warning AUDI A8 1996 D2 / 1.G 01V Transmission Center Differential Service Workshop Manual

AUDI A8 1996 D2 / 1.G 01V Transmission Center Differential Service Workshop Manual A8 1996 D2 / 1.G AUDI AUDI https://www.carmanualsonline.info/img/6/1190/w960_1190-0.png AUDI A8 1996 D2 / 1.G 01V Transmission Center Differential Service Workshop Manual

Page 2 of 29

AUDI A8 1996 D2 / 1.G 01V Transmission Center Differential Service Workshop Manual 39-46
 
  
WARNING! 
Do not run engine with the center differential 
removed or without gear oil and do not tow 
vehicle. 
Notes: 
The parts listed in the following illustration can be 
removed with t

Page 4 of 29

AUDI A8 1996 D2 / 1.G 01V Transmission Center Differential Service Workshop Manual 39-48
 
  
9 - 
Spur gear 1 
For rear gear setIf damaged, only replace together with spur 
gear 2 -Item 17 - Always replace To remove and install, pull out of center 
differential housing toward rear

Page 13 of 29

AUDI A8 1996 D2 / 1.G 01V Transmission Center Differential Service Workshop Manual 39-57
 
    
-  Unbolt driveshaft -1- from transmission and let rest on heat shield -2- 
 page 39
-79
 , Driveshaft, removing and installing. 
-  Secure driveshaft using wire (arrow) at bracket -3- of

Page 24 of 29

AUDI A8 1996 D2 / 1.G 01V Transmission Center Differential Service Workshop Manual 39-68
      
WARNING! 
     
Do not reinstall spur gears that have fallen to 
the ground. The transmission must be 
replaced in this case. 
     
-  Drive out seal using drift. 
     
Installing

Page 28 of 29

AUDI A8 1996 D2 / 1.G 01V Transmission Center Differential Service Workshop Manual 39-71
 
    
WARNING! 
Wear protective gloves!  -  Spread extractor -B- into upper lip of needle bearing -1- and secure 
extractor at nut. 
-  Install retainer -A- on extractor -B- as illustrated. 
-

Page 29 of 29

AUDI A8 1996 D2 / 1.G 01V Transmission Center Differential Service Workshop Manual 39-72
      
Installing  
      Installation is the reverse of removal. Also carry 
out the following procedure.  
     
-  Check needle bearing seat in transfer housing 
for damage, rework if necessa