lumbar support CADILLAC DEVILLE 1999 7.G Owners Manual
[x] Cancel search | Manufacturer: CADILLAC, Model Year: 1999, Model line: DEVILLE, Model: CADILLAC DEVILLE 1999 7.GPages: 368, PDF Size: 2.61 MB
Page 8 of 368
yellowblue
1-2
Seats and Seat Controls
This section tells you about the power seats -- how to
adjust them, and also about the reclining front seatbacks,
memory seats, lumbar adjustments, heated seats and
head restraints.
Power Seats
The power seat controls, located on the front doors,
move and adjust the angle of the front seats.
Move the seat cushion control forward or rearward
to move the entire seat.Moving the seat cushion control up or down adjusts
the seat height.
Lifting up or pressing down on the front part of the
seat control adjusts the front angle of the seat cushion.
Lifting up or pressing down on the rear part of the
seat control adjusts the rear angle of the seat cushion.
Power Lumbar Control (If Equipped)
The LUMBAR control is
located on the outboard side
of each front seat. It
provides additional support
to your lower back and it
works independently of the
other seat controls. Use the
power seat control first to
get the proper position.
Then proceed with the
lumbar adjustment.
To reshape the lower seatback, move the LUMBAR
switch forward to increase support and rearward to
decrease support. Move the LUMBAR switch side to
side to raise or lower the support mechanism to suit
your preference.
Page 9 of 368
yellowblue
1-3
Keep in mind that as your seating position changes, as it
may during long trips, so should the position of your
lumbar support. Adjust the seat as needed.
If you have the optional personalization package, the
power lumbar control can be programmed for memory
recall. For more information, see ªMemory and
Personalization Featuresº in the Index.
Massaging Lumbar (If Equipped)
Push the lumbar control, located on the outboard side of
each front seat, up for half a second to activate the
massage feature. The massage cycle will run
continuously for 10 minutes and can be interrupted by
pushing the lumbar control down briefly. The lumbar
support can be adjusted during the massage cycle by
moving the switch forward to increase support and
rearward to decrease support. The massage cycle will
continue to run even if the ignition is turned to OFF,
unless interrupted.
Memory Seat and Mirrors (If Equipped)
Automatic seat and mirror movement will occur if the
Remote Keyless Entry (RKE) transmitter is used to
enter the vehicle. The number on the back of the
transmitter corresponds to the 1 or 2 seat and
mirror position.
After the unlock button is pressed on the RKE
transmitter (the ignition must be in LOCK) or when the
key is placed in the ignition, the seat and mirrors will
automatically adjust to the appropriate position.
Automatic seat and mirror movement is programmed
through the Driver Information Center (DIC) so that the
driver can select whether or not movement will occur
using the RKE transmitter or by placing the ignition key
in the ignition. For programming information, see
ªMemory and Personalization Featuresº in the Index.