radio controls BUICK LACROSSE 2006 Get To Know Guide

Getting to Know YourLaCrosse6
Remote Vehicle Start
(if equipped)
Use the Remote Keyless Entry transmit
ter (key fob) to start the engine from out
side the vehicle. (See the Driver
Information Center personalization menu
section to enable.) Automatic Climate
Control system vehicles will regulate the
inside temperature.
To remote start the vehicle:
1. Press and release the key fob Lock
button.
2. Press and hold the (Remote Start)
button until the turn signal lights flash.
If the lights are not visible, hold the
Remote Start button for four seconds
and release.
The engine runs for 10 minutes. Extend
run time for 10 minutes from present by
pressing the Lock and Remote Start but
tons again. Pressing only the Remote
Start button again will turn off the igni
tion. Maximum run time is 20 minutes.
After two remote starts have been pro
vided, the Remote Vehicle Start feature
will not operate.
See Section 2 of your Owner Manual.
Unlocking the Doors with the Key
Your vehicle’s passenger doors can be
unlocked using the driver’sdoor key.
With the key in the lock cylinder:
• Turn the key toward the front of the
vehicle to unlock the driver’s door.
• Turn and hold the key toward the
front of the vehicle for two seconds to
unlock all doors.
• Turn and hold the key toward the rear
of the vehicle to lock all doors.
See Section 2 of your Owner Manual.
Headlamp Controls and
Automatic Headlamp System
You will find the exterior lamps knob on
the left side of the instrument panel.
(On/Off):If the switch is in the AUTO
position but lights are off, turn them on
by turning the switch to (On/Off) and
release. To turn the headlamps off when
the lights are on, turn the control to the
position. The momentary switch
design springs back to AUTO when
released.
AUTO:Activates the automatic head
lamp system, illuminating all exterior
lamps and the instrument panel/radio
lights when needed.
(Parking Lamps):The parking lamp
position illuminates tail/side marker/
license plate lamps and instrument
panel/radio lights.

Getting to Know YourLaCrosse10
Audio Systems
Setting the Time
Press and hold the “H” button on the
sound system faceplate until the correct
hour appears on the display. Press and
hold M until the correct minute appears.
The ignition does not need to be turned
on.
Radio Controls
(Power):
Press to turn the system on
and off.
(Volume):Turn to increase/decrease
volume.
BAND:Press to switch between AM,
FM1/FM2 and XM1/XM2 (if equipped).
DISP (Display): Press to switch the dis
play between the radio station frequency
and the time. With the ignition off, press
to display the time.
While in XM mode (if equipped), press
to display the artist, song title, category
and channel.
INFO (Information) (if equipped): While
in XM mode (if equipped), press to dis
play a current radio station message
and other information, if available.
SCV (Speed Compensated Volume):Press to select Off, Min, Med or Max
radio volume compensation as vehicle
speed increases.
(Tune/Balance/Fade):Turn to select
radio stations.
Cruise Control
The cruise control buttons are located
on the steering wheel.
(On/Off):Push to turn the system on
or off, or to deactivate.
SET (Set/Decelerate):To set cruise
control, press the button and acceler
ate to the desired speed. Press the
SETbutton and release the accelerator.
To decrease speed when cruise is
active, press and hold the SET buttonto reach the desired speed.
• Press SET once and release to
decrease speed by 1 mph.
RES+ (Resume/Accelerate):After
setting a cruise speed and later braking
for conditions, push the RES+ button to
resume the set speed.
To increase speed from a previous
setting, press and hold the RES+ button
to reach the desired speed or use the
accelerator.
• Press RES+ once and release to
increase speed by 1 mph.
See Section 3 of your Owner Manual.

