fuel AUDI A6 1998 C5 / 2.G AHA Engine On Board Diagnostic Owner's Manual

01-39

Diagnostic Trouble Code
(DTC)
Malfunction
text
MIL
Corrective action
SAE
VAG



P1237 17645 Cyl.1-Fuel Inj.
Circ.
Open Circuit Immed.
- Check fuel injectors page 24
-102
and Output Diagnostic
Test Mode (DTM) page 01
-51

P1238 17646 Cyl.2-Fuel Inj.
Circ.
Open Circuit
P1239 17647 Cyl.3-Fuel Inj.
Circ.
Open Circuit
P1240 17648 Cyl.4-Fuel Inj.
Circ.
Open Circuit
P1241 17649 Cyl.5-Fuel Inj.
Circ.
Open Circuit
P1242 17650 Cyl.6-Fuel Inj.
Circ.
Open Circuit
Pa
ge 52 of 97 On Board Dia
gnostic
(OBD
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.01.1

01-40

Diagnostic Trouble
Code (DTC)
Malfunction
text
MIL
Corrective action
SAE
VAG



P1250 17658 Fuel Level
Too Low Off
Repair Manual, Electrical Equipment, Repair Group 01 (instrument cluster diagnostics, Read Measuring Value Block)
- Fuel volume less than 2 gallons; add fuel
- Check "fuel level low" signal page 24
-176
- Check fuel level sensor signal and fuel gauge
Note on misfire malfunctions:
For malfunctions that may be caused by low fuel volume (i.e. combustion misfire) a low-fuel malfunction (DTC "P1250") is also
stored when there is less than 2 gallons of fuel remaining in the tank.
Pa
ge 53 of 97 On Board Dia
gnostic
(OBD
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.01.1

Circ.
Short to Ground
P1473 17881 EVAP Emission Contr. LDP
Circ.
Open Circ.
P1476 17884 EVAP Emission Contr. LDP
Circ.
Malfunction/Insufficient
Vacuum Off
- Check Evaporative Emission (EVAP) system Repair
Manual, Fuel Supply System, Repair Group 20
P1477 17885 EVAP Emission Contr. LDP
Circ.
Malfunction
Pa
ge 59 of 97 On Board Dia
gnostic
(OBD
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.01.1

01-44

Diagnostic Trouble Code
(DTC)
Malfunction text
MIL
Corrective action
SAE
VAG



P1500 17908 Fuel Pump Relay Circ.
Electrical Malfunction Immed.
- Check fuel pump relay and relay actuation page 24
-95

P1501 17909 Fuel Pump Relay Circ.
Short to Ground
P1502 17910 Fuel Pump Relay Circ.
Short to B+
P1505 17913 Closed Throttle Pos. Switch
Does Not Close/Open Circ. 2 Dcy
- Check throttle body and throttle valve control
module page 24
-128

P1512 17920 Intake Manifold Changeover
Valve Circ.
Short to B+ Immed.
- Check Intake Manifold Tuning (IMT) valve (change-
over valve) page 24
-154

P1515 17923 Intake Manifold Changeover
Valve Circ.
Short to Ground

P1516 17924 Intake Manifold Changeover
Valve Circ.
Open
Pa
ge 60 of 97 On Board Dia
gnostic
(OBD
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.01.1

01-46

Diagnostic
Trouble Code
(DTC)
Malfunction text
MIL
Corrective action
SAE
VAG



P1564 17972 Idle Speed Contr. Throttle Pos.
Low Voltage During Adaptation
(Supply voltage under 10 V during adaptation of throttle
valve control module to engine control module.) Off
- Check voltage supply to ECM
page 24
-90

