ignition AUDI A6 1996 C5 / 2.G 01V Transmission Read Measuring Value Block E18/2 Workshop Manual

01-228


Read Measuring Value Block
(scan tool function 08) for
transmissions with hydraulic
control -E18/2-

Notes:
For transmissions with hydraulic control -E17-,
"Read Measuring Value Block" can be found
page 01
-187


CAUTION!

To avoid risk of accidents during measuring
and test drives, note safety precautions
page 01
-34
.

Procedure

- Connect VAS 5051 tester or V.A.G 1551 scan
tool and select Transmission Control Module
(TCM) using "address word" 02 page 01
-36
.

Ignition must remain switched on for this
procedure. Rapid data transfer
HELP
Select function XX

Indicated on display
- Press PRINT button to turn on Scan Tool (ST) printer. Indicator lamp in
button must light up.
Pa
ge 1 of 42 Read Measurin
g Value Block
(scan tool function 08
) for transmissions with h
ydraulic control -E18/2-
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.14

01-261

Display
group
number Display
field Description
Test requirements
Spec. value on
V.A.G1551
display Corrective actions
013
1)
1 CAN-bus
normalizing torque While standing with
ignition switched on Nm
2 CAN-bus engine
code
0 ... 63
- See DTC table, DTC
18157/P1749 and 18249 /
P1841 page 01
-45

3 CAN-bus
Transmission
code
1
- Check coding of Engine
Control Module (ECM)
4 CAN-bus software
version code
0 ... 63
- See DTC table, DTC 18263 /
P1855 page 01
-45

1) This display group number is not displayed until model year 2000 (May 1999)
Notes for display group number 013;
Display field 2 and 4: When replacing the ECM, the same indication that appeared for the old control module should
appear after installation. If this is not the case, the wrong ECM was installed, or it is wrongly coded.
Pa
ge 41 of 42 Read Measurin
g Value Block
(scan tool function 08
) for transmissions with h
ydraulic control -E18/2-
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.14