battery BUICK CENTURY 1994 Owners Manual
[x] Cancel search | Manufacturer: BUICK, Model Year: 1994, Model line: CENTURY, Model: BUICK CENTURY 1994Pages: 308, PDF Size: 16.3 MB
Page 14 of 308

Vehicle Symbols
These are some of the symbols you may find on your vehicle.
Fur example,
these symbols
are used on an
original battery:
POSSIBLE A
CAUTION
INJURY
PROTECT EYES BY
SHIELDING
Q
CAUSTIC
BURNS AVOID
SPARKS
OR
FLAMES
SPARK
OR ,\I/,
COULD FLAME
EXPLODE BATTERY
These symbols
are important
for you and
your passengers whenever your
vehicle is
driven:
FASTEN SEAT 4
BELTS
POWER
WINDOW
AIRBAG P
These symbols have
to do with
your lights:
SIGNALS e
TURN
HIGH BEAM
OR = =o
FOG LAMPS $0
These symbols
are
on some of
your controls:
WIPER v
WINDSHIELDw DEFROSTER
WINDOW
DEFOGGER
VENTILATING FAN
These symbols
are used
on
warning and
indicator lights:
COOLANT F&
TEMP -.--
ENGINE
CHARGING
I-1
BAllERY SYSTEM
RADIATOR COOLANT
a
FUEL
ENGINE OIL e,
PRESSURE
TEMP
OIL 4%
ANTILOCK (@)
BRAKE
Here are some
other symbols
you may see:
FUSE
RADIO
k
VOLUME J
CONDITIONING A'R 0
RELEASE 6
TRUNK
LIGHTER
m
ProCarManuals.com
Page 71 of 308

up to 30 feet (9 m) away using the key chain transmitter
supplied with your vehicle.
Your Remote Keyless Entry System operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules.
This device complies with Part
15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
Should interference to this system occur, try this:
e
e
e
0
Check to determine if battery replacement is
necessary. See the instructions on battery
replacement.
Check the distance. You may be
too far from your
vehicle. This product has a maximum range.
Check the location. Other vehicles or objects may be
blocking
the signal.
See your Buick dealer or a qualified technician for
service.
Changes or modifications
to this system by other than an
authorized service facility could void authorization
to
use this equipment.
Operation
The driver’s door will unlock and the interior lights will
go
on when “UNLOCK” is pressed. If pressed again
within five seconds, all doors will unlock.
The interior
lights will go out after
40 seconds or when you turn on
the ignition.
All doors will lock when “DOOR”
is pressed.
Press the opened trunk symbol to unlock the trunk or
wagon liftgate. The transaxle must be in “P” (Park.) If
you have the wagon, the ignition must also be “Off.”
Matching Transmitter(s) To Your Vehicle
Each key chain transmitter is coded to prevent another
transmitter from unlocking your vehicle. If
a transmitter
is lost or stolen, a replacement can be purchased through
your dealer. Remember
to bring any remaining
transmitters with you when
you go to your dealer. When
the dealer matches the replacement transmitter to your
vehicle, the remaining transmitters must also be
matched. Once the new transmitter
is coded, the lost
transmitter will not unlock your vehicle.
You can match a transmitter
to as many different
vehicles as you own, provided they are equipped with
exactly the same model system. (General Motors offers
several different models
of these systems on their
69
ProCarManuals.com
Page 72 of 308

vehicles.) Each vehicle can have only two transmitters
matched to
it.
See your dealer to match transmitters to another vehicle.
Battery Replacement
Under normal use, the batteries in your key chain
transmitter should last about two years.
You can tell the batteries are weak if the transmitter
won’t work at the normal range in any location. If you
have
to get close to your vehicle before the transmitter
works, it’s probably time
to change the batteries.
To replace batteries:
1.
2.
3.
4.
5.
Carefully pry off the cover by inserting a dime (or
similar object)
in a slot between the covers and twist.
Lift off the front cover, bottom half first.
Remove and replace the batteries. Put them in
following the diagram under the batteries on the
inside of the cover.
Replace the front cover. Make sure the cover
is on
tightly,
so water won’t get in and snap the cover
together.
Check the transmitter operation.
For battery re lacernent use
two Duracell batteries,
type
DL-20 16, or a similar
type.
8
70
ProCarManuals.com
Page 78 of 308

NOTICE:
If your key seems stuck in “Lock” and you can’t
. turn it, be sure it is all the way in. If it is, then turn
the steering wheel left and right while you turn
the key hard. But turn the key only with your
hand. Using a tool to force it could break the key
or the ignition switch. If none of this works, then
your vehicle needs service.
Starting Your Engine
Move your shift lever to “P” (Park) or “N” (Neutral).
Your engine won’t start in any other position
-- that’s a
safety feature. To restart when you’re already moving,
use
“N’ (Neutral) only.
NOTICE:
Don’t try to shift to “P” (Park) if your Buick is
moving.
If you do, you could damage the
transaxle. Shift to
“P” (Park) only when your
vehicle is stopped.
To start your engine:
1. Without pushing the accelerator pedal, turn your
ignition key to “Start.” When the engine starts,
let go
of the key. The idle speed will go down as your
engine gets warm.
NOTICE:
Holding your key in “Start” for longer than 15
seconds at a time will cause your battery to be
drained much sooner. And the excessive heat
can damage your starter motor.
76
ProCarManuals.com
Page 120 of 308

