wheel torque AUDI A6 2000 C5 / 2.G Changing Clutch 5Speed Manual Gearbox

Servicing clutch Servicing clutch Special tools and workshop equipment
required
◆ 3067 Counterhold
◆ 3176 Centring
mandrel
◆ V.A.G 1331 Torque
wrench
Notes:
◆ Observe the general
repair instructions
=>Page 00-17.
◆ If the clutch has burnt out, thoroughly clean
the bell housing,
flywheel and parts of
the engine facing the
gearbox in order to
prevent odours.
◆ Two different
versions of the dual-
mass flywheels may
be fitted. Distinguishing feature of the weight-
optimised dual-mass
flywheel => Fig.2.
◆ To prevent damage
to the weight-
optimised dual-mass
flywheel when
removing it, the
removal instructions
must be observed=>
Fig.2.
◆ Replace clutch plates and pressure plates
with damaged or
loose rivets.
◆ Pressure plates with
severely bent or
broken spring
connections must be
replaced => Fig.4
◆ Replace clutch plates and pressure plates
with damaged or
loose rivets.
◆ Select the correct
clutch plate and
pressure plate
according to engine
code:
=> Parts List
◆ Clean input shaft
splines and (in the
case of used clutch Page 1 of 75-Speed Manual Gearbox 01A 4WD4.3.2014vw-wi://rl/A.en-GB.4B-S-S01AA.wi::21141315.xml?xsl=2

installing:
=> Relevant
engine
workshop
manual,
Mechanical
components;
Repair group
13 → Fig.1 Centring clutch plate and removing and installing thrust plate
‒ Loosen and tighten bolts gradually in
several stages working diagonally.
Tightening torque: 25 Nm.
‒ Reverse position of retainer 3067 when
removing.
‒ Installation position of clutch plate: spring
pack (coil springs) or marking
"Getriebeseite" towards pressure plate and
gearbox.
‒ Clutch lining and contact surface of
pressure plate must make full contact with
flywheel before securing bolts are inserted. ‒ Use mandrel 3176 to centre clutch plate.
→ Fig.2 Weight-optimised dual-mass flywheel
Identification: Cheese-head bolts -B- are
countersunk in the flywheel -A-. Page 5 of 75-Speed Manual Gearbox 01A 4WD4.3.2014vw-wi://rl/A.en-GB.4B-S-S01AA.wi::21141315.xml?xsl=2