fuel AUDI A6 1995 C5 / 2.G AHA ATQ Engines Valve Gear Service Manual
[x] Cancel search | Manufacturer: AUDI, Model Year: 1995, Model line: A6, Model: AUDI A6 1995 C5 / 2.GPages: 62, PDF Size: 1.17 MB
Page 24 of 62
15-20
- Disconnect blue harness connector on Intake Manifold Tuning (IMT)
valve.
- Disconnect black harness connector for intake air temperature sensor
on resonator.
- Cut tie wraps and move wiring to side.
- Disconnect vacuum line at cruise control vacuum diaphragm and at
vacuum booster.
- Unbolt cruise control vacuum diaphragm and unhook cruise control
vacuum diaphragm linkage at throttle body.
- Disconnect harness connector on throttle body and vacuum lines on
fuel pressure regulator.
- Disconnect harness connectors from camshaft adjustment valve and
from fuel injectors (arrows).
- Disconnect harness connectors from Engine Coolant Temperature
(ECT) sensor and Camshaft Position (CMP) sensor (arrows).
- Cut tie wraps on valve cover.
- Unclip wiring retainer on fuel rail and disconnect crankshaft housing
ventilation lines from left and right-side valve covers. Move hoses and
wiring clear (to rear).
Pa
ge 24 of 62 Valve
gear, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.15.1
Page 25 of 62
15-21
- Disconnect harness connector for tank diagnostic system in engine
compartment at arrow.
- Remove 4 bolts for fuel rail on intake manifold.
- Unclip fuel supply and return lines from retainer.
- Move fuel rail together with fuel injectors aside. Cover fuel injectors
with clean cloth.
- Install 3391 camshaft locator bar onto camshaft locking plates.
- Loosen both bolts for camshafts and back out bolts approx. 5 turns.
- Remove 3391 camshaft locator bar.
- Remove camshaft gear using T40001 special tool.
- Disconnect left-side spark plug connectors.
- Unbolt bracket for ignition coils (4 bolts) and move to right side together
with ignition coils.
- Unhook accelerator pedal cable and pull up out of retaining bracket.
Pa
ge 25 of 62 Valve
gear, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.15.1
Page 34 of 62
15-29
Compression, checking
Test conditions
Engine oil temperature at least 30 C
Battery fully charged
- Disconnect harness connectors from all 6 fuel
injectors.
- Disconnect 5-pin harness connector from power
output stage of ignition coils.
- Open throttle fully.
- Use VAG1381 or VAG1763 compression tester
to check compression.
- Operate starter until no further pressure
increases are indicated by VAG1381 or
VAG1763 compression tester.
Compression pressure
New
Wear
limit Max. permissable
difference between
cylinders
Pa
ge 34 of 62 Valve
gear, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.15.1