instrument cluster CADILLAC CATERA 2001 1.G Owners Manual
[x] Cancel search | Manufacturer: CADILLAC, Model Year: 2001, Model line: CATERA, Model: CADILLAC CATERA 2001 1.GPages: 328, PDF Size: 2.72 MB
Page 95 of 328
2-28
Upshifting and downshifting of the transmission is
automatically modified to prevent undesired shifting
when your vehicle is towing a trailer or when you
are driving in hilly or mountainous terrain.
This is also normal.
Sport Mode Button
For a firmer shift and
increased performance, you
may choose the sport mode.
This button lets you change
from a normal driving mode
to a sport driving mode.
It is located on the shift
lever handle.Press the ªSº button once to select the sport feature.
Press it again to return to the normal driving mode.
When you start the engine, your vehicle will be in
normal mode. For general driving conditions, use the
normal mode. It will remain in normal unless you select
the sport feature.This light on the instrument
panel cluster will come
on when the sport mode
is selected.
If this light begins flashing while you are driving,
there may be a fault in the automatic transmission.
Have your vehicle serviced.
Page 105 of 328
2-38 Turn and Lane Change Signals
To signal a turn, move the turn signal/multifunction
lever all the way up or down. The lever returns
automatically when the turn is complete.
This arrow on the
instrument panel cluster
will flash in the direction of
the turn or lane change.
Raise or lower the lever until the arrow starts to flash to
signal a lane change. Hold it there until the lane change
is complete. The lever returns when it is released.
Arrows that flash rapidly when signaling for a turn or
lane change may be caused by a burned
-out front signal
bulb. (This does not occur with a burned
-out rear bulb).
Other drivers won't see the turn signal. Replace
burned
-out bulbs to help avoid possible accidents.
Check the fuse (see ªFuses and Circuit Breakersº in the
Index) and for burned
-out bulbs if the arrow fails to
work when signaling a turn.
Headlamp High/Low Beam
With the Twilight Sentinel on or with the lamp
control dial turned to the headlamp position, push the
turn signal/multifunction lever on the driver's side of
the steering wheel away from you to turn on the
high
-beam headlamps.
This light on the instrument
panel cluster will be on,
indicating high
-beam usage.
Pull the lever back to the original position to return to
low
-beam headlamps. For more information, see
ªHeadlampsº in the Index.
Flash-To-Pass
This feature uses the high-beam headlamps to signal the
driver in front of you that you want to pass. This feature
will work with either the headlamps on or off.
To use, pull the turn signal lever toward you and release.
Page 107 of 328
2-40 Windshield Washer
Pull and hold the washer
lever towards you to wash
the windshield. Release the
lever when you have
enough fluid. The wipers
will clear the windshield
and either stop or return to
your preset speed.
CAUTION:
In freezing weather, don't use your washer until
the windshield is warmed. Otherwise the washer
fluid can form ice on the windshield, blocking
your vision.
This light on the instrument
panel cluster will be
displayed when the washer
fluid reaches a low level.
See ªLow Washer Fluid Warning Lightº in the Index for
more information.
Page 115 of 328
2-48
If you're not in PARK (P)
and the Twilight Sentinel
system is turned off (and it's
dark enough outside), the
DRL will remain active and
this light on the instrument
panel cluster will appear.
This is a reminder that headlamps are required.
The following conditions will override the DRL:
The vehicle's transmission is shifted back into
PARK (P) with the ignition in ON or START,
the low
-beam headlamps are turned on
(using the manual lamp knob),
the wiper
-activated headlamps are in use
(DRL will come back on 20 seconds after
wipers have turned off),
the flash
-to-pass feature is in use, or
the Twilight Sentinel is turned on.
As with any vehicle, you should turn on the regular
headlamp system when you need it.
Fog Lamps
Use the fog lamps for better
vision in foggy or misty
conditions. Press this button
to turn the fog lamps on and
press the button again to
turn the lamps off. (The fog
lamps only work when the
parking lamps or the
low
-beam headlamps are
on and the ignition is on.)
This light on the instrument
panel will come on
when the fog lamp button
is pressed.
If you turn on the high
-beam headlamps, the fog lamps
will turn off. They'll turn back on again when you
switch to low
-beam headlamps.
Page 116 of 328
2-49 Cornering Lamps
The cornering lamps come on when the headlamps
or parking lamps are on and you signal a turn.
They provide more light for cornering.
Twilight Sentinel
This feature is located
below the lamp dial on the
left side of the instrument
panel. It automatically turns
the parking lamps and
low
-beam headlamps on
and off by sensing how
dark it is outside.
