check oil AUDI S4 1997 B5 / 1.G 01E Transmission Final Drive Pinion And Ring Gear Adjustment Workshop Manual

39-161

- Remove drive pinion and outer race of large
tapered roller bearing and install together with
measured shims "S3" and spacer sleeve from
Page 39
-139
.
Install inner race of small tapered roller bearing
and tighten nut for drive pinion until specified
friction torque is obtained
Fig. 11 , Page 39
-144
.

Note:

Do not additionally oil new tapered roller
bearings for friction torque measurement. The
bearings have already been treated with a
special oil by the manufacturer.
Increase tightening torque slowly and check
friction torque at regular intervals, if the
specified friction torque is exceeded, the spacer
sleeve must be replaced and the adjustment
repeated. A spacer sleeve which has been
compressed too much cannot be reused.

- Set to following friction torques:

New bearings
Used bearings
1)
200-250 Ncm 30-60 Ncm
Pa
ge 20 of 38 Drive
pinion and rin
g gear, ad
justin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.19

39-163

Ring gear, adjusting

(Adjusting differential)
Repairs after which the ring gear has to be
adjusted Page 39
-150
, Adjustment overview

Note:

Differential tapered roller bearings are low
friction bearings. Therefore the friction torque
only has a limited use as a check. Correct
adjustment is only possible by determining the
total shim thickness "S
total
."

Do not additionally oil new tapered roller
bearings for friction torque measurement. The
bearings have already been treated with a
special oil by the manufacturer.

Determining total shim thickness "S
total
" for
shims "S1" + "S2"
(Setting preload of tapered roller bearing for
differential)

Drive pinion removed or ring gear dismantled
from differential housing

- Pull out drive flange oil seal with lever.
Pa
ge 23 of 38 Drive
pinion and rin
g gear, ad
justin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.19

39-168

Measuring friction torque (check)

Drive pinion removed
Differential fitted with shims "S1*" and "S2*"

Friction torque specifications: 1) run at least 50 km (30 miles)
Note: - Fit torque gauge 0-600 Ncm -A- onto differential.
- Read friction torque.New bearings
Used bearings
1)
150-300 Ncm 30-60 Ncm
Differential tapered roller bearings are low friction bearings. Therefore
the friction torque only has a limited use as a check. Correct
adjustment is only possible by determining the total shim thickness
"S
total
."
Do not additionally oil new tapered roller bearings for friction torque
measurement. The bearings have already been treated with a special
oil by the manufacturer. If the final drive set (drive pinion and ring gear) is being re-adjusted,
the adjustment of the drive pinion should be performed now, and the
Pa
ge 30 of 38 Drive
pinion and rin
g gear, ad
justin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.19