lumbar support CADILLAC DEVILLE 2001 8.G Owners Manual
[x] Cancel search | Manufacturer: CADILLAC, Model Year: 2001, Model line: DEVILLE, Model: CADILLAC DEVILLE 2001 8.GPages: 397, PDF Size: 3.02 MB
Page 14 of 397
1-2
Seats and Seat Controls
This section tells you about the power seats -- how to
adjust them, and also about the reclining front seatbacks,
memory seats, lumbar adjustments and heated seats.
Power Seats
The power seat controls
are located on the
outboard side of the
front seat cushions.
Move the front of the seat control up or down to
adjust the front portion of the cushion.
Move the rear of the seat control up or down to
adjust the rear portion of the cushion.
Lift up or push down on the center of the seat control
to move the entire seat up or down.
To move the seat forward or rearward, slide the seat
control forward or rearward.
Four Way Power Lumbar Control
(If Equipped)
If you have this feature, the
driver's and passenger's
seatback lumbar support
can be adjusted four ways
by moving a single switch
located on the outboard side
of the seat.
To increase or decrease support, hold the switch forward
or rearward. To move the lumbar up or down, hold the
switch up or down.
Keep in mind that as your seating position changes, as it
may during long trips, so should the position of your
lumbar support. Adjust the seat as needed.
Page 15 of 397
1-3 Massaging Lumbar (If Equipped)
Push the top of the lumbar
control located on the
outboard side of the seat
where it is marked AUTO
briefly to activate the
massage feature.
The massage cycle will run continuously for up to
10 minutes and can be interrupted by pushing the
lumbar control down briefly. The lumbar support can
be adjusted during the massage cycle by moving the
switch forward to increase support and rearward to
decrease support. The massage cycle will continue
to run even if the ignition is turned to OFF,
unless interrupted.
Four-Way Rear Power Lumbar
(If Equipped)
Four-way lumbar, without
the massage feature, is also
available for the outboard
rear seating positions.
To activate the rear lumbar feature, push forward on the
switch located on the rear door trim to increase support
or rearward to decrease support. The lumbar switch can
also be moved up and down to adjust the location of
the support.
Page 16 of 397
1-4 Adaptive Seat Control (Option)
The adaptive seat control is
located on the outboard side
of the driver's seat. Use the
power seat control first to
get the proper position.When the ignition is turned to ON, press the top of
the power lumbar control where it is marked AUTO to
activate the adaptive feature. The seatback and cushion
will inflate to adjust to the driver's body positioning in
four
-minute cycles.
To reshape the lower seatback, press the lumbar
control forward to increase support and rearward to
decrease support.
To turn off the adaptive seat feature, press the control
down. The seat will deflate when the adaptive seat
control or the ignition is turned off.