Wheels
Tire rotation
Rotating the tires regularly is rec-
ommended to ensure the tires
wear evenly. To rotate the tires,
install the tires from the rear axle
on the front axle and vice versa.
This will allow the tires to have
approximately the same length of
service life.
For unidirectional tires, make sure
the tires are installed according to
the running direction indicated on
the tire sidewall > page 291.
Hidden damage
Damage to tires and rims can of-
ten occur in locations that are hid-
den. Unusual vibrations in the ve-
hicle or pulling to one side may
indicate that there is tire damage.
Reduce your speed immediately.
Check the tires for damage. If no
damage is visible from the out-
side, drive slowly and carefully to
the nearest authorized Audi deal-
er or authorized Audi Service Fa-
cility to have the vehicle inspect-
ed.
Z\ WARNING
Tread that has worn too low or
uneven tread depths on the
tires can reduce driving safety.
266
This can increase the risk of an
accident because it has a nega-
tive effect on handling, driving
through curves, and braking,
and because it increases the
risk of hydroplaning when driv-
ing through deep puddles.
AT -m as T
B41L-1383
Fig. 167 Driver's side B-pillar: tire pres-
sure label
B8K-1151 Pee
‘SEATING CAPACITY TOTAL FRONT R NOMBRE DE ‘OTAL /ANT ARRIERE
eed 9 oF pmb , a;
COLD TIRE PRESSURE
PRESSION DES PNEUS A FROID
a KPA, HM PSI
a KPA, Mi PSI
Ga KPA, MM PSI
TIRE SIZE
PNEU _| DIMENSIONS
FRONT
AVANT
REAR
i_|
ARRERE |
‘SPARE a
DE SECOURS
Fig. 168 Tire pressure label
The correct tire pressure for tires
installed at the factory is listed on
a label. The label is located on the
B-pillar > fig. 167, > fig. 168.
Use the tire pressure specified for
a normal vehicle load when the
vehicle is partially loaded > table »
