lock BUICK CENTURY 1994 Owner's Guide

The armrest can be raised so that a passenger can sit in
the center position.
Rear Locking Storage Compartment
(Wagon)
Use your door key to unlock the storage bin on the
driver’s side near the liftgate.
Ashtrays
Reach under the front edge of the ashtray compartment
to open
it. To remove the ashtray for cleaning, reach
under the ashtray and
push up from behind it.
108
ProCarManuals.com

Brake System Warning Light
BRAKE
If the light comes on while you are driving, pull off the
road and stop carefully. You may notice that the pedal
is
Your Buick’s hydraulic harder to push. Or, the pedal may go closer to the floor.
brake system is divided into It may take longer to stop. If the light is still on, or if the
two parts. If one part isn’t
anti-lock brake system warning light is flashing, have
working, the other part can the vehicle towed for service. (See “Anti-Lock Brake
still work and stop you. For
good braking, though, you
need both parts working
well.
If the warning light comes on, there cou Ild
be a brake
problem. Have your brake system inspected right away. System
Warning Light” and “Towing Your Buick” in the
Index.)
This light should come on as you start the vehicle. If it
doesn’t come on then, have it fixed
so it will be ready to
warn you if there’s a problem.
The brake system warning light will also come on when
you set your parking brake, and it will stay on if your
parking brake doesn’t release fully. If it stays on after
your parking brake is fully released,
it means you have a
brake problem.
113
ProCarManuals.com

I
Anti-Lock Brake SJ
ANTI-
LOCK
‘S tern Warning’Light
With anti-lock, this
light will come on
when you start your
engine and it will stay
on for three seconds.
That’s normal.
If the
light doesn’t come on,
have it fixed
so it will
be ready to warn you if
there is a problem.
If the anti-lock brake system warning light stays on
longer than normal after you’ve started your engine, turn
the ignition off. Or, if the light comes on and stays on
when you’re driving, stop as soon as possible and turn
the ignition
off. Then start the engine again to reset the
system. If the light still stays on, or comes on again
while you’re driving, your Buick needs service.
If the
light is on but not flashing and the regular brake system
warning light isn’t on, you still have brakes, but you
don’t have anti-lock brakes.
If
the light flashes when you’re driving, you don’t have
anti-lock brakes and there’s a problem with your regular
brakes. Pull off the road and stop carefully. You may
notice that the pedal is harder to push. Or, the pedal may
go closer to the floor. It may take longer to stop. Have
the vehicle towed
for service. (See “Towing Your
Buick” in the Index.)
114 1
I
ProCarManuals.com

Anti-Lock Brake System Active Light
LOW
TRACTION
When your anti-lock
system is adjusting
brake pressure to help
avoid a braking
skid, the
“LOW
TRACTION’ light
will come on.
Slippery road conditions will exist if this light comes on,
so adjust your driving accordingly. The light will stay on
for
a few seconds after the system stops adjusting brake
pressure. The
“LOW TRACTION” light also comes on
briefly, as a
bulb check, when the engine is started.
Engine Coolant Temperature Warning
Light
k F- 4ccN
TEMP
This light tells you that
your engine coolant has
overheated or your radiator
cooling fan is not working.
If you have been operating
your vehicle under normal
driving conditions, you
should pull off the road,
stop your vehicle and turn
the engine
off as soon as
possible.
The chapter “Problems on the Road,” in this manual
explains what to do. See “Engine Overheating” in the
Index.
ProCarManuals.com