11
To set Bass/Treble, push and release
until “BAS” or “TRE” appears. Turn to
increase or decrease. To adjust to the
middle position, press and hold until it
beeps.
To set Balance/Fade, push and release
until “BAL” appears to adjust Balance.
Turn the knob to move the sound toward
the right or left. Push until “FAD” appears
toadjust Fade. Turn the knob to move
the sound toward the front or rear.
To adjust all controls to the middle posi
tion, push/hold the speaker knob when
no tone or speaker control is displayed.
“ALL CEN” appears and the unit beeps.
(Seek):Press and release the
left/right Seek arrow to go to the previ
ous or next station and stay there.
Toscan, press and hold either arrow for
more than two seconds. “SCAN”
appears on the display and a beep
sounds. The radio finds a station, playsafew seconds and advances to the
next. Press either arrow or a pushbutton
to stop scanning.
Toscan preset stations, press and hold
either arrow for more than four seconds.
“PSCAN” appears and two beeps
sound. Press either arrow or a push
button to stop scanning presets.
Setting Preset Stations:
1. With the radio on, press BAND to
select AM/FM1/FM2 or XM1/XM2
(if equipped).
2. Tune to the desired station.
3. Press EQ to select equalization.
4.Press and hold a numbered push
button until a beep sounds.
Repeat for each pushbutton for each
band (up to 30 possible stations).
CD Controls
With the ignition on, insert a CD, label
side up, partway into the slot. The player
will pull it in and begin playing. To insert
with ignition off, first press eject or DISP.
1 (Reverse):Press to go to the start
of the current track if more than eight
seconds have played. Hold or press
more than once to move backward
through the CD tracks.
2 (Fast Forward):Press to go to
the next track. Hold or press more than
once to forward through the upcoming
CD tracks.
4RDM (Random):Press to hear tracks
in random order.Press again to disable
random play.
(Seek):Press the left arrow to go
to the start of the current track or the
previous track. Press the right arrow to
go to the start of the next track. Press
the arrows for more than two seconds to
search previous or next tracks. Release
to stop searching and play the track.
DISP (Display):Press to display the
current CD track and the elapsed time
the current track has played.
BAND:Press to switch to the radio
when a CD is playing. The CD remains
inside the player.
(CD):Press to play a CD when the
radio is playing.
EQ (if equipped): Press to select cus
tomized equalization settings for C&W,
Jazz, Talk, Pop, Rock and Classical
music. To return to manual mode,
press and release the Tone knob until
“MANUAL” is displayed.
(Eject):Press to eject a CD, with the
ignition off or on, or the radio off. Load
CDs with the ignition off by pressing this
button first.

13
Universal Home Remote
TheUniversal Home Remote can store
three frequencies for a garage door
opener, entry door lock, security system,
etc. The remote requires the vehicle’s
engine to be running or the ignition to be
in the Run position in order to operate.
This provides added security by not
allowing access to the home, garage,
etc., through the Universal Home
Remote without having the proper key
for the vehicle.
To program, with the key On and the
engine Off:
• Press and hold the two outer buttons
on the remote until the indicator light
flashes;
then release the buttons(about 20 seconds — do not hold for
more than 30 seconds); do not repeat
this step for the second or third
devices added.
• Hold the end of your handheld trans
mitter up to three inches away from
the surface of the remote. Hold its
button and the button you wish to
assign it to on the Universal Home
Remote.
• Continue holding both buttons (up to
90 seconds); the indicator light will
begin blinking slowly, then more quick
ly. Programming is complete when
the remote light flashes rapidly.
• Release both buttons.
• Press and hold the remote button
again. If the indicator stays lit con
stantly, programming is complete.
• Continue programming additional
devices using the remaining two
Universal Home Remote buttons, but
do not simultaneously press the two
outer buttons on the remote again.
If the remote indicator blinks rapidly for
two seconds and remains on during pro
gramming, it indicates that your device
(usually a garage door opener) has a
“rolling code.”
See Section 2 of your Owner Manual.
Steering Wheel Controls (if equipped)
See Radio and CD Controls for full details
about the functions of the following buttons:
•
(Seek)
•BAND
•1–6 (Preset Stations)
•(OnStar®/Mute):Press to silence
audio, and again to play. In OnStar
equipped vehicles, press to interact
with the OnStar system.
•
(VOLUME):Press up/down
arrow to increase/decrease volume.
See Section 3 of your Owner Manual.

Getting to Know YourLaCrosse16
Opening the Vehicle Hood
Pull the hood release handle located
under the driver’s side of the instrument
panel.
Under the leading edge of the hood
itself, push the secondary hood release
handle up and to the right. Lift the hood.
See Section 5 of your Owner Manual.
Accessory Power Outlets
Your vehicle is equipped with 12volt
outlets. One is located on the center
console below the climate controls.
The second outlet is located inside the
center storage console. On 6passenger
models, the second outlet is located in
the flip/fold console. Use them to power
cellular phones, CB radio, etc. See your
Owner Manual for full safety and war
ranty cautions.
See Section 3 of your Owner Manual.
Automatic Door Locks
Auto Door Lock
The automatic door locks will automati
cally lock the vehicle’sdoors when all
doors are closed and the vehicle is shift
ed into Drive. This feature can be turned
off or on by pressing the (Option) but
ton on the Driver Information Center
(DIC) until “Auto Door Lock” appears on
the display. Press the (Set/Reset)
button to scroll between Offand On.
Press the button to select your choice.
Hanging Garments
Use the rear assist handle or coat
hook to secure clothing on hangers for
transport.
Auto Door Unlock
If the Auto Door Lock feature is turned
on, you may also select the Auto Door
Unlock feature. Automatic door unlock
ing may be turned off, used only for the
driver’s door or for all of the doors.
Press the button on the DIC until “Auto
Door Unlock” is displayed; and then
press the button to scroll through
Off, Driver and All. If Driver or All is
selected, two additional choices —
“KeyOut” and “Park” — will be dis
played. Select one of these choices to
determine when the vehicle’s door(s)
will automatically unlock.
See Section 3 of your Owner Manual.