alarm BUICK LUCERNE 2007 Get To Know Guide

(Unlock): Press this
button to unlock the driver’s
door. Press it again within
five seconds to unlock allremaining doors. The
approach lighting can beprogrammed using the DIC.(Lock): Press this button
when all doors are closed toimmediately lock all the doors.RKE feedback (light flashand/or horn chirp) can be programmed using the DIC.
If the Delayed Lock feature is
enabled and the Lock buttonis pressed while any door isopen, the doors will not lockfor approximately 10 seconds.
Remote Vehicle Start (if equipped) and Remote Keyless Entry
(Remote Vehicle Start): This feature
can be used to start the engine from outside
the vehicle. The remote start capability mustbe turned on using the Driver InformationCenter (DIC).
To remote start the vehicle:
1. Aim the transmitter at the vehicle.
(Extended remote start transmitter
range is within 196 feet (60 meters) of
the vehicle.)
2. Press and release the Lock button on the
transmitter.3. Immediately press and hold the Remote
Start button for about four seconds. Whenthe vehicle starts, the parking lamps will
light. The engine will continue running for10 minutes.
4. Repeat these steps for a 10minute time
extension. Only two consecutive remotestarts are allowed.
When you enter the vehicle after a remote
start, the key must be inserted in the ignitionand turned to the Run position before driving.
5
Your Remote Keyless Entry (RKE) transmitter allows you to lock and unlock your vehicle and
perform other functions from up to 60 feet away from the vehicle.
(Remote Trunk
Release): Press this button
to release the trunk lid. Thetrunk may also be opened by
pressing the Trunk Release button on the left side of theinstrument panel.
See Section 2 of your Owner Manual.
(Remote Alarm):Press this button to sound
the alarm. The horn will
sound and the headlampswill flash for two minutes.Press the button again orturn the ignition key to theRun position to cancel thealarm. The vehicle must be
turned off to use the alarm.
SAFETY & SECURITY