wiring AUDI S8 2015 Owners Manual

158 Airbag sys te m
- Never put the forward-facing child re­
straint up aga inst or very near the instru­
ment panel.
- Always move the passenger seat into its
rearmost position in the seat's fore and
aft adjustment range, as far away from
the a irbag as poss ible, before installing
the forward-facing child restraint. The backrest must be adjusted to an upr ight
posit io n.
- Make sure that the
PASSENGER AIR BAG
OFF
light comes on and stays on all the
t ime whenever the ignition is switched
on.
Advanced Airbag System components
The front passenger seat in your vehicle has a
lot of very important parts of the Advanced
Airbag System in it. These parts include the
weight-sensing mat, sensors, wiring, brack­
ets, and more. The function of the system in
the front passenger seat is checked by the
electronic control un it when the ign it ion is on .
The control unit mon itors the Advanced Air­
bag System and turns the airbag indicator
l ight on whe n a malfunction in the system
components is de tected. The function of the
ai rbag indicator light is described in greater
detai l be low . Because the front passenger
seat contains important parts of the Ad­
vanced A irbag System, you must take care to
prevent it from be ing damaged. Damage to
the seat may prevent the Advanced Airbag for
the front passenger seat from doing its job in
a crash .
The front Advanced Airb ag System
con sis ts of the following:
- Crash sensors in the front of the veh icle that
measure veh icle acceleration/deceleration
to provide information to the Advanced Air­
bag System about the seve rity of the c rash.
- An electron ic co ntro l unit, w ith integ rated
crash sensors for fron t and side impacts.
T he contro l unit "dec ides " whether to fire
the front airbags based on the information received from the crash sensors . The contro l unit also "decides" whether the sa
fety be lt
pretensioners shou ld be activated.
- An Advanced Airbag with gas generato r and
contro l valve for the driver inside the steer­
ing wheel h ub.
- An Advanced Airbag with gas gene rator and
contro l valve inside the instrument panel for
the front passenger .
- A weight -sensing mat under the upho lstery
padding of the front passenger seat cushion
that measures the total weight on the seat.
The informat ion registered is sent continu­
ously to the electronic control unit to regu­ late deployment of the front Advanced Air­
bag on the passenger side.
- An airbag monitoring system and indicator
light in the instrument cluster~
page 161 .
-A sensor in each front seat registers the dis­
tance betwee n the respective seat a nd the
steer ing whee l o r inst rument panel. The in­
formation registered is sent cont inuous ly to
t he ele ctron ic contro l uni t to regula te de­
p loyment of the front Adva nced A irbags .
- The
PASSENGER AIR BAG OFF light comes
on and st ays on in the center of the instr u­
ment p anel
~page 162, fig. 168 and t ells
you when the front Advanced Airbag on the
passenger side has been turned off .
- A sensor below the safety be lt latch for the
front seat passenger to measure the tension
on t he safety be lt . The tension on the safety
be lt and the weight registered by the
weight-sensing mat he lp the control unit
"decide" whether the front airbag for the
front passenger seat should be turned off or not
~ page 153, Child restraints on the
front seat -some important things to
know.
- A sensor in the safety belt latch fo r the driv­
er and fo r the fro nt seat passenger that
senses whether that safety bel t is latched or
no t and transmi ts this information to t he
electronic control unit.
A WARNING ~ -
Damage to the front passenger seat can
prevent the front airbag from work ing
properly.

210 Trailer towing
Trailer towing
Driving with a trailer
General information
Your Audi was designed primarily for passen­
ger transportation .
If you plan to tow a trai ler, please remember
that the additional load will affect durability,
economy and performance .
Trailer towing not only places more stress on the vehicle, it also calls for more concentra­
tion from the driver.
For this reason, always follow the operating
and driving instructions provided and use
common sense.
(D Note
If you are going to tow a trai ler, you must
activate the trailer operation mode
i::> page 210, Operating instructions .
Technical requirements
Trailer hitch
Use a weight-carrying hitch conforming to the
gross trailer weight. The hitch must be suita­ ble for your vehicle and trailer and must be
mounted securely on the veh icle 's chassis at a
technically sound location . Use only a trailer
hitch with a removable ball mount. A lways
check with the trai le r hitch manufacturer to
make sure that you are using the cor rect
hitch.
Do not use a bumper hitch.
The hitch must be installed in such a way that
it does not interfere with the impact-absorb­
ing bumper system. No modifications should
be made to the vehicle exhaust and brake sys­
tems. From time to time, check that all hitch
mounting bo lts remain securely fastened.
When you are not towing a trailer, remove the
trailer hitch ball mount. This prevents the
h itch from causing damage should your veh i­
cle be struck from behind~ &.
Trailer brakes
If your trailer is equipped with a brak ing sys­
tem, check to be sure that it conforms to all
regulations.
T he trailer hydraulic brake system must not be
direc tly connected to the vehicle's hydraulic
brake system .
Safety chains
Always use safety chains between your veh icle
and the tra iler.
Trailer lights
Trailer lights must meet all regulations. Be
sure to check with your Audi dealer for correct
wiring, switches and relays.
Mirrors
If you are unable to see the traffic behind you
using the regular outside mirrors, then you
must install extended mirrors. It is important
that you
always have clear v is ion to the rear .
A WARNING ,~ -
After removing the trailer hitch, do not
store it in your vehicl e. In case of sudden
braking, the hitch could fly forward and in­
jure you or your passengers.
Operating instructions
Fig. 189 MMI display : tow ing mode on
Maximum traile r weight
A trai ler for your vehicle is limited to a typical
class 1 or class 2 trailer. .,.