trip computer AUDI A8 2014 Owners Manual

24 Instruments and warning/indicator lights
Driver information
display
Overview
Fig. 4 Driver informat ion system in the instrument
cluster
Fig. S D isplay: example of th e informat ion line
The driver information system contains infor­
mation @ that is displayed on tabs @
c:;, fig. 4. The following content is possible de­
pending on vehicle equipment:
@
®
Tab Content
1 Vehicle functions :
On-board computer c::> page 25
Digital speedometer
Cruise control*
c:;, page 91
Adaptive cruise control and braking
guard*
c:;, page 94
Audi lane assist* c::> page 103
Display darkened
2 Indicator lights and messages
Warning when a door, the hood or the rear lid is not closed
c::>page29
Service interval display c::>page 28
Speed warning system ¢page 91
@ ®
Tab Content
3
Night vision assistant* c:;, page 113
4 Audio/video
s Telephone*
6 Navigation*
T he second and th ird tabs are only vis ible if at
least one indicator light or message is shown
or if that system is sw itched on.
The status line © is located in the bottom
part of the display
c::> fig. 4. It displays the ex­
terior temperature , time, selector lever posi­
t ion, trip odometer and odometer.
For some vehicle functions, you can access the
trip information from the temporary memory
c::> page 25 in the line (D c::> fig. 5.
_& WARNING ,___ -
- Never rely exclusively on the outside
temperature display to determine if a
road surface is icy or not. Keep in mind
that road surfaces, especially bridges
and overpasses, could be ice covered and
slippery even at an outside temperature
above 41 °F
(+5 °() .
- Always remember, even if the "snow­
flake" symbol (ice warning) does not ap­
pear in the d isplay, black ice could be on
the road .
- Always reduce your speed and drive with special care in cold weather cond itions
when the chance of encountering icy
road surfaces increases.
(D Tips
-At temperatures below 14 °F (+ 5 °C) a
snowf lake symbol appears ahead of the
temperature display. It is intended to re­
m ind the driver to pay special attention
to
ice on the road c::> ,&. If the vehicle is
stationary, or if you are driving at a very
low speed, the temperature shown in the
display might be slightly higher than the
actual outs ide temperature. This is .,.

Instrument s and warning /indicator lights 25
caused by the heat being radiated from
the engine.
- You can se lect the un its used fo r temper­
atu re, speed and othe r measurements in
the MML
- Fo r informa tion on the a udio/video and
navigation* functions, refer to the se pa­
r ate MMI ow ner's manual.
Operation
The driver information system is operated us­
ing the buttons on the multifunction steering
wheel.
gi g ~------,i
~
F ig . 6 Mult ifu nct io n stee ring wheel: operat ing t he d riv­
er informat ion system
Fi g. 7 Driver informat ion system: ope ning the ve hicle
funct io ns m en u
Operating concept
.. Switch the ign ition on.
.. To sw itch between t he tabs, press th e rocker
switch @to the left or right
c> fig . 6 .
.. To access additional informat ion be low or
above, rotat e the thumbwheel @ dow n or
up.
.. To confi rm a selection, press t he thumb­
whee l@ .
Accessing Vehicle functions
.. Sele ct the first t ab with the ro cker swit ch
@.
.. Press the b utton [jg] _ The Vehicle funct ions
menu appears c> fig . 7.
.. To select a menu item , tu rn and press t he
thumbwhee l@ .
Resetting values to ze ro
.. Select the on-board computer / Efficiency
program
menu item in the Vehicle func­
tions
men u.
.. Yo u can now select between t he long-term
memory and s hort-term memory .
.. To reset the values in a memory, p ress a nd
hold t he thumbwheel @ for one second .
The last function selected d isp lays when you
switc h the ig nition on.
On-board computer
You can ca ll up the followin g in formation in
the on -board computer:
- Date
- Dr iving t ime (h) from the shor t-te rm memo-
ry
- Average consumption in MPG ( l/100 km)
from the short-te rm memory
- Average speed i n mph ( km/h) from the
short-te rm memory
- Distance driven in miles (km) from the
short-te rm memory
- Cur ren t fue l consumption in MPG ( l/100
km)
- Short-term memory overview
- Long-term memory overview
T he short-te rm memory collects driv ing infor­
mation from the time the ign ition is switc hed
on until it is switched off. If you continue driv­
ing within two ho urs after switch ing the ig ni­
tion off, the new values are included when cal­
cu lating the c urrent trip information .
Un like the short -term memory, the long-term
memory is not erased automatically. You can
select the time period for evaluating t rip in­
format ion yourse lf .

