instrument cluster CADILLAC CTS 2003 1.G Owners Manual

2-20
Theft-Deterrent System
The security light is located
on the instrument panel
cluster.
If the ignition is off and a door is open, the security light
will flash, reminding you to arm the theft
-deterrent
system.
To arm the system, do the following:
1. Open the door.
2. Lock the door using the remote keyless entry
transmitter or the power door lock switch. The
security light should come on and stay on.
3. Close all the doors. The security light should go off
within approximately 30 seconds.
If a door or a trunk is opened without a key or a remote
keyless entry transmitter, the horn will sound and the
lamps will flash for up to 30 seconds.The theft
-deterrent system won't arm if you lock the
doors with a key or use the manual door lock. It
activates only if you use the remote keyless entry
transmitter.
To avoid activating the alarm by accident do the
following:

The vehicle should be locked with the door key or
the manual door lock after the doors are closed if
you don't want to arm the theft
-deterrent system.

Always unlock a door with a key or use the remote
keyless entry transmitter. Pressing the unlock button
on the remote keyless entry transmitter disables the
theft
-deterrent system. Unlocking a door any other
way will activate the alarm when a door or the trunk
is opened.
If you activate the alarm by accident, unlock the driver's
door with your key. You can also turn off the alarm by
using the unlock button on the remote keyless entry
transmitter, or by starting the vehicle with a valid key.

2-35
Sport Mode Button
(Automatic Transmission Only)
This button allows you to change the driving mode of
the vehicle from the normal driving mode to a sportier
driving mode. In sport mode the vehicle will have firmer
shifting and increased performance.
The sport mode button is
located on the center
console near the
transmission shift lever.
Press the button once to turn on the sport mode.
Press the button again to return to normal driving mode.
This light located on the
instrument panel cluster
will come on when the sport
mode is active.
When you turn off the ignition while driving in sport
mode, the vehicle will remain in sport mode. Press the
sport mode button again to turn off the feature and
return to normal driving mode.

2-36
Winter Driving Mode Button
(Automatic Transmission Only)
This feature provides more traction during slippery
conditions by using THIRD (3) gear instead of
SECOND (2) when you begin to accelerate from a
stopped position.
The winter driving mode
button is located on the
center console near the
transmission shift lever.
Press this button once to turn on the winter driving
mode feature. Press it again to turn the feature off.
The winter driving mode feature works when the vehicle
is in any gear except SECOND (2).
This light on the instrument
panel cluster will come on
when the winter driving
mode is active.
When you turn off the ignition while using this feature,
winter mode is automatically turned off. The vehicle
will return to normal driving mode. You must reselect
the winter driving mode feature each time you restart the
vehicle if you wish to use the feature.
The transmission will be in THIRD (3) gear when the
vehicle begins to move. Once the vehicle is moving, the
vehicle will upshift normally.
The transmission will downshift when the accelerator
pedal is pressed and held for more than two seconds.
This feature is not intended for continuous use or for
use when the vehicle is stuck in sand, mud, ice, snow or
gravel. If your vehicle becomes stuck, see ªRocking
Your Vehicleº in the Index for more information on
how to free it.

2-39
To release the parking brake, pull the release lever
located to the left of the steering wheel on the
instrument panel.
If the ignition is on, the brake system warning light
on the instrument panel cluster should come on. If it
doesn't, you need to have your vehicle serviced. See
ªBrake System Warning Lightº in the Index for more
information.
NOTICE:
Do not drive your vehicle with the parking brake
on. Driving with the parking brake engaged can
cause your vehicle's rear brakes to overheat. You
may have to replace them, and you could also
damage other parts of your vehicle.
A warning chime will sound if the parking brake is set,
the ignition is on and the vehicle begins to move. To
stop the chime, fully release the parking brake.
If you are towing a trailer and parking on a hill, see
ªTowing a Trailerº in the Index for more information.

