trunk release BMW 318I CONVERTIBLE 1996 E36 Convertible Tops Manual

E36 AUTOMATIC ELECTRO MECHANICAL (EM)
CONVERTIBLE TOPS
The Automatic EM convertible top was introduced as a“Semi”Automatic in the 1994
model year. The top was upgraded to a fully automatic top in 1997. Except for a few addi-
tional components and an additional function on the fully automatic version, both systems
function the same. For this reason the systems are described simultaneously and high-
lighted as required where differences occur.
FEATURES
The top is designed as a self tensioning, electric mechanical power operated folding top.
The main features include:
BOTH VERSIONS:
• Electrical interlock of the trunk lid when the top storage cover is unlocked or open.
 Automatic partial lowering of the four side windows when lowering or raising the top.
 Automatic full raising of all four windows once top is stored in the storage compartment.
 Fully diagnosible EM Top Control Module.
 A textile, crease free interior liner clipped to the top frame.
 Emergency release handle inside the passenger compartment, for manually raising the
top with an electrical failure.
 A removable (zipper) green tinted plastic rear window.
 Soft top material of 3-ply with 40% cotton fabric lining and 100% Arcyl outer skin.
SEMI AUTO ONLY:
 A centrally located turn lock fastener on the for-
ward edge of the top for locking and unlocking
the top to the windshield frame.
Convertible Tops - 4

OPERATION
The following prerequisites must be met for the top to function:
Trunk Lid Closed- Electrical interlock of the trunk and top. Due to the design of the top
storage cover and trunk lid, damage to the cover or lid would occur if both were open at
the same time.
Ignition key switched on KL R, (preferably engine running to prevent unnecessary bat-
tery drain)
Vehicle stopped(speed “A” signal <3 MPH)
Roll over bars retracted (if equipped) - bars interfere with the top operation as it is low-
ering into the storage compartment.
LOWERING THE TOP
•SEMI AUTOMATIC TOP ONLY - Unlock the top with the turn lock fastener and push
the top over the tension point.S4 must close for the top to operate. Press and hold
the top switch.Go to “TENSION BAR RAISED” on next page.
•FULLY AUTOMATIC TOP ONLY -Press and hold the top switch. All Side windows
lower automatically regardless of their position, by a signal from the top module to the
General Module (ZKE IV).
1. The top lock motor is powered in the unlock direction.
2. The left and right side locks are mechanically released via the drive cables.
3. Microswitch S7 opens indicating the top is unlatched from the windshield frame.
4. Once the locks are completely released, the top lock motor continues to run lifting
the front bow above the tension point via the tension rods.
5. As the front bow passes the tension point, micro switch S8 closes. The top lock
motor switches off and the top motor is switched ON.
Convertible Tops - 12

Convertible Tops - 13
TENSION BAR RAISED
At the same time the windows are lowering, the top drive motor is switched on and the ten-
sion bar is raised to a vertical position. The drive lever of the top linkage rotates counter
clockwise to push the tension bar to a raised position.
The control module recognizes the raising of the tension bar by the closed contacts of
micro switch S1 in the motor assembly.
When the tension bar has raised to the full vertical position micro switch S2 closes and the
motor is switched off.
STORAGE COVER OPENED
The top storage cover motor is switched on and turns counter-clockwise. This action
releases the locks of the cover via the bowden cables. The locks are forced out of the
clamps by spring pressure.
The drive linkage continues to push the cover to a raised position. A hall sensor integrat-
ed in the cover motor provides status of the storage lid movement and position to the CVM.
The motor is switched off when it reaches the end of its predetermined travel.
S6 also closes the moment the storage cover is released from its locked position. The sig-
nal is provided the GM to prevent the trunk from opening.