door lock BUICK ENCLAVE 2009 Get To Know Guide

Getting to Know Your Enclave4
Driver Information Center
Your vehicle’s Driver Information Center
(DIC) provides vehicle information, vehi-
cle feature customization, and vehicle
warning messages. The DIC messages
will be shown on the instrument panel
cluster display.
To access DIC features, press the
following buttons located below the radio
on the instrument panel:
(Set/Reset):Press this button to
set or reset DIC information while it is
displayed or to acknowledge a warning
message.
(Customization): Press this
button to scroll through the following
customization settings:
• Display Language
• Auto Door Lock
• Auto Door Unlock
• Remote Door Lock
• Remote Door Unlock
• Delay Door Lock
• Exit Lighting
• Approach Lighting
• Chime Volume
• Park Tilt Mirrors (if equipped)
• Easy Exit Seat (if equipped)
• Memory Seat Recall (if equipped)
• Remote Start On/Off (if equipped)
• Reset to Factory Settings
To customize features:
1. With the vehicle in Park, turn on the
ignition.
2. Press the (Customization) button
to enter the Feature Settings menu.
3. Press the button to scroll through
the available customization features.
4. With the desired feature displayed,
press the (Set/Reset) button to
access the settings.
5. Press the button to scroll through
the available settings.
6. With the desired setting displayed,
press the button to select it.
7. Press the button to scroll to the
next available customization feature.
8. To exit the Feature Settings menu,
press the button until FEATURE
SETTINGS EXIT is displayed, and
then press the button; or press
the button or the button.
(Vehicle Information):Press this
button to display the following vehicle
information:
• Oil Life
• Park Assist On/Off (if equipped)
• Units
• Tire Pressure
• Tire Pressure System Programming
• Remote Keyless Entry Programming

5
(Trip/Fuel):Press this button to
display the following trip and fuel
information:
• Odometer
• Trip Odometers
• Fuel Range
• Average Economy
• Timer
• Fuel Used
• Average Speed
Warnings and Messages
The DIC provides a variety of vehicle
warning messages (depending on
optional equipment) if a problem is
sensed in a vehicle system. To
acknowledge a message and clear it
from the display, press any DIC button.
Some urgent messages cannot be
cleared from the DIC display.
If you have a current OnStar subscrip-
tion, and a warning message appears,
you can press the OnStar button and
speak to an OnStar Advisor. In many
vehicles, OnStar Advisors can access
certain diagnostic information and can
tell you how serious the problem is and
what you should do about it.
See Section 3 of your Owner Manual.
Note: Your vehicle’s warnings and
messages provide critical information
that can prevent damage to your vehi-
cle. Review your Owner Manual to
become familiar with the information
displayed and the action required.
Remote Keyless Entry
The Remote Keyless Entry (RKE) trans-
mitter allows you to lock and unlock your
vehicle and perform other functions
while up to approximately 195 feet away
from the vehicle.
RKE functions include:
(Remote Vehicle Start)(if equipped):
This feature can be used to start the
engine from outside the vehicle. (See
Remote Vehicle Start.)
(Lock):Press this button to lock all
the doors. RKE feedback (light flash
and/or horn chirp) can be programmed
using the Driver Information Center
(DIC).
(Unlock):Press this button to unlock
the driver’s door. Press it again within
five seconds to unlock all remaining
doors. RKE feedback (light flash) can be
programmed using the DIC.
(Power Liftgate)(if equipped):
Press and hold this button until the lift-
gate starts moving to open and close
the liftgate. The taillamps will flash and a
chime will sound when the liftgate is
moving.
(Vehicle Locator/Panic Alarm):
Press and release this button to locate
your vehicle. The turn signal lamps will
flash and the horn will sound three
times.
Press and hold the button to activate the
panic alarm. The turn signal lamps will
flash and the horn will sound for 30
seconds. Press the button again or turn
the ignition to On to cancel the alarm.
See Section 2 of your Owner Manual.
SAFETY & SECURITY

