check oil AUDI A8 1997 D2 / 1.G 01V Transmission Drive Pinion And Ring Gear Adjust Workshop Manual

39-186

Ring gear, adjusting

(Adjusting differential)
Procedures after which the ring gear must be
adjusted Adjustment overview page 39
-
170
.

Notes:

Tapered roller bearings for differential are low-
friction bearings. Therefore friction torque can
only be used for check measurement in a
limited way. A correct adjustment is only
possible by determining the total thickness
"Sges".
Do not grease new tapered roller bearings
additionally for friction torque measurement.
The bearings are already greased with a
special oil from the factory.

Total shim thickness "Stotal" for adjustment
shims "S1" + "S2", determining
(adjust preload of tapered roller bearing for
differential)
Drive pinion removed or ring gear detached
from differential housing
Pa
ge 24 of 38 Drive
pinion and rin
g gear, ad
justin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.15

39-191

Measuring friction torque (check
measurement)

Drive pinion removed
Differential installed with shims "S1*" and
"S2*"

Friction torque specified values: 1) have been run in at least 50 km
Notes: - Position torque gauge 0 to 600 Ncm -A- on differential.
- Read friction torque.New bearings
Run-in bearings
1)
150 to 300 Ncm 30 to 60 Ncm
Tapered roller bearings for differential are low-friction bearings.
Therefore friction torque can only be used for check measurement in a
limited way. A correct adjustment is only possible by determining the
total thickness "Sges". Do not grease new tapered roller bearings additionally for friction
torque measurement. The bearings are already greased with a special
oil from the factory. For a new adjustment of the gear set, the drive pinion adjustment
Pa
ge 30 of 38 Drive
pinion and rin
g gear, ad
justin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.15