instrument panel CADILLAC CTS 2003 1.G Owner's Guide

2-153
Navigation (Option)
Navigation Display ControlsThe display screen is located in the center on the
instrument panel.
Your vehicle may have a turn by turn navigation
guidance system that includes a CD ROM map media
covering nine regional areas throughout the contiguous
United States and Canada. In addition, the system
includes intersection and freeway entrances, route
planning, a programmable address book, points of
interest, a list of restaurants, emergency phone numbers,
and a list of hotels and motels for all of the major cities
on the regional CDs. The navigation system can also
communicate with the Radio Data System (RDS) to
receive broadcast announcements on traffic, weather
information and emergency alert communications. For
more information on how to use this system, see the
CTS Entertainment and Navigation System Supplement.

3-2
Comfort Controls
This section tells you how to make your air system work
for you.
Manual operation of the system is described first,
followed by automatic operation. See ªAutomatic
Operationº later in this section for more information.
Climate Control System
Manual Operation
To turn the system on, press the PWR button located on
the driver's side of the climate control panel.
!~(Mode): This switch selects the direction of
the airflow through the vehicle. Press the up or down
arrow to scroll through the available modes. The symbol
for the current mode will be displayed on the climate
control panel.
Regardless of the mode selected, there will be some air
flowing to the outboard outlets unless you close the
outlet. See ªVentilation Systemº later in this section for
more information.
The following modes can be selected:


(Vent): This setting directs the airflow through
the instrument panel outlets.


(Bi-Level): This setting directs airflow into
your vehicle in two ways. Cooler air is directed to
the upper portion of your body through the
instrument panel outlets while warmer air is directed
to the floor ducts.

3-5
Interior Temperature Sensor
This sensor
monitors the interior
temperature of the
vehicle. It is located to
the right of the
steering wheel on the
instrument panel.
While the climate control system is in AUTO, the
system uses both the interior temperature sensor and the
electronic solar sensor to automatically adjust the
temperature and airflow in the vehicle. See ªElectronic
Solar Sensorº following for more information. Be sure
not to cover the sensor with anything. If you do, the
automatic climate control system will not work properly.Electronic Solar Sensor
This sensor monitors the sun's solar radiation. It is located
on top of the instrument panel near the windshield.
While the climate control system is in AUTO, the system
uses the information collected by the electronic solar
sensor to automatically adjust the temperature and airflow
to maintain your comfort. The climate control system may
supply cooler air to one side of your vehicle, if that side is
facing the sun. Be sure not to cover the sensor on top of
the instrument panel. If you do, the automatic climate
control system will not work properly.

3-7
Using the rear window defogger will not cancel
automatic climate control operation.
NOTICE:
Don't use a razor blade or something else sharp
on the inside of the rear window. If you do, you
could cut or damage the warming grid or the
integrated rear window antenna, and the repairs
wouldn't be covered by your warranty.
Do not attach a temporary vehicle license, tape or decals
across the defogger grid on the rear window.
Ventilation System
There are five instrument panel outlets, three in the
center and one at each end. The outlets located at each
end of the instrument panel have a feature that the center
air outlets do not. These outlets will have air flowing to
them in all modes, including defrost, when the climate
control system is on.

3-10 Setting the Clock
1. Press the TUNE/SEL knob to enter the main menu.
2. Turn the TUNE/SEL knob until SET CLOCK
is displayed.
3. Press the TUNE/SEL knob to select SET CLOCK.
4. Turn the TUNE/SEL knob to adjust the time setting.
5. Press the TUNE/SEL knob to update the time.
VEHICLE TIME UPDATED will appear on the
display. The time on the analog clock, located in the
instrument panel cluster, will adjust.
The time of an FM station broadcasting Radio Data
System (RDS) information will update the analog
clock automatically.
AM-FM Radio with Cassette Tape and
Compact Disc Player with Radio Data
Systems (RDS) and Digital Signal
Processing (DSP)
Six-Disc CD Player Audio System
Shown
- Single CD Player Similar

