windshield wipers BMW X3 2.5I 2004 E83 Owner's Manual
[x] Cancel search | Manufacturer: BMW, Model Year: 2004, Model line: X3 2.5I, Model: BMW X3 2.5I 2004 E83Pages: 132, PDF Size: 3.62 MB
Page 44 of 132
Driving
42 5Serrated dial for adjustment of the wipe
interval or the sensitivity of the rain sen-
sor
Retracted position
The right wiper is partially concealed by the
hood.
To move the wipers into a vertical position:
1.Switch on wipers in lever position 1
2.When the wipers are approximately
vertical, move the ignition key to
position 0.
For changing the wiper blades, refer to
page 99.
Fold the wipers back down onto the
windshield before you turn the igni-
tion key to position 1 or 2 again. If you do
not, they could be damaged.<
Intermittent mode
Not on vehicles with rain sensor.
You can set the wipe interval to four stages
with the serrated dial 5.
In addition, the wipe interval is varied auto-
matically depending on road speed.
Rain sensor*
The rain sensor is positioned on the wind-
shield, directly in front of the interior rear-
view mirror.
Deactivate the rain sensor when
passing through an automatic car
wash. Failure to do so could result in dam-
age caused by undesired wiper activa-
tion.<
Activating
>Move the lever to position 1 with the
ignition key in position 1 or higher. The
wipers travel once across the wind-
shield, regardless of the weather condi-
tions.
You can leave the lever permanently in
position 1 and then only need to activate
the rain sensor as of ignition key position 1.
To do so:
>Briefly turn the serrated dial 5 or>Cleaning windshield 1, refer to next
section.
Adjust sensitivity: turn the serrated dial 5.
Deactivating
>Move lever to position 0.
Normal wipe
The system switches automatically to inter-
mittent mode when the vehicle is not mov-
ing, not on vehicles with rain sensor.
Fast wipe
The wipers operate at normal speed when
the vehicle is not moving, not on vehicles
with rain sensor.
Cleaning windshield, rear window
and headlamps*
0Wipers retracted
1To clean windshield and headlamps
2Rear window wiper intermittent mode
3Clean the rear window
Do not use the washers if there is any
danger that the fluid will freeze on the
windshield. If you do so, your vision could
be obscured. To avoid freezing, use a
washer fluid antifreeze, refer to page 94.
Do not use the washers when the reservoir
is empty. This could cause damage to the
washer pump.<
Cleaning the windshield
The system sprays washer fluid against the
windshield and activates the wipers for a
brief period.
The windshield washer nozzles are auto-
Page 101 of 132
Reference
At a glance
Controls
Driving tips
Mobility
99
Replacing components
Onboard tool kit
The onboard tool kit is located in a com-
partment on the left under the cargo area.
Replacing wiper blades
Front
1.Move the wiper to a fold-out position,
refer to page 42
2.Lift the wiper arm and press the secur-
ing spring, refer to arrow
3.Pull the wiper blade off toward the
wiper arm
4.Insert the new blade and snap it into
place.
Fold the wipers back down onto the
windshield before you turn the igni-
tion key to position 1 or 2 again. If you do
not, they could be damaged.<
Rear
1.Lift the wiper arm
2.Pull off the wiper blade, refer to arrow
3.Insert a new wiper blade.
Lamps and bulbs
The lamps and bulbs make essential contri-
butions to the safety of your vehicle. There-
fore, comply fully with the following instruc-
tions during bulb replacement. If you are
not familiar with the specified procedures,
BMW recommends having the replace-
ments carried out at your BMW Sports
Activity Vehicle Center.
Never touch the glass of new bulbs
with your bare fingers, as even minute
amounts of contamination will burn into the
bulb's surface and reduce its service life.
To install, use a clean cloth, napkin etc. or
hold the bulb by its metal socket.<
A replacement bulb set is available from
your BMW Sports Activity Vehicle Center.
To prevent short circuits, before
working on any electrical system,
equipment or accessory you should always
switch it off and disconnect the cable from
the battery's negative terminal before start-
ing.
To avoid possible injury or equipment dam-
age when changing bulbs, observe any
instructions provided by the bulb manufac-
turer.<
Page 129 of 132
Reference
At a glance
Controls
Driving tips
Mobility
127
Units 47
Ð outside temperature 47
Universal garage-door
opener, refer to
Integrated universal
remote control 66
Universal remote
control 66
Unlocking
Ð engine hood 92
Ð from inside 21
Ð from outside 19
Upholstery care, refer to
Caring for your vehicle
brochure
V
Vacuum cleaner
connection 69
Vehicle
Ð battery 105
Ð dimensions 115
Ð loading 78
Vehicle battery 105
Vehicle jack 103
Vehicle Memory 33
Ventilation 61, 65
Ð draft-free 61, 65
Voice control, refer to
separate Owner's Manual
W
Warning and indicator
lamps 12
Warning triangle 108
Warranty, refer to Service
and Warranty Information
Booklet for US models,
Warranty and Service
Guide Booklet for
Canadian models 97
Warranty and service
notes 7
Washer fluid 94
Washer fluid reservoir, refer
to Windshield/headlamp
washer system 94
Weights 116Wheel/tire combination,
refer to Replacing
wheels/tires 89
Wheelbase, refer to
Dimensions 115
Wheel bolts
Ð wrench 103
Wheel changes
Ð compact wheel 103
Wheels and tires 90
Width, refer to
Dimensions 115
Windows 22
Ð convenience operation 20
Window wipers
Ð replacing 99
Windshield
Ð cleaning 42
Windshield washer
Ð washer fluid 94
Windshield washer system
Ð washer/wiper system 41
Windshield wiper blade
replacement 99
Windshield wipers, refer to
Wiper/washer system 41
Winter tires
Ð changing 103
Ð condition 89
Ð storage 90
Wiper/washer reservoir 94
Wiper blade
replacement 99
Wiper system 94
Working in the engine
compartment 92
Wrenches, refer to
Onboard tool kit 99
X
xDrive 51
Xenon lamps 101
Ð replacing the bulbs 101