NOTICE:
Damage to your engine from neglected oil
problems can be costly and is not covered by
your warranty.
Battery Light
Then it should go out. If it stays on, or corn-es 6n %bile
you are driving, you may have a problem with the
electrical charging system. It could indicate that
you
have a loose generator drive belt or another electrical
problem. Have
it checked right away. Driving while this
light is on could drain your battery.
If you must drive a short distance with the light on, be
certain
to turn off all your accessories, such as the radio
and air conditioner.
The battery warning light
will come on briefly when
you turn on the ignition, but
the engine
is not running,
as a check to
show you it is
working.
118
ProCarManuals.com
Page 121 of 308

Voltage Indicator
When your engine is not
running, but the ignition is
on (in the “Run” position),
the gage shows your
battery’s
state of charge in
DC volts. When the engine
is running, the gage shows
the condition
of the
charging system. Readings
between
the red warning
zones indicate the normal
operating range.
Readings
in either red warning zone indicate a possible
problem in the electrical system. Have your vehicle
serviced immediately.
Liftgate Ajar Warning Light (Wagon)
The “TAILGATE AJAR”
light on your instrument
panel
will come on if your
liftgate
is not completely
TAILGATE
AJAR
closed.
119
ProCarManuals.com
Page 136 of 308

CD Player Anti-Theft Feature
Delco LOC I1 is a security feature for the compact disc
player.
It can be used or ignored. If ignored, the system
plays normally. If it is used, your player won’t be usable
if
it is ever stolen, because it will go to LOC mode any
time battery power
is removed. Until an unlock code is
entered, it will
not turn on.
The instructions below tell you how to enter a secret
code into the system. If your vehicle loses battery power
for any reason, you must unlock the system with the
secret code before the radio will turn on. Be sure to read
through
the entire procedure and become familiar with
the appropriate buttons and knobs before starting.
1. Write down any six-digit number and keep it in
a
safe place.
2. Turn the ignition to the ACC or RUN position.
3. Press the PWR button to turn the radio off.
4. Press the 1 and 4 pushbuttons together. Hold them
down
until “---” shows on the display.
You are ready to enter your secret code. If you pause
more than
15 seconds between steps, you may have
to start the procedure over.
5. Press SET and “000” will appear on the display.
6. Press the SEEK button to make the first number
appear.
7. Rotate the TUNE knob right or left to make the last
two numbers agree with your code.
8. Press the lower (BAND) knob and “000” will appear
again.
Now you are ready to enter the last three digits of
your code by repeating steps
6 and 7 for the last
three digits
of your code.
9. Press the lower (BAND) knob and “rEP” will appear
for
five seconds and then “000” will appear
indicating that some steps are to be repeated.
10. Repeat steps 6,7 and 8.
11. Press the lower (BAND) knob. If the display shows
“SEC” it indicates that the process was successful
and the radio is secure. If
the display shows “---,”
the steps were not successful and the process must be
repeated
to secure.
134
ProCarManuals.com
Page 137 of 308

To Unlock the System After a Power Loss
When battery power is reapplied to a secured radio, the
radio won’t turn on and “LOC” will appear on the
display. Enter your secret code as follows; pause no
more than
15 seconds between steps.
1. Turn the ignition on. (Radio off.)
2. Press the SET button. The display will show “000.”
3. Enter the six digits of your code following steps 6-9
on the preceding. The display will show the numbers
as entered.
4. Press the lower (BAND) knob and SEC appears,
then the time, indicating that the disabling sequence
was successful.
Disabling the Anti-Theft System:
1.
2.
3.
4.
5.
6.
Press the I and 4 buttons together for five seconds with
ignition on and radio power off. The display will show
“SEC,” indicating the unit is in the secure mode.
Press the
SET button. The display will show “OOO.”
Enter the first three digits of your code following
step
6 and 7of the preceding paragraphs. The display
will show the numbers as entered.
Press the lower (BAND) knob. The radio will
display
“000.”
Enter the second three digits of the code. The display
will show
the numbers as entered.
Press the lower (BAND) knob.
If the display shows
numbers matched the user-selected code or
the
factory back-up code) and the unit is in the
UNSECURED mode. If
the display shows “SEC,”
the disabling sequence was unsuccessful and the numbers did
not match either of the codes and the
unit will remain in the SECURED mode.
“--- , ” the disabling sequence was successful (the
135
ProCarManuals.com
Page 166 of 308

bags, rags, floor mats -- anything you can wrap around
yourself or tuck under your clothing
to keep warm.
You
can run the engine to keep warm, but be careful.
Run your engine only as long as
you must. This saves
fuel. When you run the engine, make it go a little faster
than just idle. That is, push the accelerator slightly. This
uses less fuel for the heat that you get and it keeps the
battery charged.
You will need a well-charged battery to
restart the vehicle, and possibly for signaling later
on
with your headlights. Let the heater run for awhile.
164
ProCarManuals.com
Page 175 of 308

.-
Press the button in to make
your front and rear turn
signal lights flash on
and off.
Your hazard warning
flashers work no matter
what position your key is
in, and even if the key
isn't in.
To turn off the flashers, pull
out on the collar.
When
the hazard warning
flashers are on, your turn
signals won't work.
Other Warning Devices
If you carry reflective triangles, you can set one up at
the side of the road about 300 feet (100 m) behind your
vehicle.
Jump Starting
If your battery has run down, you may want to use
another vehicle and some jumper cables to start your
Buick. But please follow the steps below
to do it safely.
173
ProCarManuals.com