ECU AUDI S4 1997 B5 / 1.G 01E Transmission Final Drive Flange Housing Remove And Install Workshop Manual

39-83

- Remove heat shield above driveshaft.

- Remove heat shield next to rear final drive.

- Check whether there is a factory marking (paint spot) on driveshaft. If
not, mark position of driveshaft flange -A- in relation to rear final drive
(arrow -B-) with paint.
- Unscrew bolts from driveshaft flange.

Note:
If it is not possible to push the driveshaft up and off the flange, lower the
final drive before tying up the driveshaft. When lowering the final drive,
prevent the driveshaft from dropping down, and do not bend the center
joint further than the maximum angle permitted Page 39
-64
, Notes. - Secure driveshaft to parking brake cable bracket with wire.
Pa
ge 3 of 7 Drive flan
ge housin
g, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.11