wipers BUICK LESABRE 2004 Get To Know Guide

Turn Signal/Multifunction Lever
Windshield Wiper Controls
MIST
Turn the WIPER band toward you and
release it for a single wipe cycle. For
more cycles, hold the band on MIST
longer.
WASH
Push the washer PUSH tab to spray
washer solvent on the windshield.
Moisture-Sensing Delay Windshield
Wipers (optional)
The moisture-sensing wiper system
monitors the moisture on the windshield The headlamps, parking and backup
lamps will illuminate when you press the
unlock symbol on the keyfob
transmitter.
See Section 3 of your Owner Manual.
Getting to Know Your2004 LeSabre10
Lamp Controls
Interior Lamps
See Section 3 of your Owner Manual for
interior lamp operating instructions.
Daytime Running Lamps
The Daytime Running Lamps will come
on when the ignition is ON, the head-
lamp switch is OFF, and the transaxle is
not in PARK (P).
Twilight Sentinel
This feature automatically switches the
headlamps on and off by sensing how
dark it is outside. You should not have to
manually turn the headlamps on or off.
The Twilight Sentinel control lever is
located to the left of the steering
column. To operate it, slide the lever
from OFF to MAX to adjust the
headlamps ON time from a few seconds
to 3 minutes, after the ignition has been
turned OFF.
Perimeter Lighting
Notice:Driver #1 and Driver #2 key
fob settings are unique. Refer to DIC
Programming.
15778 LeSABRE GUIDE 5/22/03 1:55 PM Page 10

11
and adjusts the wipers accordingly. The
wipers will wipe once to indicate that this
feature is on.
Activate the Moisture-Sensing System
Turn the WIPER band to one of the five
sensitivity levels within the DELAY area.
The wipers will make one wipe to indi-
cate it is on. The DELAY position clos-
est to OFF/MIST is the lowest sensitivity
setting and allows more rain to accumu-
late before the wipers actuate. Rotating
the WIPER band away from you will
increase the sensitivity and frequency of
wipes.
See Section 3 of your Owner Manual.
Cruise Control
Set Cruise Control
The cruise control buttons are located
on the steering wheel. Press the
ON/OFF button to turn cruise control on.
Accelerate to the speed you want
to set.
Press the SET/COAST button. The
cruise control light on the instrument
cluster will illuminate. Remove your foot
from the accelerator pedal.
Notice:Turn the wiper band to OFF
to avoid wiper damage when going
through an automatic car wash.
Resume Set Speed
Applying the brakes will turn the cruise
control off.
Press the RESUME/ACCEL button. The
vehicle’s preset speed will resume.
OFF
Press ON/OFF or step on the brake
pedal.
See Section 3 of your Owner Manual.
Headlamps — High Beam
High/Low Beam Changer
Pull the turn signal lever toward you until
it clicks to change from low beam to
high beam.
Flash-To-Pass
Pull and hold the turn signal lever toward
you briefly to flash the headlamps.
See Section 3 of your Owner Manual.
15778 LeSABRE GUIDE 5/22/03 1:55 PM Page 11