Lower Knob Pushbuttons
Rotate
the lower knob to tune in radio stations. Press it
to change between the AM and FM bands.
Fade
The FADE control behind the lower knob adjusts the
front/rear speaker balance.
Treble
Slide this lever up to increase treble, or down to
decrease it. If a station is weak or noisy, reduce the
treble.
Bass
Slide this lever up to increase bass, or down to decrease it.
Scan
Press the SCAN button to hear each station for a few
seconds. Push it again to stop scanning.
Seek
rress the SEEK button to go to the next higher station
and stay there. Push
it again and it will find the next
higher station. The
four pushbuttons let you return to favorite stations.
To set the pushbuttons for up
to fourteen stations (7 AM
and
7 FM:
1. Use the lower knob (TUNE) to tune in the station
you want.
display.
3. Within 5 seconds, press one of the four pushbuttons.
Whenever you push that button again, the preset
station will return.
2. Press SET. The SET indicator will appear in the
Up to three more stations may be preset on each band by
pressing two pushbuttons that are next to each other, at
the same time.
1. Tune in the desired station.
2. Press SET, and within five seconds press any two
pushbuttons that are next to each other at the same
time. The station will return when the same two
pushbuttons are pressed again.
Clock
To set the clock,
1. Press the SET button.
127
ProCarManuals.com

Bass
Slide this lever up to increase bass, or down to decrease it.
Scan
Press the SCAN button to hear each station for a few
seconds. Push it again
to stop scanning.
Seek
Press the SEEK button to go to the next higher station
and stay there. Push
it again and it will find the next
higher station.
Pushbuttons
The four pushbuttons let you return to favorite stations.
To set
the pushbuttons for up to fourteen stations
(7 AM and 7 FM:
1. Use the lower knob (TUNE) to tune in the station
you want.
display.
3. Within 5 seconds, press one of the four pushbuttons.
Whenever
you push that button again, the preset
station will return.
2. Press SET. The SET indicator will appear in the Up
to three more stations may be
preset on each band by
pressing two pushbuttons that are next
to each other, at
the same time.
1. Tune in the desired station
2. Press SET, and within five seconds press any two
pushbuttons
that are next to each other at the same
time. The station will return when the same two
pushbuttons are pressed again.
Clock
To set the clock,
1. Press the SET button.
2. Within 5 seconds, press and hold SCAN until the
correct hour appears on the display.
3. Press and hold SEEK until the correct minute
appears on the display.
Dynamic Noise Reduction
Press the DNR@ button to select the Dynamic Noise
Reduction system that reduces background hiss on AM
and
FM radio broadcasts, as well as on cassette tapes.
You may want to leave
it pushed in all the time.
129
ProCarManuals.com

Pushbuttons
The five pushbuttons let you return to favorite stations.
1. Use the lower knob (TUNE) to tune in the station
you want.
display.
2. Press SET. The SET indicator will appear in the
3. Within 5 seconds, press one of the five pushbuttons.
Whenever
you push that button again, the preset
station
will return.
Clock
To set the clock,
1. Press the SET button.
2. Within 5 seconds, press and hold SCAN until the
correct hour appears on the display.
3. Press and hold SEEK until the correct minute
appears on the display.
To Play a Compact Disc:
Before you begin, please note: Don’t use mini-discs that
are called singles. They won’t eject.
Use only full-size
compact discs.
1. Press PWR to turn the radio on.
2. Insert a disc part-way into the slot, with the label
side up. The player will
pull it in. In a few seconds,
the disc should play.
If the disc comes back out and/or Err appears
on the
display:
0 The disc may be upside down.
0 The disc may be dirty, scratched or wet.
There may be too much moisture in the air (wait
The player may be too hot, or the road may be too
about
one hour and try again).
rough for the disc to play.
As soon as things get back
to normal, the disc should play.
While
a disc is playing, the CD indicator is displayed.
Recall
Press RCL once to see which track is playing. Press
again within five seconds to see how long your selection
has been playing. The track number also will be
displayed when
the volume is changed or a new track
starts to play.
Compression
Depressing COMP makes soft and loud passages more
equal
in volume. Press again to resume normal play.
132
ProCarManuals.com

