oil dipstick BMW MOTORRAD K 1200 GT 2006 Rider's Manual (in English)

Underneath the seat1Seat height adjuster
( 66)
2 Filler neck for engine oil
and oil dipstick ( 103)
( 105)
3 Brake-fluid reservoir, rear
( 108)
4 Helmet holder ( 68)
5 Rider's Manual
6 Toolkit ( 102)
215zGeneral views

Other engine problems
besides a low oil level
can cause the insufficient en-
gine oil pressure warning to
be issued. Continuing to ride
in these cases can cause en-
gine damage.
If this warning is issued even
though the engine oil level is
correct: do not continue to
ride.
Do not continue your jour-
ney.
Have the fault rectified as
quickly as possible by a
specialist workshop, prefer-
ably an authorised BMW
Motorrad dealer.
Engine-oil level too low Shows accompanied by
the
Oil
warning
The electronic oil-level sensor
has registered an excessively
low oil level. Dipping the oil with the dip-
stick is the only way of ascer-
taining the exact engine-oil
level. The next time you stop
for fuel:
Checking engine oil level
( 103)
If the oil level is too low:
Top up the engine oil
( 105)
The oil sensor might be
defective if the "Check oil
level" message appears even
though a check with the
dipstick reveals that the oil
level is correct. Seek the advice of a spe-
cialist workshop, preferably
an authorised BMW Motor-
rad dealer. Insufficient battery charge
current
General warning light
lights up red.
Battery charge current
symbol is displayed.
A discharged battery can
cause the engine to die
suddenly, and this could res-
ult in a dangerous situation in
traffic.
Have faults rectified as soon
as possible.
If the battery is not char-
ging, continuing to ride
can cause it to discharge
completely, in which case it
will suffer irreparable damage.
If possible, do not continue
your journey.
Battery is not being charged.
You can continue to
ride until the battery is
discharged. Bear in mind,
329zStatus indicators

Reset average
consumptionRepeatedly press BC but-
ton1until the average fuel
consumption appears in the
display.
Press and hold down the
BC button until the reading
changes ("RESET").
The display shows
"--.- l/100 km".
Oil levelThe "Oil" reading gives you
an indication of the engine
oil level. You can call up this
reading only when the motor-
cycle is at a standstill.
The preconditions for auto-
matic registration of the oil
level are as follows:
Engine idling for at least 30
seconds.
Engine at operating temper-
ature.
Make sure the motorcycle is
upright. The readings mean:
Oil level is correct
Check the oil level with
the dipstick the next time
you stop for fuel. If you call
up another reading on the on-
board computer, this symbol
remains visible beside the
BC
line.
Oil level cannot be
measured (conditions as
stated above not satisfied).
The most recently measured
level is displayed for 5
seconds when you next
switch on the ignition.
The oil sensor might be
defective if the "Check
oil level" message reappears
even though a check with the
dipstick reveals that the oil
level is correct. In this case,
452zOperation

Remove the front seat
( 65)
Wipe the area around the oil
filler neck clean.
Remove oil filler cap1by
turning it counter-clockwise. Use a dry cloth to wipe oil
dipstick
2clean
Seat the oil dipstick on the
oil filler neck, but do not
engage the threads. Make sure that the dipstick is
seated in guide
3.
Remove the oil dipstick and
check the oil level.
Engine oil, specified
level
Between MIN and MAX
marks
If the oil level is below the
MIN mark: Top up the engine oil.
7104zMaintenance

Cruise-control system, 16Deactivating, 54
Resuming cruising
speed, 55
Set road speed, 53
Step-by-step accelera-
tion, 53
Step-by-step decelera-
tion, 54
Stepless acceleration, 54
Stepless deceleration, 54
Switching off, 55
Switching on, 53
Telltale light, 23
D
Dimensions Technical data, 151
E
Electrics Technical data, 149
Emergency off switch (kill switch), 17, 55 Engine
Starting, 78
Technical data, 142
Temperature gauge, 23
Warning, engine electron-
ics, 28
Engine oil Checking level, 103
Filler neck, 15
Oil dipstick, 15
Technical data, 144
Topping up, 105
Warning, engine oil level, 29
Warning, engine oil pres-
sure, 28
ESA, 16, 71 Adjust spring preload, 72
Adjust suspension damp-
ing, 71
Call up settings, 71
EWS Warning, 27 F
Final drive
Technical data, 147
Frame Technical data, 151
Front seat Adjusting, 15, 66
Heating, 17, 57
Installation, 66
Removal, 65
Front-wheel stand Installing, 118
Fuel Quantity reading, 23
Refuelling, 83
Technical data, 143
Warning, fuel down to
reserve, 27
Fuses, 149
G
Gear indicator, 23
Grip heating, 17, 56
11165zIndex