26 Instruments and warning/indicator lights
For some vehicle functions, you can access the
trip information from the t emporary memory
in the line
(D ~ page 24, fig. 5.
The current fuel consumpt ion can be dis­
p layed using a bar~
page 2 7, fig. 10. The
average consumption (mpg) stored in the
short-term memory is also d isplayed. Electri ­
cal energy can be stored in the battery when
t he vehicle is coasting or driving downhill (re­
cupe rat ion) . The bar will move toward D.
Efficiency program*
The efficiency program can help you to use
less fuel. It evaluates driving information in
reference to fuel consumption and shows oth­
er equipment influencing consumption as well
as shift recommendations .
c:> page 26. Fuel
economy messages ~
page 26 provide tips
for eff icient driving . The eff ic iency program
uses distance and consumption data from trip
compute r
1.
To display the efficiency program, call up Ve­
hicle functions and select the menu option
Efficiency program .
If the data are deleted in
the efficiency program, those values are also
reset in trip computer.
@ Tips
-All stored va lues w ill be lost if the veh i­
cle battery is disconnected .
- Fuel consumptions (ave rage and cur­
r ent), range and speed are displayed in
metric units on Canadian models.
Other equipment
Applies to vehicles: with efficiency program
Fig. 8 Tri p comp uter: othe r equ ipment
Requirement: The efficiency program must be
displayed
c:> page 26 .
,. Tur n the thumbwheel unti l the other equip-
ment appears in the display.
Other equipment th at is currently affecting
fuel consumpt ion is listed in the effic iency
program. The display shows up to three other
items of equipment @. T he equipment using
the most fuel is listed first. If more than three
items using fuel are switched on, the equip­
ment that is currently using the most fuel is
displayed .
A scale @also shows the current tota l con­
sumption of all other equipment.
Fuel economy messages
Applies to vehicles: with efficiency program
Fig. 9 Display : example of a fuel econo my m essage
Fuel economy messages are displayed when
f uel consumption is increased by certa in con­
ditions. If you follow these fue l economy mes­
sages, you can reduce your vehicle's consump­
tion of fuel. The messages appear automati ­
cally and are only displayed in the efficiency
program. The fuel economy messages turn
off
automatically after a certain per iod of time .
.,. To turn an economy message
off immediate­
ly after it appears, press any button on the
multifunction steering wheel.
(D Tips
- Once you have turned a fuel economy message
off , it will only appear again af-
ter you turn the ign ition on again . .,,.

Instrument s and warning /indicator lights 2 7
-The fuel economy messages are not dis­
played in every instance, but rathe r in in­
terva ls
over a period o f time.
Cylinder on demand System
App lies to vehicles: w ith 4 .0 TFS ! engi ne
F ig. 10 Inst rume nt cluster: fuel consumption
To save fu el, the eng ine automat ic all y t urns
four cylinders o n or
off, de pending on the
amo unt of power needed. This action is not
fe lt by the passengers.
Displaying cylinder mode
Requirement: t he on-bo ard computer is di s­
pl ayed~
page 25.
~ Turn the thumbwhee l until the current fue l
c o nsu mption display is shown in the inst ru­
me nt cl uster.
If the green ba r is d ispl ayed,
yo u a re driving in 4-cylin der m ode.
Basic requirements for 4 -cylinder mode
4-cy linder drive mode is used automatically if
certain basic requir emen ts are fulfi lled. These
in clude:
- A low powe r output requi reme nt.
- Driving in third gear or higher.
- Engine speed between 960 and 3,500 RP M.
-A warm engine .
Odometer
Fig. 11 Instrument cluste r Odo meter a nd reset button
The odometer shows you how many m iles
(k ilometers) you have driven. You can switch
the d isplay from miles to kilomete rs and v ice
versa via t he MMI.
Upper odometer
The trip odometer shows the distance driven
since it was last reset.
It can be used to meas­
ure s ho rt d istances . The last digit indicates
1/10 of a mile (100 meters) .
You can reset the trip odometer to zero by
pressing the Reset button~-
Lower odometer
The lower odomete r shows the tota l num ber
of m iles (kilometers) dr iven.
Malfunction message
I f th ere is a malfunc tion i n the in strumen t
cl us ter,
DEF will ap pear i n the trip odometer
display a rea. Conta ct your author ized Audi
dealer to have the problem corrected.
Time and date display
Fig . 1 2 Ce nter console: ana log clock