differential BMW X5 2002 E53 DSC System Workshop Manual

2
DYNAMIC STABILITY CONTROL (DSC III)
DSC FOR THE X5
INTRODUCTION
The X5 is equipped with DSC III for its stability control system. The components are the
same as the DSC III system (version 5.7) currently installed in the E38/E39 vehicles.
However the software and programming are changed to allow for new functions associat-
ed with all wheel drive and off-road use.
New/changed functions of the DSC III include:
• New Hill Decent Control (HDC) function
• New Differential Brake Control (ABD) function
• Changed traction control function
• Changed ABS function
DSC - X5 OVERVIEW
The DSC system for the X5 provides all of the functions and features of the DSC III system
currently in the E38/E39 vehicles. these functions/features include:
• Maintaining traction under all driving conditions
• Maintaining the directional Control (Longitudinal Stability)
• Providing Lateral Stability (Correction for oversteer/understeer)
• Providing Corner Braking Control (CBC)
• Providing Dynamic Braking System features of - Dynamic Braking Control and
Maximum Braking Control (DBC and MBC)
• Providing Electronic Brake Proportioning (EBV)

7
DYNAMIC STABILITY CONTROL (DSC III)
All of the familiar braking and straight line traction control features and system communi-
cation carry over from DSC II. Based on select high/select low logic, the DSC III control
module selects a vehicle stabilizing strategy based on the specific input signal values it is
monitoring at the moment. For all DSC strategies this begins with engine intervention to
reduce torque:
•For the 750iL this is handled via CAN communication, DSC III to EML to minimize the
throttle angle of the DK motors (750iL). For the 740i/iL and 540iA this is handled by
direct DSC III activation of the ADS II throttle housing.
• If additional torque reduction is necessary, DSC III informs DME over CAN to:
• Retard ignition timing
• Shut down the fuel injection to individual cylinders
DSC III monitors under/oversteer conditions through the following components:
• The driver’s desired steering angle - steering angle signal over CAN bus.
• Vehicle speed and speed differential at front wheels - wheel speed sensors
• Dynamic forces of lateral acceleration and yaw placed on the vehicle. This is possible
with two new components which are discussed further on. The results are as follows:

13
DSC - NEW FUNCTIONS
AUTOMATIC DIFFERENTIAL BRAKE (ADB)
On dry pavement with no wheel slip, the vehicle’s driving torque is split 68% rear and 32%
front through the planetary gear differential transfer case.
If one or more wheels spin or slip, the DSC will activate a regulation process and the brakes
on the effected wheel(s) will be pulsed. The driving torque will be distributed through the dif-
ferential to the remaining wheels with a good coefficient of friction
The driving torque will be applied through the differential as follows:
• Three wheels - with one wheel spinning.
• On two diagonal wheels with two wheels spinning on different axles.
• One axle only with two wheels spinning on the same axle.
Once the spin or slip is under control, the drive torque will again be applied to all wheels.