3-27
Navigation/Radio System (Option)
Navigation/Radio Display and Controls
The display screen is located in the center of the
instrument panel.Your vehicle may be equipped with an AM
-FM radio
navigation radio system that includes digital sound
processing (DSP), Radio Data System (RDS) with
program type selections (PTY) that will seek out the
kind of music you want to listen to. The radio system
can also communicate with your navigation system to
broadcast announcements on traffic, weather and
emergency alert communications. For information on
how to use this system, see the ªNavigation/Radio
Systemº supplement.
Theft-Deterrent Feature
THEFTLOCK
is designed to discourage theft of your
radio. Your vehicle has a ªbuilt
-inº theft-deterrent
feature on each radio that is automatic
-- there is no
programming required. The radio in your vehicle cannot
be used in any other vehicle. When the radio was
originally installed in your vehicle at the factory, it
stored the Vehicle Identification Number (VIN). Each
time the ignition is turned on, the VIN is verified. If the
vehicle's VIN does not match the VIN stored in the
radio, THEFTLOCK will be activated and the audio
system will not play. If the radio is removed from your
vehicle, the original VIN in the radio can be used to
trace the radio back to your vehicle.

4-39 Making Turns
NOTICE:
Making very sharp turns while trailering could
cause the trailer to come in contact with the
vehicle. Your vehicle could be damaged. Avoid
making very sharp turns while trailering.
When you're turning with a trailer, make wider
turns than normal. Do this so your trailer won't
strike soft shoulders, curbs, road signs, trees or other
objects. Avoid jerky or sudden maneuvers. Signal well
in advance.
Turn Signals When Towing a Trailer
When you tow a trailer, your vehicle may need a
different turn signal flasher and/or extra wiring. Check
with your dealer. The arrows on your instrument panel
will flash whenever you signal a turn or lane change.
Properly hooked up, the trailer lamps will also flash,
telling other drivers you're about to turn, change lanes
or stop.
When towing a trailer, the arrows on your instrument
panel will flash for turns even if the bulbs on the trailer
are burned out. Thus, you may think drivers behind you
are seeing your signal when they are not. It's important
to check occasionally to be sure the trailer bulbs are
still working.
Driving On Grades
Reduce speed and shift to a lower gear before you start
down a long or steep downgrade. If you don't shift
down, you might have to use your brakes so much that
they would get hot and no longer work well.
On a long uphill grade, shift down and reduce your
speed to around 45 mph (70 km/h) to reduce the
possibility of the engine and the transmission
overheating.

5-2
Hazard Warning Flashers
Your hazard warning flashers let you warn others. They
also let police know you have a problem. Your front and
rear turn signal lamps will flash on and off.
The hazard warning button
is located in the center of
the instrument panel,
between the two air vents.
Your hazard warning flashers work no matter what
position your key is in, and even if the key isn't in.
Press the button to make the front and rear turn signal
lamps flash on and off. The light in the center of the
button will flash, indicating that the hazard warning
flashers are on. Press the button again to turn the
flashers off.
When the hazard warning flashers are on, neither your
turn signals nor your Daytime Running Lamps (DRL)
will work.

6-9 Hood Release
To lift the hood, use the following steps:
1. Pull the lever inside the vehicle to open the hood.
It is located on the lower left side of the
instrument panel.
2. Then go to the front of the vehicle and find the
secondary hood release lever. The lever is located
under the front edge of the grille near the center.
Move the release lever to the side and raise the hood.
Before closing the hood, be sure all filler caps are on
properly. Then pull the hood down and close it firmly.

6-51 Cleaning the Top of the Instrument Panel
Use only mild soap and water to clean the top surfaces
of the instrument panel. Sprays containing silicones or
waxes may cause annoying reflections in the windshield
and even make it difficult to see through the windshield
under certain conditions.
Cleaning Interior Plastic Components
Use only a mild soap and water solution on a soft
cloth or sponge. Commercial cleaners may affect the
surface finish.
Cleaning Wood Panels
Use a clean cloth moistened in warm, soapy water (use
mild dish washing soap). Dry the wood immediately
with a clean cloth.
Cleaning Speaker Covers
Vacuum around a speaker cover gently, so that the
speaker won't be damaged. Clean spots with just water
and mild soap.
Care of Safety Belts
Keep belts clean and dry.
CAUTION:
Do not bleach or dye safety belts. If you do, it
may severely weaken them. In a crash, they
might not be able to provide adequate protection.
Clean safety belts only with mild soap and
lukewarm water.