wiring diagram AUDI A6 2000 C5 / 2.G 01V Transmission Electrical Testing Workshop Manual

01-274

Additional information

Repair Manual, 5 Spd. Automatic Transmission
01V,
Electrical Wiring Diagrams, Troubleshooting &
Component Locations"

Notes:
Use VAG1526A multimeter for the test. The
tables list which measures range needs to be
selected before taking each measurement.
The specified values are valid for an ambient
temperature of 0 to 40 C (32 to 104 F).

If the values obtained differ from the specified
values, determine the malfunction using the
applicable wiring diagram.
If the measured values only deviate slightly
from the specified values clean sockets and
connectors of testers and repeat test. Before
replacing a component, check wires and
connections. If the specified values are below
10 , repeat the resistance measurement on
the component.
Pa
ge 2 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-275

The contact numbers of the connector and the
socket numbers of VAG 1598/20 test box match
up page 01
-277
.

To check the multi-function switch, it is not
necessary to connect test box VAG 1598/20
because first the connectors for the multi-
function switch are checked.

CAUTION!

To avoid permanent damage of electronic
components, select the appropriate
measuring range on tester before connecting
the measuring leads.

Test requirements
Battery voltage OK
Fuses for Transmission Control Module
(TCM) OK

Electrical Wiring Diagrams, Troubleshooting &
Component Locations

Fuses for component being tested OK. The
fuse holder is behind a cover on the side of
Pa
ge 4 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

the instrument cluster.
Ground (GND) connections OK:

Check battery Ground (GND) strap and Ground
(GND) strap between body and transmission.

Check Ground (GND) connections for
Transmission Control Module (TCM).

Electrical Wiring Diagrams, Troubleshooting &
Component Locations
Pa
ge 5 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-277
88-pin connector for Transmission Control Module (TCM) -J217- (sockets on VAG1598/20)
1- Solenoid valve 5 -N92- 18-
Kick-down switch -F8- (not for E-gas and V6-TDI)
2- Shift lock solenoid -N110- 19-
Control input to transmission from ABS control module
3- Vacant 20-
Engine intervention (via ignition timing)
1)
4- Solenoid valve 7 -N94- 21-
ATF temperature sensor -G93-
5- Solenoid valve 4 -N91- 22-
ATF temperature sensor -G93-
6- Ground (GND) for power consumers, term.
31 23-
Sensor for transmission RPM -G182- (shielding)
7- Vacant 24-
Vacant
8- Multi-function TR switch -F125-, L2 25-
Selector lever display (not for Highline combi)
9- Multi-function TR switch -F125-, L4
supply voltage for cruise control system 26-
Supply voltage (terminal 30) with or without fuses depending on
model wiring diagram
10-
Brake light switch -F- (not for E-gas and
V6-TDI) 27-
Kick-down for air conditioning
1)
11-
Vacant 28-
Ground (GND) for electronics (terminal 31)
4)
12- Vacant 29- Solenoid valve 6 -N93-
Pa
ge 7 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-282
Electrical test table

Voltage measurement: Switch multimeter to 20 V measuring range
Test
step VAG
1598/20
sockets Test of
Test
conditions
- Additional
steps Specified
value Corrective action
1 55 + 6
55 + 6
54 + 28
1) Supply voltage for
Transmission Control Module
(TCM) -J217-
Ignition
switched on approx.battery
voltage - Check wiring per wiring
diagram.
- Check wiring from terminals 6,
34 and 28 to Ground
- Check wiring from terminals 54
and 55 to terminal 15 of central
electric.

54 + 55
0 V

26 + 6
26 + 34 Voltage of electr. system
(term. 30) for TCM -J217- Ignition
switched off approx. battery
voltage - Check wiring per wiring
diagram.
2 2 + 6
Shift lock solenoid -N110-
2)
Ignition
switched on approx. battery
voltage - Check wiring per wiring
diagram.
- Test multi-function TR switch -
F125- for short circuit.
- Test shift lock solenoid -N110-
for short circuit.
Pa
ge 14 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-283

