towing BMW 328Ci CONVERTIBLE 2000 E46 Owner's Manual

Contents

Owner service procedures
Advanced technology
Technical data

Replacement procedures:

Onboard tool kit152
Windshield wiper blades152
Lamps and bulbs152
Changing a wheel159
Battery162
Fuses165

In case of electrical
malfunction:

Fuel filler door165
Fully automatic convertible
top166

Assistance, giving and
receiving:

Jump-starting168
Towing the vehicle169Adaptive Transmission Control
(ATC)172
Airbags173
Dynamic Stability Control
(DSC)173
Radio reception174
Safety belt tensioner174
Interior rearview mirror with
automatic dimmer175
Rain sensor176
Tire Pressure Control (RDC)177
Self-diagnostics178
Rollover protection system179
Xenon lamp179Engine data182
Dimensions183
Weights184
Capacities185
Electrical system186
Drive belts 186

76n
Automatic transmission with Steptronic
*
In the following situations, the Step-
tronic "thinks" for you in the manual
mode:
>In order to prevent the engine from
overrevving, the transmission shifts
automatically to the next higher gear
just before the RPM cutoff point
>If you do not do anything to inter-
vene, it will automatically downshift
at lower speeds
>In the "Kickdown" mode, the trans-
mission shifts down to the lowest
gear which is possible, depending on
the engine speed
>Depending on the situation – when
driving in adverse winter conditions,
for example – you may also start out
in 2nd or 3rd gear.
Available displays
P R N D SD M1 M2 M3 M4 M5
Electronic transmission control
module
If the indicator lamp comes on,
there is a malfunction in the
transmission system.
46cus005
Bring the vehicle to a stop. Move the
transmission selector lever to "P". Set
the parking brake and turn the engine
off (ignition key to position 0).
Wait a few seconds, then start the
engine.
If the indicator lamp goes out after a
few seconds, normal transmission per-
formance has been restored. You may
continue to drive as usual. If the indica-
tor lamp does not go out, you can put
the selector lever in all positions. How-
ever, the vehicle will now only operate
in 3rd and 4th gear.
If this happens, avoid extreme engine
loads and consult the nearest BMW
center.
Do not work in the engine com-
partment when a drive gear (for-
ward or reverse) is engaged. If you do
this, the vehicle could move.<
For towing and jump-starting the
vehicle, refer to page 168

106n
Ski bag
*
Cargo loading
4 Press the button in the luggage com-
partment (arrow)
5 Use the magnetic retainer to fasten
the cover panel to the back wall.Securing the load
Secure the skis or other objects in
the bag by tightening down the re-
taining strap at the buckle.<
Please ensure that the skis are clean
before loading them into the bag. Take
care to avoid damage from sharp
edges.
46cde065
Stowing cargo If you are transporting a load in your
BMW:
>Load heavy cargo as far forward as
possible – directly behind the back-
rests or the luggage compartment
partition – and as low as possible
>Cover sharp edges and corners.46cde063
To enlarge the luggage compart-
ment when the convertible top is
closed, refer to page 41.
We recommend that you always fold
the convertible top compartment panel
down as soon as you have unloaded
the luggage compartment. That way
you will always be sure of being able to
operate the convertible top at any time.
Reverse the process by flipping the
convertible top compartment panel up
before stowing any cargo in the lug-
gage compartment, which will (also)
prevent any damage to the convertible
top compartment or the cargo.<

112n
To ensure that your vehicle provides
maximum economy throughout a long
service life, we request that you comply
with the following recommendations.
Engine and differentialUp to 1,200 miles (2,000 km):
Drive at varying engine and road
speeds, but do not exceed 4,500 rpm
or 100 mph (160 km/h) during this time.
Obey your local and state maximum
speed limits.
Refrain from using full throttle and avoid
pressing the accelerator beyond the
"kickdown" point.
After you have driven 1,200 miles
(2,000 km), you can gradually increase
the engine and road speed.
You should also comply with these
break-in procedures if the engine or
differential is replaced at a later point.
TiresDue to technical factors associated
with their manufacture, tires do not
achieve their full traction potential until
an initial break-in period has elapsed.
Thus, drive with extra care during the
initial 200 miles (300 km).
Obey your local and state maximum
speed limits.
When the vehicle is operated on
wet or slushy roads, a wedge of
water may form between the tire and
the road surface. This phenomenon is
referred to as aquaplaning, or hydro-
planing, and can lead to partial or com-
plete loss of traction, vehicle control
and braking effectiveness. Reduce your
speed on wet roads. their optimum wear and surface-con-
tact patterns until you have driven
approx. 300 miles (500 km).
To break in the separate parking brake
drums, apply the parking brake lightly
when coasting to a standstill (at a traffic
signal, for instance), provided that traf-
fic conditions allow you to do so.
To avoid corrosion, repeat this proce-
dure from time to time.
The brake lamps do not come on
when the parking brake is applied.
Vacuum for the brake system servo unit
on your BMW is available only when the
engine is running. When you move the
vehicle with the engine shut off – when
towing, for example – substantially
higher levels of pedal force will be
required to brake the vehicle.<
Break-in procedures