2-46
Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:

Turn and Lane
-Change Signals

Headlamps

Headlamp High/Low Beam
-Changer

Flash
-To-Pass Feature

Fog Lamps
For more information on the exterior lamps, see
ªExterior Lampsº later in this section.
Turn and Lane-Change Signals
To signal a turn, move the lever all the way up or down.
The lever returns automatically when the turn is
complete.
Arrows on the instrument
panel cluster flash in the
direction of the turn or
lane change.
Raise or lower the lever until the arrow starts to flash to
signal a lane change. Hold it there until the lane change
is complete. The lever returns to its original position
when it's released.
Arrows that flash rapidly when signaling for a turn or
lane change may be caused by a burned
-out signal bulb.
Other driver's won't see the signal.
Replace burned
-out bulbs to help avoid possible
accidents. Check the fuse and for burned
-out bulbs if the
arrow fails to work when signaling a turn. See ªFuses
and Circuit Breakersº in the Index for more information.

2-48
Headlamp High/Low-Beam Changer
Push forward on the turn signal/multifunction lever to
change the headlamps from low to high beam. Pull the
lever back and then release it to change from high to
low beam.
This light on the instrument
panel cluster will be on,
indicating high
-beam usage.
Lamps On Reminder
A warning chime will sound if the exterior lamp control
is left on in either the headlamp or parking lamp
position and the driver's door is opened with the
ignition off.
Flash-To-Pass Feature
This feature allows you to use the high-beam headlamps
to signal the driver in front of you that you want to pass.
Pull and hold the turn signal/multifunction lever toward
you to use. When you do, the following will occur:

If the headlamps are either off, in low
-beam or in
Daytime Running Lamps (DRL) mode, the
high
-beam headlamps will turn on. They'll stay on
as long as you hold the lever there. Release the lever
to turn them off.

If the headlamps are in high
-beam mode, they will
switch to low beam. To return to high
-beam, push
the lever away from you.

2-54
Setting Cruise Control
CAUTION:
If you leave your cruise control switch on when
you're not using cruise, you might hit a button
and go into cruise when you don't want to. You
could be startled and even lose control. Keep the
cruise control switch off until you want to use
cruise control.
1. Press the cruise control on/off button to turn cruise
control on. An indicator light will come on to show
that the cruise control is on.
2. Accelerate to the speed you want.
3. Press either the plus or minus button and release it.
This will set the cruise control.
4. Remove your foot from the accelerator pedal.
This light on the instrument
panel cluster will come on
when cruise control is on.
It will go out when cruise
control is turned off.
Resuming a Set Speed
Suppose you set your cruise control at a desired speed
and then you apply the brake. This shuts off the cruise
control. But you don't need to reset it.
Once the vehicle is traveling approximately 25 mph
(40 km/h) or more, you can press the resume/accelerate
button to return to your desired preset speed. The cruise
control light will be displayed again.
The vehicle will return to and stay at your preset speed.
If you press and hold the resume/accelerate button, the
vehicle speed will increase until you release the button
or apply the brake. Unless you want to go faster, do not
press and hold the resume/accelerate button.

2-81
The main components of the instrument panel are the following:
A. Air Outlets
B. Turn Signal/Multifunction Lever
C. Reconfigurable Steering Wheel Controls
D. Instrument Panel Cluster
E. Cruise Control Buttons
F. Audio Mute Button (Base Radio) or Voice
Recognition Button (Navigation System)
G. Audio Volume Knob and Source Button
H. Windshield Wiper LeverI. Storage Compartment or Ashtray (Option)
J. Hazard Warning Flasher Button
K. Transmission Shift Lever
L. Accessory Power Outlet or Cigarette
Lighter (Option)
M. Climate Control System
N. Audio/Navigation System (Option)
O. Glove Box

2-82
Instrument Panel Cluster
The instrument panel cluster is designed to let you know at a glance how your vehicle is running. You'll know how
fast you're going, how much fuel you're using and many of the other things you'll need to know to drive safely
and economically.
United States version shown, Canada similar

2-84
Tachometer
This gage indicates the
engine speed in revolutions
per minute (rpm).
NOTICE:
Do not operate the engine with the tachometer in
the shaded area or engine damage may occur.
Engine Speed Limiter
This feature prevents the engine from operating at too
many revolutions per minute (rpm). When the engine's
rpm are too high, the fuel supply to the engine will be
limited. When the rpms return to normal, the fuel supply
will return to normal. This helps prevent damage to
the engine.
Clock
Your vehicle has an analog clock on the instrument
panel cluster. For more information on setting the time,
see ªSetting the Clockº in the Index. If your vehicle
has the optional Navigation/audio system, see
ªAdjusting, Clockº in the Index of the CTS
Entertainment and Navigation System Supplement
supplied with the vehicle.