buttons BUICK LACROSSE 2007 Get To Know Guide

A.Air Outlets
B.Interior Lamps Control
C.Exterior Lamps Control/Fog Lamp
Control
D.Turn Signal/Multifunction Lever
ECruise Controls
F.Instrument Panel Cluster G.DIC Buttons (if equipped)/Hazard
Warning Flasher Button
H.Passenger Airbag Status Indicator
I.Audio System Controls
J.Hood Release
K.Parking Brake
L.Tilt Lever (if equipped)M.Horn
N.Audio Steering Wheel Controls
(if equipped)
O.Shift Lever
P.Accessory Power Outlet
Q.Climate Controls
R.Glove Box
Getting to Know YourLaCrosse2
Instrument Panel
See Section 3 of your Owner Manual.
DRIVER INFORMATION
LaCrosse 2007 A.qxd 4/25/06 11:14 AM Page 2

Getting to Know YourLaCrosse6
Unlocking the Doors with the Key
Your vehicle’s passenger doors can be
unlocked using the driver’s door key.
With the key in the lock cylinder:
• Turn the key toward the front of the
vehicle to unlock the driver’s door.
• Turn and hold the key toward the
front of the vehicle for two seconds
to unlock all doors.
•Turn and hold the key toward the rear
of the vehicle to lock all doors.
See Section 2 of your Owner Manual.
SAFETY & SECURITY
Automatic Door Locks
Auto Door Lock
The automatic door locks will lock the
vehicle’s doors when all doors areclosed and the vehicle is shifted intoDrive.
Auto Door Unlock
Automatic door unlocking options
include off, unlocking the driver’s door
or unlocking all doors. Press the button on the DIC until Auto Door
Unlock is displayed; and then press
the button to scroll through Off,
Driver and All. If Driver or All is selected,two additional choices — KeyOut andPark — will be displayed. Select one ofthese choices to determine when the
vehicle’s door(s) will automaticallyunlock.
See Section 3 of your Owner Manual.
Exterior Light Delay— Sets the time
for exterior lights to remain on after thekey is removed from the ignition or thevehicle is unlocked with the Remote
Keyless Entry transmitter. To program:
1. From the Personal Program menu,
press the (Option) button until
EXTLIGHT DELAY is displayed.
2. Press the (Set/Reset) button to
scroll through OFF or 15/30/60/90second delays.
3. Press the button to store a setting.
You can also use the (Option) and
(Set/Reset) buttons to personalize
each of the following:
• Return settings to factory default/
reset all keys
• Interior lights on when key is
removed from the ignition
• Content theftdeterrent system on/off
Exiting Programming Mode:The DIC
exits programming mode when:
• The vehicle is shifted out of Park.
• The vehicle is no longer in Run.
See Section 3 of your Owner Manual.
LaCrosse 2007 A.qxd 4/25/06 11:14 AM Page 6

Getting to Know YourLaCrosse12
CONVENIENCE
Remote Vehicle Start
(if equipped)
Use the Remote Keyless Entry transmit
ter (key fob) to start the engine fromoutside the vehicle. (See the Driver
Information Center personalization menu
section to enable.) Automatic Climate
Control system vehicles will regulate the
inside temperature.
To remote start the vehicle:
1. Press and release the key fob Lock
button.
2. Press and hold the (Remote Start)
button until the turn signal lights flash.If the lights are not visible, hold theRemote Start button for four secondsand release.
The engine runs for 10 minutes. Extend
run time for 10 minutes from present bypressing the Lock and Remote Start but
tons again. Pressing only the Remote
Start button again will turn off the ignition. Maximum run time is 20 minutes.
After two remote starts have been pro
vided, the Remote Vehicle Start featurewill not operate.
See Section 2 of your Owner Manual.
Finding a Category Station
(if equipped)
Category (CAT) stations are available on
XM1 or XM2 bands only. To find a CATstation:
1. Press the CAT button to activate
Program Type (PTY) Select mode.
2. A category is displayed.
3. Rotate the Tune knob. When the
preferred category appears, press theSeek button to go to the first categorystation (pressing Seek for more thantwo seconds will activate CategoryScan).
4. To go to another station, press the
CAT button. The previously storedcategory will be displayed.
5. Press the up or down Seek button.
6. Press the CAT button to exit Program
Type Select mode.
Audio Steering Wheel Controls
(if equipped)
See Audio Systems for full details about
the functions of the following buttons:
•
(Seek)
•BAND
•1–6 (Preset Stations)
•(OnStar®/Mute):Press to silence
audio, and again to play. In OnStar
equipped vehicles, press to interactwith the OnStar system.
•
(VOLUME):Press up/down
arrow to increase/decrease volume.
See Section 3 of your Owner Manual.
LaCrosse 2007 A.qxd 4/25/06 11:14 AM Page 12

The cruise control buttons, located on
the steering wheel, include the followingfunctions:
(On/Off): Press this button to turn
the cruise control system on or off.
+ RES (Resume/Accelerate): Press
this button toresume a setspeed, or toincrease the setspeed when thesystem is active.
– SET (Set):Press this button
to set a speed, orto decrease theset speed whenthe system isactive. When thecruise control isset, the Cruiselight will illuminateon the instrumentpanel cluster.
(Cancel):Press this button to can
cel the set speed. The set speed willremain in memory. Applying the brakes
will also cancel the set speed.
See Section 3 of your Owner Manual.
Getting to Know YourLaCrosse14
Cruise Control
The windshield wipers/washer controls
are located on the multifunction lever onthe left side of the steering wheel.
(Mist):For a single wipe, twist the
band on the multifunction stalk down tothis position and release.
(Off):Twist the band to this position
to turn off the wipers.
(Delay):Twist the band up to set the
delay time (the top of the band equals ashorter delay).
(Low):Twist the band up to this
position for lowspeed wipers.
(High):Twist the band up to this
position for highspeed wipers.
(Washer):To spray washer fluid,
turn the paddle at the top of the multi
function lever forward and release.There will be a slight delay before the
wipers are activated. This is normal andallows the washer to clean the entirewindshield.
See Section 3 of your Owner Manual.
Windshield Wipers/Washer
LaCrosse 2007 A.qxd 4/25/06 11:14 AM Page 14