lights BUICK SKYLARK 1993 Owners Manual

Vehicle Symbols
These are some of the symbols you will. find -on your vehicle.
For example,
these symbols
are used on an
original battery:
CAUTION
INJURY
PROTECT EYES BY
SHIELDING
Q
CAUSTIC
ACID COULD CAUSE
BA~~RY
BURNS AVOID
SPARKS
OR
FLAMES
SPARK
OR ,\I/,
COULD pq
FLAME
EXPLODE BATTERY
These symbols
are important
for you and
your passengers
whenever your
vehicle- is
driven:
FASTEN SEAT 4
BELTS
POWER
WINDOW
These symbols
have to do with
your lights:
SIGNALS e 9
TU-RN
HIGH BEAM
OR = =o
FOG LAMPS # 0
These symbols
are on some of
your controls:
WINDSHIELD ' ' '
. WASHER
CI 0s
-tO -1
WINDSHIELD
WASHER 8
wI*DsHIELDw DEFROSTER
WINDOW
Ltft,
REAR
DEFOGGER
VENTILATING FAN
3f
HEADLAMP -
WIPER
WASHER
EQ
L
~
These symbols
are used
on
warning and
indicator lights:
COOLANT F-
TEMP *-
ENGINE
CHARGING BATTERY
SYSTEM
RADIATOR
a
COOLANT
FUEL @
ENGINE OIL e,
PRESSURE
TEMP
OIL &
ANTILOCK (@)
BRAKE
Here are some
other symbols
you may see:
FUSE
RAD10 k
VOLUME
CONDITIONING
AIR e
HATCHBACK TRUNK
RELEASE
LIGHTER
1-i
HORN
SPEAKER
12

Adjustable Ride Control System
(Option)
adjusts to a medium ride.
0 Sport - This provides a firm, sporty ride with
This suspension system option allows the driver to
adjust the ride comfort according to road conditions.
To select a ride comfort option, push one of these three
1 buttons:
i Soft - This provides a smooth, comfortable ride.
0 Auto - This setting automatically adjusts the system.
While traveling at speeds under
47 mph (75 km/h),
the system will adjust to the soft ride. Traveling at
speeds faster than
47 mph (75 km/h) the system
responsive handling and cQrnering.
When Auto or
Soft is selected, the system begins in the
Sport mode. It will also automatically change back to
the Sport mode when the vehicle _---lkes anabrupt start,
stop or a sharp turn.
The indicator lights for all the buttons will come on for about
5 seconds after the ignition is started as a system
check.
If all the indicator lights come on and stay on,
there may be a problem.
You should have your vehicle
inspected.

Ihrn Signal tCONSS Chime
A chime will sound if your turn signal is left on after
having gone
3/4 of a mile, to remind you to turn your
signal
off.
Operation of Lights
Although your vehicle’s lighting system (headlights,
parking lights, fog lamps, side.marker lights and
taillights) meet all applicable federal lighting
requirements, certain states and provinces may apply their own lighting regulations that may require special
attention before you operate these lights. For example,
some jurisdictions may require that you operate your
lower beam lights with fog lamps at all times, or that
headlights be turned on whenever you must use your
windshield wipers. In addition, most jurisdictions
prohibit driving solely with parking lights, especially at
dawn or dusk. It
is recommended that you check with
you own state or provincial highway authority for
applicable lighting regulations.
Headlight High-Low Beam
To change the headlights
from low beam to high or
high to low, pull the turn
signal lever all the way
toward you. Then release it.
When the high beams are
on, this blue light on the
instrument panel also will
be on.
Flash-To-Pass Feature
It lets you use your high beam headlights to signal a driver in front of you that you want to pass. It works
even
if your headlights are off.
To use it, pull the multifunction lever toward you a little
(but not
so far that you hear a click).
If your headlights are off Your high beam headlights
will
turn on. They’ll stay on as long as you hold the
lever there. Release the lever to turn them
off.
90
I

If your headlights are on, but on low beam: The
system works normally. Just pull the lever until it clicks.
Your headlights will shift to high beam and stay there.
To return to low beam, just pull the lever toward you.
Windshield Wipers
You control the windshield wipers by moving the lever
marked
“WIPER.”
For a single wiping cycle, move the lever down to
“MIST.” Hold it down until the wipers start, then let go.
The wipers will stop after one cycle. If you want more
cycles, hold the lever down to “MIST” longer.
i
For steady wiping at low speed, move the lever to the
“LOW’ position. For high speed wiping, move the lever
further, up to “HIGH” To stop the wipers, move the
lever to “OFF.”
Low Speed Delay Wipers (Option)
You can set the wiper speed for a long or short delay
between wipes. This can be very useful in light rain or
snow. Move the lever to DELAY then, turn the band to
choose the amount of delay.
I A CAUTION:
Damaged wiper blades may prevent you from
seeing well enough
in a storm to drive safely. To
avoid damage, be sure to clear ice and snow
from the wiper blades before using them.
If
they’re frozen to the windshield, carefully loosen
or thaw them.
If your blades do become
damaged, get new blades or blade inserts.

