spark plugs replace BUICK CENTURY 1993 Owners Manual

ITEM
NO. SERVICE
5 Engine Accessory Drive Belt Inspection-
* Inspect the belt for cracks, fraying, wear and
proper tension. Replace as needed.
6 Cooling System Service*-Drain, flush and
refill the system with new or approved recycled
coolant conforming to
GM Specification 1825M.
Keep coolant at the proper mixture as specified. See “Engine Coolant” in the Index. This
provides proper freeze protection, corrosion inhibitor level and engine operating temperature.
Inspect hoses and replace if they are cracked,
swollen or deteriorated. Tighten screw-type hose
clamps. Clean the outside of the radiator and air
conditioning condenser. Wash the pressure cap
and neck.
To help ensure proper operation, we recommend
a pressure test of
both the cooling system and the
pressure cap.
ITEM
NO. SERVICE
7 Transaxle Service-Change both the fluid and
filter every
l5,O00 miles (25 O00 km) if the
vehicle is mainly driven under one or more of
these conditions:
In heavy city traffic where the outside tem-
perature regularly reaches
90°F (32OC) or
higher.
In hilly or mountainous terrain.
When doing frequent trailer towing.
Uses such as found in taxi, police car or
If you do’not use your vehicle under any of
these conditions, change both the fluid and filter every
100,000 miles (160 0o0 km).
plugs with the proper type. See “Specifications
‘and Capacities” in the Index. delivery service.
8 Spark
Plug Replacement*-Replace spark
285
ProCarManuals.com

ITEM
NO. SERVICE
9 Spark Plug Wire Inspection**-Inspect for
bums, cracks or other damage. Check the boot
fit at the distributor and at the spark plugs.
Replace wires as needed.
10 Exhaust Gas Recirculation (EGR) System
Inspection (2.2L Code 4 engine only)**-
Conduct the EGR system service as described in
the service manual.
To purchase a service
manual, see “Service Publications” in the Index.
ITEM
NO. SERVICE
12
Air Cleaner Filter Replacement*-Replace
every
30,000 miles (50 OOO km) or more often
under dusty conditions. Ask your dealer for the
proper replacement intervals for your driving conditions.
Fuel %nk, Cap
and Lines Inspection* A-
Inspect fuel tank, cap and lines (including fuel
rails and injection assembly, if equipped) for
damage or leaks. Inspect fuel cap gasket for an
even filler neck imprint or any damage. Replace
parts as needed. Periodic replacement of the fuel
filter is not required.
*An Emission Control Service.
*The
U.S. Environmental Protection Agency has determined that the failure to perform this maintenance item will not nullify the emission warranty
or limit
recall liability prior to the completion of vehicle useful life. General Motors, however, urges that all recommended maintenance services be
performed at the indicated intervals and the maintenance be recorded in “Section E: Maintenance Record.”
286
ProCarManuals.com

USAGE FWID/WBRICANT
~~ ~ ~~~ ~~
Hood Latch Assembly
a. Pivots and Spring
b. Release Pawl
Anchor a.
Engine oil.
b. Chassis lubricant meeting requirements of NLGI Grade 2, Category LB or GC-LB
(GM Part
No. 1052497 or equivalent).
Hood and Door
Hinges, Station Wag01
Liftgate, Fuel Door
Hinge, Folding Seat
Hardware, Rear Compartment Lid
Hinges Engine oil
or Lubriplate Lubricant
(GM Part No. 1050109).
Weatherstrips Dielectric Silicone Grease (GM Part No. 12345579 or equivalent).
See “Capacities and.Specifications” in the Index for recomm\
ended replacement filters, valves and spark plugs.
294
ProCarManuals.com