oil pressure AUDI A8 2000 D2 / 1.G AHA ATQ Engines Lubrication System Components Workshop Manual

Checking oil level page 17
-32
.

Notes:

Always replace seals and gaskets.
Viscosity classes and oil specifications page 17
-31
.

Checking oil pressure page 17
-30
.
Pa
ge 2 of 34 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.17.1

17-8


Fig. 1 Removing and installing oil pump
1 - Oil pump
Cannot be disassembled (oil pressure release valve is integrated
with oil pump)
2 - Pressure regulation valve
Tightening torque: 40 Nm (30 ft lb)
3 - Tightening torque: 20 Nm (15 ft lb)
4 - Tightening torque: 25 Nm (18 ft lb)
5 - Chain sprocket
When installing, make sure shaft fits chain sprocket
Pa
ge 12 of 34 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.17.1

17-12


- Set 10-222A engine support bridge together with 10-222A/3 engine
support adapter on fender mounting edges.
- Attach 2024A engine sling to mounting eyes at front and rear of engine.
- Using 10-222A engine support bridge spindle, lift up engine as far as
possible.

- Cut tie wraps (arrows), open bracket for starter wiring and remove
wiring.
- Remove torque support at front of engine.
- Unbolt coolant line at front of engine from oil pan.
- Disconnect harness connector from oil pressure switch on left-side of
oil pan.
- Disconnect coolant lines from oil cooler underneath oil filter.
Pa
ge 16 of 34 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.17.1