ECU AUDI A6 1998 C5 / 2.G 01E Transmission Clutch Mechanism Service User Guide

30-20

Note:

For the following procedures, make sure that the clutch pedal does not
press out switch -1- from securing clip, since the thread of the switch
would be damaged and the switch would have to be replaced. To ensure proper securing, the switch may only be installed once.
- Remove bolts for master cylinder (arrow -2-) and for mounting bracket
(arrow -3-).
- Pull complete pedal assembly somewhat toward seating compartment
and remove clutch master cylinder -4-.
Pa
ge 20 of 27 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.1

30-22


- Tighten bolts for brake booster (arrows) to 25 Nm.

- Press securing clip -C- in to stop.
- Insert tube -B- into master cylinder until the tube engages audibly.
- Insert rubber grommet -D- into transverse wall above connecting
tube/after-run hose -A-.
- Slide on after-run hose -A- to brake fluid reservoir to stop.
- Remove special tool 3094.
Pa
ge 22 of 27 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.1

30-24

- Remove driver's side storage compartment:

Repair Manual, Body Interior, Repair Group
68


Repair Manual, Electrical Equipment, Repair Group 97
- Always replace seal -C-.
- Make sure seal does not cover chassis opening and elevated edge of
sheet metal.
- Insert E-Box in securing point -B- and tighten nuts -A- to 4 Nm.
- Press cover on by hand and tighten bolts -A- diagonally to 4 Nm (also
see inscription on cover).
- Install engine wiring harness and connect harness connector in
connector station.
- Install engine control module and if necessary, auxiliary relay carrier
and auxiliary fuse holder.
Pa
ge 24 of 27 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.1