engine AUDI A8 2000 D2 / 1.G 01V Transmission Oil Seal Flange Shaft Workshop Manual

39-114


Removing
Note:
The exhaust system must only be removed if left seal is replaced.
Repair Manual, Engine Mechanical, Repair Group 26; removing and
installing exhaust system
Repair Manual, Suspension, Wheels, Steering, Repair Group 42; Component allocation of rear axle (All Wheel Drive (AWD) vehicles); Drive axle, removing and installing

VAG1383A engine/transmission hoistRear final drive installed
- Observe general repair notes page 00
-27
.
- Remove rear part of exhaust system behind clamping sleeve(s):- Remove left or right drive axles from rear final drive and lay to side:

- Remove drive flange. To loosen securing bolt, thread 2 bolts into drive
flange and counter hold using tire iron.
Pa
ge 2 of 4 Oil seals for flan
ge shafts, re
placin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.9

39-116


Repair Manual, Suspension, Wheels, Steering, Repair Group 42;
Component allocation of rear axle (All Wheel Drive (AWD) vehicles); Drive axle, removing and installing

Repair Manual, Engine Mechanical, Repair Group 26; removing and
installing exhaust system
Tightening torque - Using 2062 driver, press in seal for right drive flange to stop without
bending seal.
- Install driveshaft.
- Install exhaust system free of stress:- Top-up and check gear oil in rear final drive page 39
-94
.
Component
Nm
Drive flange to final drive 25
Pa
ge 4 of 4 Oil seals for flan
ge shafts, re
placin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.9