torque BMW 3 SERIES 2002 E46 TV Function Retrofit Kit Installation Instruction Manual

EN/3

Retrofit kit No. 65 50 0 143 549
Installation Instructions No. 01 29 0 143 558 Issue date: 03.2002
Important information

The retrofit kit is for use within the BMW dealership organisation only.
Subject to technical modifications.

Target group

The target group for these installation instructions is specialist personnel trained on BMW cars with the
appropriate specialist knowledge.
All work must be completed using the latest BMW repair manuals, circuit diagrams, servicing manuals and
work instructions in a rational order using the prescribed tools (special tools) and observing current health and
safety regulations.

Installation information

The installation of the aerial is shown on the left-hand side of the bumper, proceed in the same way on the
right-hand side of the bumper.
Refer to the instructions for use of Sikaflex-221 (Saloon only).
Observe the tightening torque values for screw connections. The required tightening torque values are set
out in the part information system (TIS).
Ensure that the cables/lines are not kinked or damaged as you install them in the car.
The installed cables are to be secured with cable ties.
If the specified PIN chambers are occupied, bridges, double crimps or twin-lead terminals must be used.
After the installation work the retrofit TV function must be coded using DIS or MoDiC via the

Retrofit

path.

Information on operation

The TV function is only active when the car is at a standstill.

Tools required

DIS or MoDiC
Removal clips (65 5 400)

Special material required (Saloon only)

Sikaflex-221 (81 22 9 407 533)