Getting to Know Your Enclave6
Seat Adjustments
Power Seat Adjustment
Use the horizontal control (A) on the
outboard side of the seat cushion to
move the seat forward/rearward and —
on the driver’s seat only — up/down,
as well as raise/lower the front or rear
of the seat cushion.
Power Seatback Recline Adjustment
(if equipped)
Use the vertical control (B) on the
outboard side of the seat cushion to
recline/raise the seatback.
Power Lumbar Support Adjustment
(if equipped)
Use the control pad (C) on the outboard
side of the seat cushion to increase/
decrease lumbar support.
Manual Seatback Recline Adjustment
Lift the lever located on the outboard
side of the seatback and move the seat-
back to the desired position; then
release the lever.
OnStar®
Your vehicle features the uplevel OnStar
Directions & Connections Plan with one
year of OnStar service from the date
you purchased your new vehicle. With
the help of OnStar Advisors, who are
available 24 hours a day, 7 days a
week, OnStar offers a wide variety of
safety and driver assistance capabilities,
including:
• Driving Directions and Turn-by-Turn
Navigation
• OnStar Vehicle Diagnostic email
• Automatic Notification of Airbag
Deployment
• Emergency Services
• Remote Door Unlock
• Stolen Vehicle Location Assistance
• Information & Connections services
For more information, refer to
your OnStar Owner’s Guide, call
1-888-4-ONSTAR (1-888-466-7827),
or visit onstar.com.
See Section 2 of your Owner Manual.
Child Restraints (LATCH)
Your vehicle is equipped with LATCH
anchors, and may have top tethers for
use with a LATCH-compatible child
restraint. The LATCH anchors are locat-
ed in the 2nd-row outboard seating posi-
tions. If your child restraint is not com-
patible with the LATCH system, you may
still use it by installing the child restraint
with the safety belt system. Choose a
child seat that is appropriate for the
child’s age and size (weight and height).
See Section 1 of your Owner Manual.
COMFORT
C B A

9
Memory settings can be programmed for
the position of the driver’s seat, outside
mirrors and power adjustable steering
wheel (if equipped). The memory but-
tons are located on the driver’s door.
To save memory settings:
1. Adjust the driver’s seat, outside mir-
rors, and power adjustable steering
wheel to the desired position.
2. Press and hold button 1 until two
beeps sound.
Repeat these steps using button 2 for a
second driver.
To recall the memory settings, press
button 1 or 2 with the vehicle in Park.
The memory seat setting also can be
programmed in the DIC to be recalled
automatically when using the Remote
Keyless Entry transmitter.
Easy Exit Seat
With the vehicle in Park, press the
(Easy Exit Seat) button to recall the exit
Memory Seat and Mirrors
(if equipped)
Adjust the driver’s seat to a comfortable
position before adjusting the steering
wheel.
Manual Adjustment
To tilt and tele-
scope the
position of the
steering
wheel:
1. Push down
the lever on
the left side of the steering column.
2. Adjust the wheel to a comfortable
position by moving it up or down
as well as forward or backward.
3. Pull up the lever to lock the wheel
in place.
Power Adjustment (if equipped)
To operate the
power tilt and
telescope fea-
ture, use the
control located
on the left side
of the steering
column.
To tilt the
steering wheel up or down, push the
control up or down.
To move the steering wheel away from
you or toward you, push the control
forward or rearward.
See Section 3 of your Owner Manual.
Steering Wheel Adjustment
position for the driver’s seat. The easy
exit seat setting also can be pro-
grammed in the DIC to be recalled when
removing the key from the ignition.
See Section 1 of your Owner Manual.
(Cooled Seat):Press the top button
to turn on the cooled seat.
Continue to press the desired button to
cycle through the temperature settings
of High (three indicator lights), Medium
(two indicator lights), Low (one indicator
light), and Off (no indicator lights).
See Section 1 of your Owner Manual.

