coolant capacity BMW 645Ci COUPE 2004 E63 N62B44 Engine Workshop Manual

Downloaded from www.Manualslib.com manuals search engine Alternator
Due to the high power capacity of 180 A, the alternator is cooled by the engine's cooling
system to enhance heat dissipation. The brushless Bosch alternator is installed in an alu-
minum housing which is mounted to the engine block. The exterior alternator walls are sur-
rounded with circulated engine coolant. The function and design of the alternator is the
same as in the M62, with only minor modifications. The BSD interface (bit-serial data inter-
face) for the ECM is new.
* Further details found in the cooling circuit
section
Regulation
The alternator communicates with the Engine Control Module (ECM) via the BSD (bit-seri-
al data interface). The alternator conveys data such as model and manufacturer. This is
necessary to allow the engine management system to adapt it’s calculations and specific
control to the type of alternator fitted.
17
N62 Engine
42-02-17
Alternator
1. Watertight Housing
2. Rotor
3. Stator
4. Seal
Alternator Coolant Flow
1. Coolant Return Flow
2. Coolant Inlet Flow
42-02-18

Downloaded from www.Manualslib.com manuals search engine 38
N62 Engine
Cooling System
Coolant Circuit - 14 Liter Coolant Capacity
42-02-56
Cooling System (Circuit Flow)
1. Cylinder Head Bank 5-8 12. Radiator
2. Coolant Supply (heater core) 13. Radiator Partition (low temp section)
3. Water valve with electric water pump 14. Temperature Sensor
4. Cylinder Head Gasket 15. Water Pump
5. Coolant Supply Line 16. Radiator Return Flow
6. Cylinder Head Ventilation Lines 17. Radiator Ventilation Line
7. Hole (crankcase venting system) 18. Expansion Tank
8. Transmission oil lines 19. Thermostat
9. Oil/water heater exchanger for automatic transmission 20. Cylinder Head Bank 1-4
10. Thermostat for transmission oil heat exchanger 21. Vehicle Heater
11. Alternator Housing 22. Radiator (High Temperature Area)