CD Player Anti-Theft Feature
Delco LOC I1 is a security feature for the compact disc
player.
It can be used or ignored. If ignored, the system
plays normally. If it is used, your player won’t be usable
if
it is ever stolen, because it will go to LOC mode any
time battery power
is removed. Until an unlock code is
entered, it will
not turn on.
The instructions below tell you how to enter a secret
code into the system. If your vehicle loses battery power
for any reason, you must unlock the system with the
secret code before the radio will turn on. Be sure to read
through
the entire procedure and become familiar with
the appropriate buttons and knobs before starting.
1. Write down any six-digit number and keep it in
a
safe place.
2. Turn the ignition to the ACC or RUN position.
3. Press the PWR button to turn the radio off.
4. Press the 1 and 4 pushbuttons together. Hold them
down
until “---” shows on the display.
You are ready to enter your secret code. If you pause
more than
15 seconds between steps, you may have
to start the procedure over.
5. Press SET and “000” will appear on the display.
6. Press the SEEK button to make the first number
appear.
7. Rotate the TUNE knob right or left to make the last
two numbers agree with your code.
8. Press the lower (BAND) knob and “000” will appear
again.
Now you are ready to enter the last three digits of
your code by repeating steps
6 and 7 for the last
three digits
of your code.
9. Press the lower (BAND) knob and “rEP” will appear
for
five seconds and then “000” will appear
indicating that some steps are to be repeated.
10. Repeat steps 6,7 and 8.
11. Press the lower (BAND) knob. If the display shows
“SEC” it indicates that the process was successful
and the radio is secure. If
the display shows “---,”
the steps were not successful and the process must be
repeated
to secure.
134
ProCarManuals.com

To Unlock the System After a Power Loss
When battery power is reapplied to a secured radio, the
radio won’t turn on and “LOC” will appear on the
display. Enter your secret code as follows; pause no
more than
15 seconds between steps.
1. Turn the ignition on. (Radio off.)
2. Press the SET button. The display will show “000.”
3. Enter the six digits of your code following steps 6-9
on the preceding. The display will show the numbers
as entered.
4. Press the lower (BAND) knob and SEC appears,
then the time, indicating that the disabling sequence
was successful.
Disabling the Anti-Theft System:
1.
2.
3.
4.
5.
6.
Press the I and 4 buttons together for five seconds with
ignition on and radio power off. The display will show
“SEC,” indicating the unit is in the secure mode.
Press the
SET button. The display will show “OOO.”
Enter the first three digits of your code following
step
6 and 7of the preceding paragraphs. The display
will show the numbers as entered.
Press the lower (BAND) knob. The radio will
display
“000.”
Enter the second three digits of the code. The display
will show
the numbers as entered.
Press the lower (BAND) knob.
If the display shows
numbers matched the user-selected code or
the
factory back-up code) and the unit is in the
UNSECURED mode. If
the display shows “SEC,”
the disabling sequence was unsuccessful and the numbers did
not match either of the codes and the
unit will remain in the SECURED mode.
“--- , ” the disabling sequence was successful (the
135
ProCarManuals.com

And, of course, actual stopping distances vary greatly
with the surface of
the road (whether it’s pavement or
gravel); the condition
of the road (wet, dry, icy); tire
tread; and the condition
of your brakes.
Avoid needless heavy braking. Some people drive
in
spurts -- heavy acceleration followed by heavy braking
-- rather than keeping pace with traffic. This is a
mistake. Your brakes may not have time to cool between
hard stops. Your brakes will wear out much faster if you
do a
lot of heavy braking. If you keep pace with the
traffic and allow realistic following distances, you will
eliminate a lot
of unnecessary braking. That means
better braking and longer brake life.
If your engine ever stops while you’re driving, brake
normally but don’t pump your brakes.
If you do, the
pedal may get harder to push down. If your engine
stops,
you will still have some power brake assist. But
you will use it when you brake. Once the power assist is
used up, it may take longer
to stop and the brake pedal
will be harder to push.
Anti-Lock Brakes (ABS)
Your Buick has an advanced electronic braking system
that will help prevent skidding.
ANTI-
LOCK
This light on the
instrument panel will
go on when
you start
your vehicle.
When you start your vehicle, or when you begin to drive
away,
you may hear a momentary motor or clicking
noise. And you may even notice that your brake pedal
moves a little while this is going on. This
is the ABS
system testing itself. If there’s a problem with the
anti-lock brake system, the anti-lock brake system warning light
will stqy on or flash.
See “Anti-lock Brake System Warning Light” in
the
Index.
145
ProCarManuals.com