Getting to Know Your Enclave16
Windshield Wipers and Washer
The windshield wipers and washer con-
trols, located on the multifunction lever
on the left side of the steering column,
include the following functions:
(Mist):Rotate the control band to
this position to turn the wipers on for
one wipe.
(Off):Rotate the control band to this
position to turn off the wipers.
Interior Lighting Features
Instrument Panel Brightness
The (instrument panel brightness)
control knob is located on the left side of
the instrument panel. To brighten or dim
the instrument panel lights, press the
knob; it will pop out. Turn the knob to
adjust the intensity of the lights.
Courtesy Lamps
The courtesy lamps will come on when
a door is open. The lamps also can be
turned on by fully rotating the instrument
panel brightness control knob clockwise.
To disable the courtesy lamps, press the
(Courtesy Lamp Override) button
located above the instrument panel
brightness control knob.
See Section 3 of your Owner Manual.
The Automatic Headlamp System
turns on the Daytime Running Lamps
in the daytime and the headlamps and
other exterior lamps at night or when
necessary.
The system uses a light sensor, located
on top of the instrument panel, to
determine light conditions. For proper
operation, avoid placing any objects on
or near the sensor.
Exterior Lamps Control
The exterior lamps can be operated
using the control knob located on the left
side of the instrument panel. The knob
can be rotated to the following positions:
AUTO (Automatic Lamp Control):
This position enables the Automatic
Headlamp System.
(On/Off):Momentarily turn the knob
to this position to turn the Automatic
Headlamp System off or on again.
(Parking Lamps):This position
turns on the parking lamps and
taillamps.
(Headlamps):This position turns
on the headlamps, parking lamps and
taillamps.
(Fog Lamps):Press this button on
the exterior lamps control knob to turn
the fog lamps on or off.
See Section 3 of your Owner Manual.
Automatic Headlamp System

(Delay):Rotate the control band to
one of these positions to adjust the
delay between wipes. The wipers acti-
vate more often as the band is rotated
upward.
1 (Low):Rotate the control band to this
position for steady wipes.
2 (High): Rotate the control band to this
position for rapid wipes.
(Washer Fluid):Push the button
on the end of the lever to spray washer
fluid on the windshield.
Rear Wiper and Washer
The rear wiper
and washer
button, located
on the center
console in front
of the shift
lever, includes
the following
functions:
(Rear Wiper):Press the top of the
button (A) to turn the rear wiper on or
off.
(Washer): Press the bottom of the
button (B) to spray washer fluid on the
rear window.
See Section 3 of your Owner Manual.
17
B
A
Heated Washer Fluid
(if equipped)
Press the (Heated Washer Fluid)
button on the left side of the instrument
panel to spray heated washer fluid on
the windshield. This will help clear ice,
tree sap or bugs from the windshield.
Power Windows
Express-Down Windows
To operate the driver or front passenger
express-down window, press the switch
fully and the window will lower automati-
cally. Press the switch partway to open
the window a small amount. To stop the
window, pull or press on the switch
momentarily.
Express-Up Window
To operate the driver or front passenger
express-up window, pull up the switch
fully and the window will rise automati-
cally. To stop the window, pull or press
on the switch momentarily.
Window Lockout
Press the (Window Lockout) switch
on the driver’s door armrest to prevent
the rear windows from operating except
from the driver’s position. Press the
switch again to turn off the lockout
feature.
See Section 2 of your Owner Manual.
It may take up to
40 seconds to
heat the washer
fluid, after which
the wipers will
automatically turn
on for four heated
wash cycles.
Press the button
again to cancel any remaining cycles.
See Section 3 of your Owner Manual.

There are several ways to open and
close the power liftgate:
• Press and hold the (Power
Liftgate) button on the Remote
Keyless Entry transmitter until the lift-
gate starts moving. Press it again to
reverse operation.
The following power foldaway mirror
controls are located on the driver’s door:
(Mirror Selector):Press the left side
of this switch (A) to select the driver’s
side mirror or the right side of this switch
to select the passenger’s side mirror.
Press either side of the switch twice to
lock out the control pad to prevent un-
intentional adjustment.
(Mirror Adjustment):Press the
four-way control pad (B) to adjust the
selected mirror.
(Foldaway Mirrors)(if equipped):
Press the right side of this switch (C) to
fold the mirrors, and press the left side
of this switch to unfold the mirrors.
See Section 2 of your Owner Manual.
Getting to Know Your Enclave18
Cruise Control
The cruise
control
buttons are
located on
the steering
wheel. They
include the
following
functions:
(On/Off):
Press this
button to
enable the
cruise control
system.
SET– (Set):Press this button to set a
speed. If the system is active, press and
release this button to decrease speed
1 mph, or press and hold the button to
decrease speed more than 1 mph.
When the cruise control is set, the
(Cruise Control) symbol will illuminate in
the instrument panel cluster.
RES+ (Resume):Press this button to
resume a set speed. If the system is
active, press and release this button to
increase speed 1 mph, or press and
hold the button to increase speed more
than 1 mph.
(Cancel):Press this button to can-
cel the cruise control but retain the set
speed in memory.
See Section 3 of your Owner Manual.
Outside Power Foldaway Mirrors
(if equipped)
Power Liftgate
B
A
C