window CADILLAC CTS 2003 1.G Owner's Manual

2-62
Compass Variance
Compass variance is the difference between earth's
magnetic north and true geographic north. If the mirror
is not adjusted for compass variance, your compass
could give false readings.
The mirror is set in zone eight upon leaving the factory.
It will be necessary to adjust the compass to compensate
for compass variance if you live outside zone eight.
Under certain circumstances, such as a long distance,
cross
-country trip, it will be necessary to adjust the
compass variance.
To adjust for compass variance, do the following:
1. Find your current location and variance zone number
on the zone map that follows.
2. Press and hold the on/off button until a zone number
appears on the display.
3. Once the zone number appears on the display, press
the on/off button quickly until you reach the correct
zone number. Stop pressing the button and the mirror
will return to normal operation. If C appears in the
compass window, the compass may need calibration.
See ªCompass Calibrationº listed previously.

2-64
Curb View Assist Mirror (If Equipped)
If your vehicle is equipped with the memory seat and
mirrors, it will also be capable of performing the curb
view assist mirror feature. This feature will cause the
passenger's mirror to tilt to a preselected position when
the vehicle is shifted into REVERSE (R). Use this
feature to view the curb when you are parallel parking.
When the vehicle is shifted out of REVERSE (R) and a
five
-second delay has occurred, the passenger's mirror
will return to its original position.
If further adjustment is needed after the mirror is
tilted, the mirror controls can be used. See ªPower
Outside Rearview Mirrorsº listed previously for
more information.
This feature can be enabled/disabled through the DIC.
See ªVehicle Programming and Personalization
Featuresº in the Index for more information.
Convex Outside Mirror
Your passenger's side mirror is convex. A convex
mirror's surface is curved so you can see more from the
driver's seat.
CAUTION:
A convex mirror can make things (like other
vehicles) look farther away than they really are.
If you cut too sharply into the right lane, you
could hit a vehicle on your right. Check your
inside mirror or glance over your shoulder before
changing lanes.
Heated Outside Rearview Mirrors
When you operate the rear window defogger, it also
warms both outside rearview mirrors to help clear them
of fog or ice. See ªRear Window Defoggerº in the Index
for more information.

2-107
Battery Saver Active
This symbol appears
with the Battery Saver
Active message.
This message appears when the system detects that the
battery voltage is dropping beyond a reasonable level.
The battery saver system will start reducing certain
features of the vehicle that you may not be able to
notice. At the point that the features are disabled, this
message is displayed. It means that the vehicle is trying
to save the charge in the battery.
Turn off all unnecessary accessories to allow the battery
to recharge.
The normal battery voltage range is 11.5 to 15.5 volts.
You can monitor battery voltage on the DIC by pressing
the INFO button until you find BATTERY VOLTS
(base audio system) or by selecting Battery Voltage
from the Vehicle Info menu (Navigation system).Battery Voltage HighThis symbol appears
with the Battery Voltage
High message.
This message indicates that the electrical charging
system is overcharging the battery. When the system
detects that the battery voltage is above approximately
16 volts, this message will be displayed.
To reduce the charging overload, use the vehicle's
accessories. Turn on the exterior lamps and radio, set the
climate control on AUTO and the fan speed on the
highest setting, and turn the rear window defogger on.
The normal battery voltage range is 11.5 to 15.5 volts
when the engine is running. You can monitor battery
voltage on the DIC by pressing the INFO button until
you find BATTERY VOLTS (base audio system) or by
selecting Battery Voltage from the Vehicle Info menu
(Navigation system).