Overview
Controls and features
Operation, care
and maintenance
Owner service procedures
Technical data
Index Advanced technology
151n
IndexDataTechnologyRepairsCar careControlsOverview
Replacement procedures:
Onboard tool kit152
Windshield wiper blades152
Lamps and bulbs152
Changing a wheel159
Battery162
Fuses165
In case of electrical
malfunction:
Fuel filler door165
Fully automatic convertible
top166
Assistance, giving and
receiving:
Jump-starting168
Towing the vehicle169
Repairs

169n
IndexDataTechnologyRepairsCar careControlsOverview
Towing the vehicleTow fittingThe screw-in tow fitting is stored in the
onboard tool kit; be sure that it remains
in the vehicle at all times. This fitting
is designed for installation in the tow
sockets located at the front and rear of
the vehicle. It is intended for towing on
paved road surfaces only. This fitting
should not be used to pull a vehicle out
of deep snow, mud, sand, etc.
Always comply with all applicable
towing laws and regulations.Access to tow socketsFront:
Using a screwdriver, press out the cover
panel on the top part of the recess.462de254
Rear:
Using a screwdriver, press out the cover
panel on the top part of the recess.
Screw the tow fittings in com-
pletely and tightly. If you do not,
the threads could be damaged.
Do not tow the vehicle by any compo-
nents of the running gear, or lash them
down in any way. If you do, the compo-
nents could be damaged, leading to
possible accidents.<462de255
Towing with a commercial tow
truck>Do not tow with sling-type equipment
>Use wheel lift or flat bed equipment
>Please comply with applicable state
towing laws.
Never allow passengers to ride in
a towed vehicle for any reason.
Never attach tie-down hooks, chains,
straps, or tow hooks to the tie rods,
control arms, or any other part of the
vehicle suspension. If you do so, severe
damage will occur to these compon-
ents.c46cus031

Everything from A to ZService and Warranty
Information Booklet (US
models)138
Service Interval
Display83, 138
Shiftlock74
Side airbags63
Side lamps91
bulb replacement154
Sitting properly53
using airbags64
Ski bag105
Skid control119
Slippery roads118
Snow chains118, 128
Socket104
Space-saver spare tire159
Spare key32
Spare tire159
Spark plugs186
Speaker103
Speedometer18
Starting70
Starting problems113, 168
Steel wheels128
Steering120
Steering wheel lock70
Steptronic74
Stopping the vehicle71
Storage compartments102
Storing your vehicle147
Stroke182
Summer tires126Switching off the engine71
Symbols4, 163
Synthetic oils134
TTachometer82
Tail lamps155
bulb replacement155
Tank capacity185
Tank cover
unlock in case of electrical
fault165
Technical data182
Technical
modifications6, 148
Telephone
refer to the separate
Owner's Manual
Telephone hookup103
Temperature display
outside temperature85
Temperature gauge
engine coolant83
Temperature layering98
Tether anchorage for child
retsraint66
Third brake lamp157
Tilt alarm37
remote control37
Tilt sensor alarm system43
Tire codes126
Tire damages123Tire inflation
pressure27, 123
Tire Pressure Control
(RDC)89, 177
Tire pressure
monitoring89, 177
Tire pressure, checking27
Tire replacement124, 125
Tire specifications128
Tire tread123
Tools152
Torque182
Tow fittings169
Towing169
Track183
Traction Control System
refer to DSC88
Transmission73
Tread depth, tires123
Trip odometer82
Trunk39
locking separately39
Trunk lid, refer to luggage
compartment lid39
Turn signal indicator23, 77
Turn signals
bulb replacement154
Turning radius183
Two-way radios120
UUniform Tire Quality
Grading124Universal Transmitter100
Used batteries164
VVehicle
battery162, 186
identification137
immobilizer33
painting140
starting70
storage147
weight184
Vehicle care
exterior140
interior141
Vehicle Identification
Number (VIN)137
Ventilation94
draft-free98
Vinyl upholstery, care142
Visors59WWarning lamp "Please fasten
safety belts"21
Warning lamps20
Warning messages84
Warranty and Service Guide
(Canadian models)138
Washer reservoir, filling132
Washing your car139
Water on roadways
deep water113

Owner service procedures
197n
IndexDataTechnologyRepairsCar careControlsOverview
Starting problems71, 113
Switching off the interior
motion sensor43
Switching off the tilt sensor
alarm system43TTail lamps155
bulb replacement155
Tire damage123
Tire rotation159
Tools152
Tow fittings169
Towing169
Turn signal indicator
bulb replacement154UUse of antifreeze,
radiator136WWarning lamps20
Warning messages84
Washer fluid, adding132
Washer nozzles,
adjusting132
Wheel lug wrench159
Working in the engine
compartment129