on the remote control key,
p or pull the button on the driver’s door,
p or press the catch on the boot lid, the boot lid will
be unlocked and opened. Push up the boot lid
slightly to make it stay open.
Locking and unlocking the vehicle
Press the required button.
eUnlocking button
Open one of the doors within about 60 seconds, other-
wise the vehicle will lock itself again automatically.
rUnlocking button for boot lid
Press the button for at least 1 second.
tLocking button
The turn signals flash once to
confirm that the doors and
boot lid are properly
closed and locked.
Convenience feature
Press and hold button
eor ton the remote control
key to open or close all the windows and the sun roof
automatically.
WARNING!
The doors and windows cannot be opened from
inside the vehicle if it has been locked from the
outside.
1Locking and unlocking the vehicle
Comfort setting
Turn the control until it
engages at position
e.
To tilt open
Press the control briefly (in position ) to make the
roof tilt open all the way. Pull the control to close the
sun roof.
Press or pull the control and hold it to make the roof
tilt up or down to the desired position.
12
0
Sun roof
Opening and closing
With the ignition switched on, turn the control to
position
rand hold it there until the roof reaches the
desired open position. When you let go of the control
it will auto matically
return to position
e.
To close the roof, turn
the control back to
position .
Page 1

Downloaded from www.Manualslib.com manuals search engine
Page 2

1

2
3
4
5
6
894
7
1Starting/stopping the engine · Adjusting front seats
%advanced key
The advanced key allows you to lock and unlock the vehicle
and start the engine without handling the key itself. You only
need to have the remote control key on your person.
Unlocking the vehicle
Take hold of a door handle. The vehicle will be unlocked auto-
matically.
Locking the vehicle
Briefly touch the locking sensor on one of the door handles.
The selector lever must be in position Pon vehicles with
automatic gearbox.
Note:If you keep hold of the sensor, this will also close the
windows and the sun roof.
Adjusting front seats
Manual seat adjustment
eAdjusting head restraint
To raise head restraint:Take hold of the sides of the head
restraint with both hands and move it up as required
To lower head restraint:Press the button on the side and
move the head restraint down.
rAdjusting backrest
Take your weight off the backrest
and turn the knob.
tAdjusting seat height
Lift or press the lever repeatedly until
the seat reaches the desired height.
uAdjusting lumbar support
Press the appropriate part of
the switch.
iAdjusting angle of seat cushion
Lift or press the lever repeatedly
until the seat reaches the desired
height.
oMoving seat backwards or forwards
Lift the lever and move the seat into the desired position.
Then release the lever and move the seat further until the catch engages.
pAdjusting thigh support
Pull up the handle to extend the thigh support.
To retract the thigh support, push it back into the seat. Electrical seat adjustment
uAdjusting lumbar support
Press the appropriate part of
the switch.
aAdjusting seat height and
moving seat backwards
or forwards
Press the switch in the direction
indicated by the arrows: To raise/lower the seat
at the front
To raise/lower the seat at
the rear
To raise/lower the seat
To move the seat forwards/
backwards
sAdjusting backrest
Press the switch in the direction indicated
by the arrows: Backrest further upright/further
reclined
Starting/stopping the engine
Starting the engine
p Insert the key in the ignition lock.
p Manual gearbox: Press the clutch pedal and select neutral
gear.
p Automatic gearbox: Press the brake pedal and move the
selector lever to Por N.
p Press the key in briefly.
On vehicles with diesel
engine, keep your foot
on the clutch (manual
gearbox) or brake
(automatic gearbox)
until the engine starts.
Switching off the engine when the vehicle is stationary
p Vehicles with automatic gearbox: Move the selector lever to
Por N.
p Press the key in briefly.
Switching the ignition on/off
p Press in the key withoutpressing the clutch
(manual gearbox) or brake pedal (automatic gearbox).
The key can be removed only when the ignition is off.

Downloaded from www.Manualslib.com manuals search engine
Page 6

[20] Audi hold assist
The Audi hold assist func-
tion automatically detects
when the vehicle is statio-
nary and prevents it from
rolling away. You do not
have to keep your foot on
the brake pedal.
Switching on/off: Press button
r. The diode in the button
will light up when the Audi hold
assist function is activated.
[20] Electro-mechanical parking brake
The parking brake replaces the conventional
handbrake.
Applying the parking brake when stopping:
Pull button
e.
Releasing the parking brake: Press brake
pedal and press button
e.
Releasing automatically: Drive off as normal.
The parking brake will be
released automatically
when you drive off.
WARNING!
Do not move the selector lever to positions P or R
when the vehicle is moving.

[17] Selector lever for automatic gearbox
P Parking lock
R Reverse gear
N Neutral
D Drive
To move the selector lever out of position
P or N, or into position Por R, press the inter-
lock button on the selector lever handle and the
brake pedal simultaneously.
Note:If the Audi hold
assist function is
switched off, use the
foot brake to hold the
vehicle when stationary
with the engine running
(in all selector lever

positions other than P).
Manual gear selection
(tiptronic)
The tiptronic program

enables you to change gear
manually. From position D,
push the selector lever to the right
as far as the stop. The currently selected gear is shown
in the instrument cluster display (bottom left). Push the
selector lever forwards briefly to shift up a gear, or pull
the lever back to shift down a gear.

1

2

3

[19] ENGINE START/STOP button
With the Audi advanced key you can start the engine
without having to insert the key into the ignition lock.
You only need to have the remote control key on your
person.
Starting the engine: Press the clutch pedal, select
neutral gear and press the START/STOP button
t.
On vehicles with automatic gearbox, move the selector
lever to position Por N, put your foot on the brake
pedal and press the START/STOP button.
Switching off the engine: Stop the vehicle, move the
selector lever to position Por Nand press the START/
STOP button
t.
Switching the ignition on/off: Press the START/STOP
button without pressing the clutch (manual gearbox)
or brake pedal (automatic gearbox).
[21] Lever for steering column
adjustment
Pull the lever and adjust
the position of the steering
column as required. Then push
the lever towards the steering column until the
catch engages.