2-149
To change the mode using the Navigation system, do the
following:
1. Enter the Personalization menu following the
instructions listed previously.
2. Scroll to Delayed Locking using the TUNE/SEL
knob to highlight it.
3. Press the TUNE/SEL knob to switch back and forth
between on and off.
When the mode is turned on, an X will appear in the
box to the left.
The mode you selected is now set. You can either exit
the programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
Lock Passenger Window
This feature allows you to disable either all the
passenger window switches or the rear passenger
window switches only. If this feature is turned on, all
passenger window switches will be disabled when the
window lockout button is pressed. If the feature is off,
only the rear passenger window switches will be
disabled. See ªPower Windowsº in the Index for
more information.Programmable Modes
Mode 1: ON
Mode 2: OFF
Before your vehicle was shipped from the factory, it was
programmed to Mode 2. The mode to which the vehicle
was programmed may have been changed since it left
the factory. To determine the mode to which the vehicle
is programmed or to program the vehicle to a different
mode, use one of the following procedures:
To change the mode using the Base audio system, do the
following:
1. Enter the personalization portion of the SETUP
menu following the instructions listed previously.
2. Scroll to LOCK PASS WINDOW using the
TUNE/SEL knob to highlight it.
3. Press the TUNE/SEL knob to switch back and forth
between on and off.
When the mode is turned on, a check mark will
appear next to the feature name.

2-150
To change the mode using the Navigation system, do the
following:
1. Enter the Personalization menu following the
instructions listed previously.
2. Scroll to Lock Passenger Window using the
TUNE/SEL knob to highlight it.
3. Press the TUNE/SEL knob to switch back and forth
between on and off.
When the mode is turned on, an X will appear in the
box to the left.
The mode you selected is now set. You can either exit
the programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
Mirror to Curb in Reverse (If Equipped)
This feature will move the passenger's outside rearview
mirror to a curb view position when the shift lever is
shifted into REVERSE (R), and it will return the mirror
to the last known driving position when the shift lever is
moved out of REVERSE (R). See ªCurb View Assist
Mirrorº in the Index for more information.Programmable Modes
Mode 1: ON
Mode 2: OFF
Before your vehicle was shipped from the factory, it was
programmed to Mode 2. The mode to which the vehicle
was programmed may have been changed since it left
the factory. To determine the mode to which the vehicle
is programmed or to program the vehicle to a different
mode, use one of the following procedures:
To change the mode using the Base audio system, do the
following:
1. Enter the personalization portion of the SETUP
menu following the instructions listed previously.
2. Scroll to MIRROR TO CURB IN REV using the
TUNE/SEL knob to highlight it.
3. Press the TUNE/SEL knob to switch back and forth
between on and off.
When the mode is turned on, a check mark will
appear next to the feature name.

3-
3-1
Section 3 Comfort Controls and Audio Systems
In this section, you'll find out how to operate the comfort control and audio systems offered with your vehicle.
Be sure to read about the particular systems supplied with your vehicle.
3
-2 Comfort Controls
3
-2 Climate Control System
3
-6 Air Conditioning
3
-6 Defogging and Defrosting
3
-6 Rear Window Defogger
3
-7 Ventilation System
3
-9 Climate Control Steering Wheel Controls
3
-9 Audio Systems
3
-10 Setting the Clock
3
-10 AM-FM Radio with Cassette Tape and
Compact Disc Player with Radio Data
Systems (RDS) and Digital Signal
Processing (DSP)3
-27 Navigation/Radio System (Option)
3
-27 Theft-Deterrent Feature
3
-28 Audio Steering Wheel Controls
3
-29 Understanding Radio Reception
3
-30 Tips About Your Audio System
3
-31 Care of Your Cassette Tape Player
3
-32 Care of Your Compact Discs
3
-32 Care of Your Compact Disc Player
3
-33 Diversity Antenna System

3-3

(Floor/Defrost): This setting directs airflow to
the floor ducts and toward the windshield, with some
air diverted toward the outboard outlets to defog the
side windows.


