engine AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owner's Manual

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owner's Manual A8 1996 D2 / 1.G AUDI AUDI https://www.carmanualsonline.info/img/6/1207/w960_1207-0.png AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owner's Manual

Page 25 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-95
      
-  Only perform vehicle alignment if necessary.
     
       Repair Manual, Suspension, Wheels, 
Steering, Repair Group 44; Vehicle alignment
   
     
-  Install transmission supports at

Page 26 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-96
       For vehicles with Torx bolts:  
    
 Repair Manual, Electrical Equipment, Repair Group 27; Starter, 
removing and installing
    -  Bolt 3 torque converter bolts to drive plate using res

Page 29 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-99
      
Removing and installing for 2.7 Liter 5V turbo 
engine:  
    
-  Remove bolts (arrows) and remove engine covers -A- and -B-.
-  Remove cover above air filter.
    
-  Remove coolant expa

Page 31 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-101
 
    
-  Disconnect connector -1- for oxygen sensor (right side) at bulkhead.
-  Expose wire with connector to oxygen sensor.
    
-  Disconnect connectors -2- of left oxygen sensor at bulkhea

Page 32 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-102
      
-  Assemble both 10-222A/3 engine support 
adapters for front and rear spindles on support 
bar. 
    
-  Set 10-222A engine support bridge onto the fender mounting flanges 
using 10-222

Page 33 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-103
 
    
 Repair Manual, Suspension, Wheels, Steering, Repair Group 40
    -  Remove left and right heat shields for drive axles (arrows).
-  Disconnect drive axles from transmission drive flange

Page 36 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-106
      
-  Loosen left and right transmission mounts from 
subframe  page 37
-125
 
    
Note:  
When installing, make sure that locating sleeves -2- engage again.  -  Mark installation position

Page 37 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-107
 
    
Automatic Transmission 01V with All Wheel Drive is supported at the 
same positions as the Front Wheel Drive version. 
WARNING! 
When working on the subframe, all precautions and notes w

Page 38 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-108
 
    
-  Mark installation position of protector shield and hose clamp -1- at left 
and right exhaust pipe using a waterproof marker, to quickly find the 
correct installation position when re

Page 40 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-110
      
Removing 3 torque converter bolts  
    
If opening -A- is not present, perform the following two work steps to be 
able to remove the 3 bolts of the torque converter.  
 Repair Manual,
Page:   < prev 1-10 11-20 21-30 31-40 41-50 next >