Lights
The headlight switch is located on the control left of the
steering column. To turn on your lights, turn the band
marked LIGHTS.
It controls these light systems:
0 Headlights
0 Taillights
Parking Lights
0 License Lights
Sidemarker Lights The interior courtesy lights can be turned on by rotating
the control located
on the instrument panel
to MAX.
The instrument panel brightness can be adjusted
between MIN and MAX by rotating the control also.
Battery Run-down Protection
This feature is made up of two functions. They are
inadvertent power control and parasitic power control. If
vehicle battery is disconnected for any reason the system
timers will change to
3 minutes and 3 days respectively
until the vehicle is driven 15 miles.
77

Headlights Reminder Light (Canada Only)
If your vehicle was first sold, when new, in Canada, this
light will
go on at night to remind you to turn on the
headlights.
Daytime Running Lights (Canada Only)
The Canadian Federal Government has decided that
“Daytime Running Lights” (DRL) are
a useful feature,
in that DRL can make your vehicle more visible to
pedestrians and other drivers during daylight hours.
DRL are required on
new vehicles sold in Canada.
Your DRL work with
a light sensor on top of the
instrument panel. Don’t cover it up.
The high beam headlights will come on at reduced
brightness in daylight when:
The ignition is on
The headlight switch is off, and
The parking brake is released.
At night, the headlights reminder light on the instrument
panel will come on to remind
you to turn on the
headlights. When
you turn on your headlights, the DRL
will switch
off and the exterior lights will come on.
When
you turn off the headlights, the exterior lights will
go out and the high beams will change to the reduced
brightness of DRL again. Of course, you may still turn on the headlights
or flash to pass any time you need to.

Courtesy Lights
When any door is opened, several lights go on. They
make it
easy for you to enter and leave the car. You also
can turn these lights on by rotating the interior light
control to
MAX.
The rear compartment lamp is also activated when the
doors are opened, the deck lid is opened
or when the
interior light control is rotated to
MAX.
Interior Lights Delay
On entry, the interior lights stay on, even after the door
is closed to give you time to find your keys
or controls.
The interior'lights go
off automatically when the
ignition is turned on, or after approximately
40 seconds.
This
40 second delay is disabled if the ignition has been
off less than
2 minutes. The interior lights will also go
on for
4 seconds if you pull on the door handle from the
inside trying to open a locked door.
Mirrors
Inside Mirror
When you are sitting.in a comfortable driving position,
adjust the mirror
so you can see clearly behind your car.
The day-night adjustment allows you to adjust the mirror
to avoid glare from the lights behind you.
102

Warning Lights, Gages and
Indicators
This section describes the warning lights and gages that
may be on your vehicle. The pictures will help you
locate them.
Warning lights and gages can signal that something is wrong before it becomes serious enough to cause an
expensive repair or replacement. Paying attention to
your warning lights and gages could also save you or
others from injury.
Warning lights go on when there may be or is a problem with one of your vehicle’s functions.
As you will see in
the details
on the next few pages, some warning lights
come on briefly when you turn the ignition key just to
let you know they’re working. If you are familiar with
this section, you should not be alarmed when this
happens.
Gages can indicate when there may be or is a problem
with one of your vehicle’s functions. Often gages and
warning lights work together to let you know when
there’s a problem with your vehicle. When
one
of the warning lights comes on and stays on
when you are driving, or when one of the gages shows
there may be a problem, check the section that tells you what to do about it. Please follow the manual’s advice.
Waiting to do repairs can be costly
-- and,even
dangerous.
So please get to know your warning lights
and gages. They’re a big help.
Fuel Gage
Your fuel gage shows how much fuel is in your tank. It
works only when the engine is on. When the indicator
nears
“E,” you still have a little fuel left. You need to get
more right away.

Traffic Lights
We’re all familiar with traffic lights or stop lights. Often
green arrows are being used in the lights for improved
traffic control. On some multilane roads, green.arrows
light up, indicating that traffic in one or more lanes can
move or make a turn. Green arrows don’t mean “go no
matter what.” You’ll still need to proceed with caution,
yielding the right of way to pedestrians and sometimes
to other vehicles.
Some traffic lights also use red arrows to signify that
you must stop before turning on red.
REVERSIBLE
LANE ON
LANE
ROADWAY
M U LTI-
Many city roads and expressways, and even bridges, use
reversible-lane traffic control during rush hours.
A red X
light above a lane means no driving in that lane at that

time. A green arrow means you may drive ir&that lane. ’
and days these systems are in effect. -,i ““ ff. 4 -’ ~‘’ - .. :
1 Look for the signs posted to warn drivers. what bQ.urs. .. . ,.
1 Pavement Markings
NO
PASSING I’
Pavement markings add to traffic signs and signals.
They give information to drivers without taking
attention from the roadway. A solid yellow line on your
side of the road or lane means “don’t cross.”
Your Own Signals
..
Drivers signal to others, too. It’s not only mare polite,
it’s safer
to let other drivers know what you are doing.
And in some places the law requires iver si.gnals.
L. ..
Turn and lane change signals. Always signal: when you
plan to turn or change lanes.
If necessary, you can use hand signals out the window:
Left arm straight out for a left turn, down for slow or
about-to-stop, and up for a right turn.
Slowing down. If time allows, tap the brake pedal once
or twice in advance of slowing or stopping. This warns
the driver behind you.
Disabled. Your four-way flashers signal that your
vehicle is disabled or
is a hazard. See “Hazard Warning
Flashers” in the Index.
Traffic Officer
The traffic police officer is also a source of important
information. The officer’s signals govern, no matter
what the traffic lights or other
signs say.
The next section discusses some of the Toad conditions
you may encounter.
._ . .-_. ;: , , .c**“jy;, “C.$ -,a,, ..,... ’ : ., - , . ,.> p :, , ,. . +.
Defensive Driving $@, *-<; .I i.?;’ * i.
, +& ’ . i *. , .. . I I- ., I.. .. \e. . *, ,
The best advice anyone can give about\driving is: Drive
defensively.
Please
start with a very important safety device in your
Buick: Buckle up. (See “Safety Belts” in the Index.)