(Floor): This setting directs airflow
through the floor ducts. Some air is diverted
to the windshield and outboard outlets to
minimize fogging.
!~ (Fan): This switch adjusts the fan speed.
Press the up or down arrow to increase or decrease the
fan speed.
(Recirculation): Press this button to limit the
amount of outside air entering your vehicle. This is
helpful when you are trying to cool the air quickly or
limit odors entering your vehicle. Press this button again
to turn off the recirculation feature. If you notice the
windows fogging, turn off the recirculation feature.
Recirculation is not available in the defrost mode and
will automatically turn off after 10 minutes if
floor/defrost mode is selected.
(Defrost): Press this button to quickly remove
fog or frost from the windshield. This setting sends
most of the airflow to the windshield with a small
amount diverted to the outboard outlets to minimize
fogging. The air conditioning compressor may operate
in this mode.
A/C OFF (Air Conditioning Off): Press this button
to turn off the air conditioning compressor. AC OFF will
appear on the display. Press the button again to turn the
compressor back on. When the compressor is on, the
system will cool and dehumidify the air inside the
vehicle. The compressor cannot be turned off in
defrost mode.
(Driver's Temperature Switch): This switch is used
to adjust the air temperature for the driver's side of the
vehicle. To adjust the temperature, press the up or down
arrow located on the PWR button. The temperature will
increase or decrease with each press of an arrow.
The driver's set temperature is always displayed when
the climate control system is on regardless of whether or
not the system is in AUTO. See ªAutomatic Operationº
later in this section for more information on the
AUTO button.

3-6 Air Conditioning
On hot days, open the windows long enough to let hot
inside air escape. This reduces the time it takes for your
vehicle to cool down. Then keep your windows closed
for the air conditioner to work its best.
While the system is in AUTO, it will use recirculation
as necessary to cool the air.
Defogging and Defrosting
When the mode switch is set for floor/defrost or the
defrost button is pressed, outside air will be selected
automatically. This helps clear the windshield more
quickly. Adjust the temperature and set the fan speed to
the highest setting. When the windshield is clear, adjust
the fan speed for maximum defrosting to a lower setting
or return to AUTO mode.
Recirculation is not available in the defrost mode, and
the air conditioning compressor cannot be turned off in
this mode.
For maximum side window defogging, turn the outboard
outlet thumbwheels to the side window defogger setting.
See ªVentilation Systemº later in this section for more
information on the outlet settings.
Rear Window Defogger
When the rear window defogger is turned on, the rear
window and both outside rearview mirrors are heated to
remove fog from the surface of the glass.
The rear window defogger
button is located on the
climate control panel to the
right of the defrost button.
Press the button to turn on the rear defogger. Press the
button again to turn the system off.
The system will automatically shut off after 10 minutes
unless your vehicle is traveling more than 30 mph
(48 km/h). If further defogging is desired once the
system is off, press the button again. The system will
automatically shut off after five minutes for any cycles
after the initial activation.

3-7
Using the rear window defogger will not cancel
automatic climate control operation.
NOTICE:
Don't use a razor blade or something else sharp
on the inside of the rear window. If you do, you
could cut or damage the warming grid or the
integrated rear window antenna, and the repairs
wouldn't be covered by your warranty.
Do not attach a temporary vehicle license, tape or decals
across the defogger grid on the rear window.
Ventilation System
There are five instrument panel outlets, three in the
center and one at each end. The outlets located at each
end of the instrument panel have a feature that the center
air outlets do not. These outlets will have air flowing to
them in all modes, including defrost, when the climate
control system is on.

3-8
You can adjust the direction
of airflow by moving the
knobs in the center of the
outlets and by turning the
thumbwheel at the bottom
of the outlets. You may
choose from the
following positions:
(Side Window Defogger): Turn the thumbwheel
to this symbol on the outboard outlets to use the side
window defogger feature. The air coming through the
outlets will be directed toward the side windows to
prevent fogging.
(Open): Turn the thumbwheel to this symbol to
open the outlets completely and allow the maximum
amount of air to enter the vehicle. A small amount
of air will still be directed to the side window
defogger setting.
(Closed): Turn the thumbwheel to this symbol to
close the outlets and minimize the amount of air
entering the vehicle.
Ventilation Tips

Keep the hood at the base of the windshield and
front air inlet free of ice, snow or any other
obstruction (such as leaves). The heater and defroster
will work far better, reducing the chance of fogging
the inside of your windows.

When you enter a vehicle in cold weather, select the
highest fan setting for a few moments before driving
off. This helps clear the intake ducts of snow and
moisture, and reduces the chance of fogging the
inside of your windows.

Keep the air path under the front seats clear of
objects. This helps air to circulate throughout
your vehicle.