To operate the Twilight Sentinel, the ignition must be in
ON or START and the Twilight Sentinel must be turned
on by pressing the OFF button (the indicator light in the
button will be off when the Twilight Sentinel is
activated). If the system senses it is dark enough outside,
the lamps will turn on. The lamps turn off when the
system detects that it is bright enough outside.If you turn the knob all the way up, the lamps will
remain on for about three minutes after the ignition has
been turned to OFF or LOCK. If you turn the knob
all the way down, the lamps will go off quickly.
You can adjust the delay time from a few seconds
up to three minutes.
To turn the Twilight Sentinel off, press the OFF button
again. The indicator light in the button will be on. This
lets the driver know that the system has been turned off.
The Twilight Sentinel also turns off if the ignition is
turned to OFF or to LOCK.This light in the instrument
panel cluster will come on if
the ignition is on and:
the headlamps have not been manually turned on,
the Twilight Sentinel senses it is dark
enough outside,
the Twilight Sentinel is OFF and
the transmission is not in PARK (P).
Page 136 of 328
2-69
A. Air Outlets
B. Turn Signal/Multifunction Lever
C. Instrument Panel Cluster
D. Windshield Wiper/Washer Lever
E. Comfort Controls
F. Lamp Controls
G. Horn
H. Steering Wheel Touch Controls for Audio System
I. Hood ReleaseJ. Heated Front Seat Control (Option)
K. Hazard Warning Flasher Button
L. Fuel Door Release Button
M. Ashtray
N. Radio
O. Trunk Release Button
P. Rear Power Sunshade Button (Option)
Q. Traction Control On/Off Button
R. Glove Box
Page 137 of 328
2-70 Instrument Panel Cluster
The instrument panel cluster is designed to let you know at a glance how your vehicle is running. You'll know how
fast you're going, how much fuel you're using and many of the other things you'll need to know to drive safely and
economically. The main components of the instrument panel are:
United States version shown, Canada similar
Page 138 of 328
2-71 Speedometer and Odometer
The speedometer lets you see your speed in both
miles per hour (mph) and kilometers per hour (km/h).
The odometer shows how far your vehicle has been
driven, in either miles (used in the United States) or
kilometers (used in Canada).
Trip Odometer
The trip odometer tells how far you have driven since
you last reset it. To set it to zero, press the knob located
below the speedometer on the instrument panel cluster.
Tachometer
This gage indicates the
engine speed in revolutions
per minute (rpm).
NOTICE:
Do not operate the engine with the tachometer in
the red area or engine damage may occur.
Engine Speed Limiter
This feature prevents the engine from operating at too
many revolutions per minute (rpm). When the engine's
rpm are critically high, the fuel supply to the engine
is shut off. When the engine speed slows, the fuel
supply will come on again. This helps prevent damage
to the engine.
Page 310 of 328
6-59
Fuse Usage
4 RH and LH Rear Seat Cushion
Heater Relay, Rear Sunshade
Motor, Accessory Power Outlet
5 Transmission Control Module
6 Radio Speaker Amplifier
7 RH and LH Rear Side Door
Window Regulator Motor
8 Headlamp Switch, Turn Signal
Switch, Horn Relay, CD Changer,
Multifunction Relay
9 Windshield Wiper Motor and
Relay, Windshield Wiper and
Windshield Washer Switch
10 Body Control Module (BCM),
Heater Water Auxiliary Pump,
Fan Control Relays, Auxiliary
Water Pump Relay
11 Heater and A/C Control, RH and
LH Outside Rearview Mirrors
12 Hazard Warning Switch,
Instrument Cluster, Data Link
Connector (DLC), Stoplamp
Switch, Gage Cluster,
Heater and A/C Control.Fuse Usage
13 Remote Control Outside Rearview
Mirror Switch, A/C Compressor
Relay, Coolant Fan Test
Connector, A/C Load Switch
14 Cellular Telephone, RH and LH
Windshield Washer Nozzles,
Driver and Passenger Heated Seat
Switch, Heater and A/C Control,
Heated Outside Rearview Mirror
and Rear Window Defogger Relay
15 Rear Suspension Leveling Air
Compressor Relay, Instrument
Cluster, Gage Cluster, Cruise
Control Switch, Headlamp Switch,
Multifunction Relay, Passenger
and Driver Heated Seat Relay,
BCM, Sunroof Actuator,
Automatic Level Control Sensor,
RH and LH Heated Rear Seat
Switch, RH and LH Heated Rear
Seat Cushion Relay, Driver Seat
Adjuster Memory Module, LH
Front Side Door Window Switch,
Inside Rearview Mirror