P1565 17973 Idle Speed Contr. Throttle Pos.
Lower Impact Not Attained
(Lower specification not attained during adaptation of
throttle valve control module to engine control module,
e.g., accelerator pedal cable incorrectly adjusted,
throttle body dirty, etc.) 2 Dcy
- Clean throttle body
- Check accelerator pedal cable
adjustment Repair Manual,
Fuel Supply System, Repair
Group 20 P1600 18008 Power Supply (B+) Terminal 15
Low Voltage Immed.
- Check voltage supply to Engine
Control Module (ECM) page
24
-90

Pa
ge 63 of 97 On Board Dia
gnostic
(OBD
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.01.1

01-51

Output Diagnostic Test Mode (DTM)
(scan tool function 03)


Notes:

The output Diagnostic Test Mode (DTM) can be
activated only with ignition switched on and the
engine not running.
The output DTM is interrupted if the engine is
started, or if a rotary pulse from the ignition
system is recognized.
When operating in the output DTM, the
individual output signals are actuated until the
program sequence is advanced by pressing the
button.

Output signals are checked by listening for the
sound of the component being actuated, or
feeling for mechanical evidence of actuation,
such as clicking, vibration, etc.
Without letting the engine run, briefly switch the
ignition off for approx. 20 seconds before
repeating the output checks.
During the entire output DTM sequence, the
electric fuel pump will run.
Pa
ge 69 of 97 On Board Dia
gnostic
(OBD
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.01.1

01-52
The following components are actuated in
sequence:

1. Cylinder 1 fuel injector -N30-
2. Cylinder 2 fuel injector -N31-
3. Cylinder 3 fuel injector -N32-
4. Cylinder 4 fuel injector -N33-
5. Cylinder 5 fuel injector -N83-
6. Cylinder 6 fuel injector -N84-
7. EVAP canister purge regulator valve -N80-
8. Secondary AIR solenoid valve -N112-
9. Secondary AIR pump relay -J299-
10.
Intake manifold tuning valve -N156-
(change-over valve)
11.
Camshaft adjustment 1 (Valves -1- and -2-
for camshaft adjustment, -N205- and -N208-
)

Required special tools and testing
equipment

VAG1551 Scan Tool (ST) with VAG1551/3
adapter cable

Test conditions
Pa
ge 71 of 97 On Board Dia
gnostic
(OBD
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.01.1

Fuse for Engine Control Module (ECM) OK
Closed Throttle Position (CTP) switch -F60-
OK
Fuel pump relay OK
Pa
ge 72 of 97 On Board Dia
gnostic
(OBD
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.01.1

01-53

Test sequence

- Connect VAG1551/VAG1552 scan tool and
insert "Engine Electronics" address word 01
(ignition on) page 01
-8 .
Rapid data transfer
HELP
Select function XX

Indicated on display
- Press buttons -0- and -3- to select "Output Diagnostic Test Mode"
function 03.
Rapid data transfer
Q
03 - Output Dia
gnostic Test Mode

Indicated on display
Fuel injectors:
- Press -Q- button to confirm input.
Output Diagnostic Test Mode Cylinder 1 Fuel In
jector-N30

Indicated on display
Note:
The fuel pump relay must be activated, the fuel pump must run, and you
must clearly hear the flow of fuel in the fuel pressure regulator. If the fuel
pump does not run, check fuel pump relay and connections page 24
-
95
.
- Operate throttle valve at throttle body.
As soon as the Closed Throttle Position (CTP) switch opens, cylinder 1
fuel injector must be actuated (click) 5 times.
Pa
ge 73 of 97 On Board Dia
gnostic
(OBD
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.01.1

01-54
To check remaining fuel injectors:

-
Press button and open the throttle valve
again.
As soon as the Closed Throttle Position (CTP)
switch opens, the applicable fuel injector must
be actuated (click) 5 times.

- Repeat for each fuel injector.
To skip individual tests:

-
Press button to advance through program
sequence. If one or more of the fuel injectors is not
actuated:

- Check fuel injectors page 24
-102
.
Pa
ge 74 of 97 On Board Dia
gnostic
(OBD
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.01.1