window BMW 325I CONVERTIBLE 1995 E36 Convertible Tops Manual

Convertible Tops - 32
OPERATION
•Top operation is dependent on a stationary vehicle with the brake pedal depressed.
•Unlock the top at the windshield frame and raise past the tension point (microswitch
closes).
•With the windows lowered press the top switch in the console panel.
•The switch provides a ground for the control circuit of either the up or down relay. Power
is provided through the brake light switch circuit when the brake pedal is depressed.
•The activated relay provides operating power to the pump motor which is grounded
through the other relays not active contacts.
•Release switch once top is at end of travel.
•Motor reversal is achieved when the switch is pressed in the opposite direction activat-
ing the other relay.

Convertible Tops - 33
Z3 CONVERTIBLE TOP ADJUSTMENTS
The following adjustments are pos-
sible on Z3 convertible tops. The
Repair Manual section of TIS pro-
vides system component R&R and
adjustment procedures.
 Adjustment Shims for Base
mount to body. Procedures for
R&R top.
Additionally, the Repair Manual has
procedures for:
 Replacing Rear Window
 Replacing Convertible Cover
 Replacing gas spring strut
Not included in the repair manual is the
adjustment procedure for the windshield
latch hooks.
The hook(s) can be adjusted to correct
for inadequate sealing at the windshield
seal or if the hooks are excessively hard
to close.
Loosen the small recessed allen set
screw. Screw the threaded hook in or out
as needed to adjust. Pull the allen screw
completely out and apply a light coating
of loctite on the threads. Tighten set
screw.