Voltage measurement: switch multimeter to 20 V measuring range
Test step
VAG
1598/20
sockets Test of
Test conditions
- Additional stepsSpecified
value Corrective action
3
1)
10 + 6
10 +
28
2) Brake light switch
-F-
Ignition switched
on Brake pedal not
depressed less than 1 V
- Check wiring per wiring
diagram.
- Replace and adjust brake
light switch -F-.
not for E-gas
engines
- Brake pedal
depressed approx. battery
voltage Repair Manual, Brake
System, Repair Group 47

4 9 + 6
9 + 28
2) Supply voltage for
Cruise Control, Control
Module
-J213-
Ignition switched
on Selector lever in
D, 4 and 3 approx. battery
voltage - Check wiring from terminals
6 and 28 to Ground.
- Check wiring from terminal 9
to terminal 15 of central
electrics.
- Check wiring to cruise
control, control module -J213-
- Check multi-function switch -
F125- page 01
-322


Selector lever in
P, R, N, and 2 less than 5 V
- Check fuse 31
Pa
ge 16 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-284

Voltage measurement: switch multimeter to 20 V measuring range
Test step
VAG
1598/20
sockets Test of
Test conditions
- Additional stepsSpecified
value Corrective action
5
1)
not for E-gas
engines 18 + 54 Kick-down
switch -F8-
Ignition switched on
- Depress accelerator to
kick-down approx. battery
voltage
Repair Manual, General,
Engine, Repair Group 20 - Check wiring per wiring
diagram.
- Adjust or replace accelerator
pedal cable.
- Perform test step 17.
1) This test cannot be performed on vehicles with E-gas. The kick-down switch -F8- in this case is integrated in the Throttle
Position (TP) Sensor (-G79-, -G185-).
Pa
ge 18 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-285

Voltage measurement: switch multimeter to 20 V measuring range
Test
step VAG
1598/20
sockets Test of
Test conditions
- Additional stepsSpecified
value Corrective action
6
2 + 54
2 +55 Shift Lock Solenoid -
N110-
1)
Ignition switched
off 14 to 28

- Check wiring per wiring diagram.
- Check multi-function switch -F125-
Page 01
-306

- Check Shift Lock Solenoid -N110- for
short circuit
- Perform test steps 2 and 16.
1) Solenoid for shift lock -N110- is also referred to as shift lock solenoid -N110-
Pa
ge 19 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-286

Resistance measurement: switch multimeter to 200 measuring range
Test
step VAG
1598/20
sockets Test of
Test
conditions
- Additional
steps Specified
value Corrective action
7 6 + 34
28
1) + 34 Ground (GND) connection of
Transmission Control Module
(TCM) -J217-
Ignition
switched off smaller than
1
- Check wiring per wiring
diagram.

34 + battery
ground (GND)
smaller than
1

8
52 + 53 Voltage supply to solenoid
valves
Ignition
switched off smaller than
1,5
- Check wiring per wiring
diagram.
- Perform test step 1
- Check wiring between TCM
and 16-pin connector page 01
-302
.
- Perform test step 1
- Check harness in
transmission according to
wiring diagram
1) Pin 28 at the control module is vacant for vehicles with 10-pin connector of multi-function switch -F125-.
Pa
ge 20 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-287

Resistance measurement: switch multimeter to 200 measuring range
Test
step VAG
1598/20
sockets Test of
Test
conditions
- Additional stepsSpecified
value Corrective action
9 52 + 30 Solenoid Valve
1 -N88- Ignition
switched off 25 to 35

- Check 16-pin connector to transmission for
contact corrosion

30 + 34
infinity
1)
- Perform test step 8
10 52 + 33 Solenoid Valve
2 -N89-
Ignition
switched off 25 to 35

- Check wiring connection from 88-pin connector to
8-pin connector page 01
-302


33 + 34
infinity
1)
- Check wiring harness in transmission according
to wiring diagram, replace if necessary.
11 52 + 32 Solenoid Valve
3 -N90-
Ignition
switched off 25 to 35

Repair Manual, 5 Spd. Automatic Transmission
01V, Repair Group 38
- Remove and install valve body

32 + 34
infinity
1)
12 52 + 5 Solenoid Valve
4 -N91-
Ignition
switched off 6 to 8

5 + 34
infinity
Pa
ge 21 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16