brake pads BMW 5 SERIES 1989 E34 Workshop Manual

BMW 5 SERIES 1989 E34 Workshop Manual 5 SERIES 1989 E34 BMW BMW https://www.carmanualsonline.info/img/1/2759/w960_2759-0.png BMW 5 SERIES 1989 E34 Workshop Manual

Page 19 of 228

BMW 5 SERIES 1989 E34 Workshop Manual inhibitors wear out, so it must be renewed at
the specified intervals.
Brake and clutch fluid
Warning: Brake fluid can harm
your eyes and damage painted
surfaces, so use extreme caution
when handling

Page 32 of 228

BMW 5 SERIES 1989 E34 Workshop Manual no cause for concern. Make sure that any fluid
noted is from the struts/shocks, and not from
any other source. If leakage is noted, renew
the struts or shock absorbers in axle pairs (or
as a full set)

Page 33 of 228

BMW 5 SERIES 1989 E34 Workshop Manual material is bonded to a metal plate or shoe -
the metal portion is not included in this
measurement. Always renew the pads on
both sides of the vehicle (in axle sets), even if
only one pad of the four

Page 39 of 228

BMW 5 SERIES 1989 E34 Workshop Manual 1 General information
This Part of Chapter 2 is devoted to in-
vehicle engine repair procedures. All
information concerning engine removal and
refitting and engine block and cylinder head
overhaul can

Page 129 of 228

BMW 5 SERIES 1989 E34 Workshop Manual 9
General
Brake fluid type  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . See Chapter 1
Disc brakes
Minimum brake pad thickness  . . . . . . . . . . . . . . .

Page 130 of 228

BMW 5 SERIES 1989 E34 Workshop Manual Torque wrench settingsNm
Front disc brake caliper
Caliper guide (mounting) bolts  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 to 35
Caliper bracket-to-strut housing bolts
3-Series,

Page 131 of 228

BMW 5 SERIES 1989 E34 Workshop Manual and cause the system to malfunction. If
the ABS wiring harness is damaged in any
way, it must be renewed.
Caution: Make sure the ignition is
turned off before unplugging or
re-making any electrical
co

Page 132 of 228

BMW 5 SERIES 1989 E34 Workshop Manual 6Be sure to inspect the wear sensor(s) (left
front wheel only, or left front and right rear
wheel). If they’re OK, transfer them from the
old pads to the new ones; if they’re worn by
abrasion, fit

Page 133 of 228

BMW 5 SERIES 1989 E34 Workshop Manual illustration). Use only low pressure, such as
that produced by a foot pump, to ease the
piston out of its bore.
Warning: Be careful not to place
your fingers between the piston
and the caliper, as the

Page 134 of 228

BMW 5 SERIES 1989 E34 Workshop Manual Inspection
1Loosen the wheel bolts, raise the vehicle
and support it securely on axle stands.
Remove the wheel, and refit three bolts to
hold the disc in place. If the rear brake disc is
being worked
Page:   1-10 11-20 next >